Differential FBG sensor for temperature-compensated high-pressure (or displacement) measurement

A differential fiber Bragg grating (FBG) sensor with a free active element bulk-modulus for high-pressure (or displacement) measurement is presented. Based on the differential measurement method and an isosceles triangle cantilever structure, problems of cross-sensitivity and chirped signal in FBG sensor are improved both theoretically and experimentally. Preliminary experiments indicate that temperature-compensated measurement results agree well with the theoretical analysis. Displacement measurement sensitivity is 1.75 pm/μm, and the estimated pressure measurement resolution can reach 0.27 MPa in case the wavelength shift measurement resolution is 0.01 nm.     

Une méthode de calcul des coefficients de réflexion et de transmission d'une houle bidimensionnelle en milieu confinéA new method for the calculation of transmission and reflection coefficients for water waves in a small basin

This paper presents a method to estimate reflected and transmitted wave amplitude spectra in a bounded domain such as a wave tank, when available data signals must be shortened due to interferences and wall effects. This paper extends the well known Goda and Suzuki two-probe method to three probes. The paper also suggests solutions to compute reliable transmission and reflection coefficients in spite of problems linked to higher harmonics and to the interference between different wave trains propagating in the tank. To cite this article: G. Duclos, A.H. Clément, C. R. Mecanique 331 (2003).     

一种新颖的超结构光纤Bragg光栅梳状滤波器的设计

报道一种新颖的用于多波长光纤激光器的超结构光纤Bragg光栅（SFBG）梳状滤波器，其突出特点是仅由单个光栅构成、折射率调制和局部啁啾富于变化、反射峰均匀性好、窄带宽和标准的信道间隔.采用基于LP算法的IS光纤光栅设计技术，将整体加窗切趾法改进为各信道独立加窗切趾，成功地设计出所需的SFBG，同时对SFBG的制作技术也进行了探讨.用传输矩阵法分析反射谱、时延曲线和群时延抖动.结果表明，所设计的SFBG满足各项设计指标要求，在DWDM系统中，这种新颖的SFBG可望成为用于多波长光纤激光器的最理想的高性 能梳 关键词： 超结构光纤Bragg光栅 光栅设计 梳状滤波器     

Relative intensity noise of mode-locked fiber grating external cavity semiconductor lasers

The noise of hybrid soliton pulse source (HSPS) with linearly chirped Gaussian apodized fiber Bragg grating is analyzed by couple-mode equations including spontaneous emission noise when the HSPS is mode-locked. Relative intensity noise is calculated using numerical solutions of these equations. It is shown that transform limited pulses are generated over a wide tuning range around the fundamental mode-locking frequency with low spontaneous noise. However, a high noise level affects the operation of device, and therefore transform-limited pulses are not obtainable over a wide tuning range. It is also shown that noise is extremely sensitive to the RF and DC currents, linewidth enhancement factor, gain saturation parameter and spontaneous coupling factor.     

应用波分复用改善像束传像系统像质的研究

本文通过分析空间波分复用系统中包散元件的色散平均效应,用线扩散传递函数研究了像束传像性质,由光学成像的本征理论用像束成像信息量分析了波分复用改善像束传像像质的机制,并从实验上验证了上述分析结论.     

激光相干阵列探测中的二元全息光栅

从外差阵列探测出发，围绕木振光束整形问题，就计算全息位相光栅在激光相干雷达系统中的应用进行了理论及实施方面的研究，得出较好的结果。     

聚合物分散液晶光栅的衍射特性的研究

报道了一种由聚合物分散液晶膜与具有周期性条状电极结构板结合的新型光栅器件，借助于聚合物分散液晶膜的电光特性，这种栅对入射光的散射或衍射取决于对其施加的电压，即它是电场可调的，实验结果显示出当驱动电压超过器件器件阈值电压时，衍射光的强度和衍射斑的可见级次被电场调制，而且它能入射光的线性偏振态变为椭圆偏振态。     

Structure induced by irradiation of femtosecond laser pulse in dyed polymeric materials

We investigated the structures induced by an irradiation of a near‐infrared (NIR) femtosecond laser pulse in dye‐doped polymeric materials {poly(methyl methacrylate) (PMMA), thermoplastic epoxy resin (Epoxy), and a block copolymer of methyl methacrylate and ethyl acrylate‐butyl acrylate [p(MMA/EA‐BA) block copolymer]}. Dyes used were classified into two types—type 1 with absorption at 400 nm and type 2 with no absorption at 400 nm. The 400‐nm wavelength corresponds to the two‐photon absorption region by the irradiated NIR laser pulse at 800 nm. Type 1 dye‐doped PMMA and p(MMA/EA‐BA) block copolymer showed a peculiar dye additive effect for the structures induced by the line irradiation of a NIR femtosecond laser pulse. On the contrary, dye‐doped Epoxy did not exhibit a dye additive effect. The different results among PMMA, p(MMA/EA‐BA) block copolymer, and Epoxy matrix polymers are supposed to be related to the difference of electron‐acceptor properties. The mechanism of this type 1 dye‐additive‐effect phenomenon for PMMA and p(MMA/EA‐BA) block copolymer is discussed on the basis of two‐photon absorption of type 1 dye at 400 nm by the irradiation of a femtosecond laser pulse with 800 nm wavelength and the dissipation of the absorbed energy to the polymer matrix among various transition processes. Dyes with a low‐fluorescence quantum yield favored the formation of thicker grating structures. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 2800–2806, 2002     

Fabricating blazing grating on NGD by photochemical etching

This paper tries to introduce the reader to the method of using photochemical re-action to copy holographic optical elements(HOEs)in relief.The holographic blazing gratingso copied is groove depth adjustable phase modulability enlarged through copying and 3.3times the diffraction efficiency(DE)of the original grating.It is expected that the newmethod will lead to the mass production of the light-weight HOEs at low cost.     

倾斜Bragg光纤光栅反射谱特性理论和实验研究

光纤Bragg光栅在通信和传感领域有着广泛的应用。根据倾斜光纤Bragg光栅的结构特点，利用耦合模原理，运用传输矩阵法，模拟分析了倾斜角度对光纤Bragg光栅反射特性的影响，并用实验对模拟结果进行了验证。实验和模拟结果表明：随着倾斜角的增大，中心反射波长向长波方向移动，反射带宽变窄，反射率减小。这个结论对倾斜Bragg光纤光栅的生产和应用有一定的指导作用。