利用“神光-Ⅱ”激光装置多路光束叠加直接驱动下的冲击波平面性及稳定性

利用“神光-Ⅱ”的3路基频光输出及小透镜列阵束匀滑技术,通过优化设计和合理地选择光路组合,实现了多路叠加斜入射的驱动激光, 在靶材料中产生一个650~750μm范围内平面性良好的冲击波,有效地提高了“神光-Ⅱ”输出光束的利用率。同时,利用斜面靶进行的冲击稳定性实验表明,在靶面功率密度分别为3.26×1014及2.56×1014W/cm2时,冲击波至少在28.38~55.82和22.13~35.07μm的Al样品厚度内是稳定传播的。     

圆弧形面阵自适应波束形成快速计算方法

针对圆弧形面阵估计水下目标二维波达方向的问题,提出一种降维处理的自适应波束形成方法。利用圆弧形面阵模型简化阵列内插矩阵的计算,通过垂直和水平两阶段波束加权,降低自适应波束形成维数,从而实现快速估计声源二维波达方向的目的。仿真结果表明,所提改进方法的计算量较传统二维最小方差无失真波束形成方法降低约一个数量级,且在低快拍条件下具有更明显的噪声抑制优势。湖上实验数据处理结果验证,在复杂水声环境下,所提方法具有较好的目标分辨性能。     

Use of Extraction Disks for Trace Enrichment of Various Pesticides from River and Sea Water Samples

Abstract

C-18 Empore extraction disks were used for the isolation and trace enrichment of different groups of pesticides from river water and artificial sea water at concentration levels of 0.2, 5 and 20 μg/l [chlorotriazines, (atrazine and simazine), their dealkylated metabolites, (deethyl- and deisopropylatrazine), organophosphorus (parathion-ethyl), phenylurea (linuron), anilide (propanil), carbamate (aldicarb and carbofuran) and carbamate transformation products (aldicarb sulfoxide, aldicarb sulfone and 3-hydroxy-7-phenol carbofuran]. The extraction disks allowed high flow rates thus 51 samples could be processed within 2h. 30 min.

For most of the pesticides the recoveries, as determined by liquid chromatography with diode array detection (LC-DAD), varied from 74 up to 125% with coefficients of variations (CV) of 5-10%, whereas for the carbamate transformation products the recoveries were in the range of 30-35% having a CV of 17-21%. At spiking level of 0.2 μg/l the dealkylated triazine metabolites and the carbamate transformation products were not detected at all.     

Study on an optical system with coherent laser array source and phase optimization in turbulent atmosphere

Model of an optical system with coherent laser array source and the piston phase optimized by the stochastic parallel gradient descent algorithm is established. With this model, theory of beam propagation through the optical system in turbulent atmosphere is analyzed, and the analytical formulas of the beam average intensity along the propagation path are derived. Strehl ratio of the received beam induced by intensity disorderly distribution and power efficiency of the received beam are introduced to evaluate performance of the optical system. Under the H-V 5/7 atmospheric turbulent model, performance of an optical system with determinate parameters was calculated, and the influences of the propagation distance and the laser wavelength were numerically analyzed, respectively.     

Influence of aspect ratio and anisotropy distribution in ordered CoNi nanowire arrays

The size effects on magnetic properties of nanowires arrays were studied varying the nanowires diameter and maintaining the same periodicity among them, for two different nominal compositions of Co and Ni in the alloy form. The competition among magnetocrystalline and shape anisotropies changes drastically from smallest to biggest diameters altering the easy axis direction. In the case of 75% of Co in alloy, experimental values of the effective anisotropy constant (K_eff) vary from positive to negative depending on the diameter, which means a reversal of the easy axis direction. For 50% of Co the shape anisotropy dominates over the magnetocrystalline for all studied diameters.     

字符串匹配算法在DNA序列比对中的应用

高通量测序技术的飞速发展让生物信息领域迎来了大数据时代。新技术在提供海量生物遗传信息的同时,也给分析这些数据带来了新的挑战。DNA序列比对是信息分析流程中的关键步骤,为后续的变异检测提供序列比对信息。2015“深圳杯”数学建模夏令营B题以DNA序列比对为研究课题,希望参赛学生给出序列快速比对的最佳方案。本文简要点评了各参赛队伍的解答情况,然后介绍了现有DNA序列比对软件中用到的算法和数据结构。     

Rapid quantitative analysis of individual anthocyanin content based on high‐performance liquid chromatography with diode array detection with the pH differential method

A new quantitative technique for the simultaneous quantification of the individual anthocyanins based on the pH differential method and high‐performance liquid chromatography with diode array detection is proposed in this paper. The six individual anthocyanins (cyanidin 3‐glucoside, cyanidin 3‐rutinoside, petunidin 3‐glucoside, petunidin 3‐rutinoside, and malvidin 3‐rutinoside) from mulberry (Morus rubra) and Liriope platyphylla were used for demonstration and validation. The elution of anthocyanins was performed using a C₁₈ column with stepwise gradient elution and individual anthocyanins were identified by high‐performance liquid chromatography with tandem mass spectrometry. Based on the pH differential method, the high‐performance liquid chromatography peak areas of maximum and reference absorption wavelengths of anthocyanin extracts were conducted to quantify individual anthocyanins. The calibration curves for these anthocyanins were linear within the range of 10–5500 mg/L. The correlation coefficients (r²) all exceeded 0.9972, and the limits of detection were in the range of 1–4 mg/L at a signal‐to‐noise ratio ≥5 for these anthocyanins. The proposed quantitative analysis was reproducible with good accuracy of all individual anthocyanins ranging from 96.3 to 104.2% and relative recoveries were in the range 98.4–103.2%. The proposed technique is performed without anthocyanin standards and is a simple, rapid, accurate, and economical method to determine individual anthocyanin contents.     

Effect of hybrid fillers on the mechanical behavior of polypropylene based hybrid composites

The present study investigates the effect of hybrid fillers such as graphene nanoplatelets (GnPs) and Titanium di-oxide (TiO₂) in polypropylene (PP) composites on the mechanical properties. The compatibilizing agent of Maleic anhydride grafted polypropylene (MAPP) are used in the polypropylene based composites to increase the interfacial adhesion between matrix and fillers. The experiments are designed according to L₁₆ orthogonal array (OA) based design of experiments (DOE). The parameters selected for this study are GnPs, TiO₂ and MAPP with four different levels are used.By using Orthogonal array and Taguchi based experimental design, the performance characteristics of tensile modulus, tensile strength, elongation at break and toughness can be analyzed with more objective through a small set of experiments.Taguchi based analysis are used to find out the optimal parameters to maximize the tensile properties for the GnPs and TiO₂ reinforced PP hybrid composites. Further, analysis of variance (ANOVA) is investigated to identify the most significant parameters which influence the mechanical properties.From the analysis it was found that the optimal parameters of 3 ?wt% GnPs, 2 ?wt% TiO₂ and 6 ?wt% MAPP for maximum tensile modulus and tensile strength. The most significant parameter for tensile modulus and tensile strength is GnPs followed by TiO₂ and MAPP according to ANOVA analysis.     

相控阵雷达导引头便携测试方法及误差角波动机理分析

相控阵雷达导引头组成复杂、测试指标多、数据量大,通常需要在符合远场条件的微波暗室内测试。本文介绍了一种相控阵雷达导引头便携测试方法及测试系统的组成,分析了便携测试机理、便携屏蔽装置设计原理,解释了该便携测试系统中相控阵雷达导引头角跟踪参数测试时偶尔引起的误差角波动现象。该测试方法简便、快捷、实用、成本低,较好的解决了外场或环境试验中产品测试的需求。本文所述相控阵雷达导引头便携测试方法和相关分析结论有较高的实用价值。     

Enzymatic Fabrication of High‐Density RNA Arrays

A powerful new strategy for the fabrication of high‐density RNA arrays is described. A high‐density DNA array is fabricated by standard photolithographic methods, the surface‐bound DNA molecules are enzymatically copied into their RNA complements from a surface‐bound RNA primer, and the DNA templates are enzymatically destroyed, leaving behind the desired RNA array. The strategy is compatible with 2′‐fluoro‐modified (2′F) ribonucleoside triphosphates (rNTPs), which may be included in the polymerase extension reaction to impart nuclease resistance and other desirable characteristics to the synthesized RNAs. The use and fidelity of the arrays are explored with DNA hybridization, DNAzyme cleavage, and nuclease digestion experiments.