Rotational bands in 181Ta

High-spin states in ¹⁸¹Ta have been studied via the ¹⁷⁶Yb(¹¹B,α2n) reaction at 52 MeV using the PEX array and at 57 MeV using the NORDBALL array, with α-particle detection. The previously known, K^π=(7/2)⁺ ground state band and K^π=(9/2)⁻ band have been extended to spins (29/2)⁺ and (31/2)⁻, respectively. Two new one-quasiparticle bands, the K^π=(5/2)⁺ band built on the known (5/2)⁺ isomer and a K^π=((1/2)⁻) band have been observed. Two other rotational bands with three-quasiparticle structure, K^π=(15/2)⁻ and ((19/2)⁺ with π(7/2)[404]ν²(1/2)[510](9/2)[624] and π(9/2)[514]ν²(1/2)[510](9/2)[624] configurations, respectively, have been newly observed. The half-life of the K^π=((19/2)⁺) bandhead which decays to the head of the (15/2)⁻ band has been measured to be 140(36) ns. However, transitions from the ((19/2)⁺) state to the (15/2)⁻ band have not been observed. Received: 26 August 1998     

Rheological behaviour and shear thickening exhibited by aqueous CTAB micellar solutions

In this experimental work we carefully investigate the rheological behaviour and in particular the shear thickening exhibited by aqueous micellar solutions of CTAB with NaSal as added counterion. We are particularly interested in the evolution of the critical shear rate (at which shear thickening occurs) versus C _D , the surfactant concentration. We show that , at fixed salt concentration C _S , increases with C _D following a power law evolution with a positive exponent of + 5.8. On the other hand we show that if the ratio C _D / C _S is fixed, decreases with C _D with a negative exponent of -2.0. Nevertheless investigations of the zero shear viscosity indicate that in all situations (implying variation of the surfactant concentration C _D , or the salt concentration C _S or the temperature) is a decreasing function of the length of the micelles. All these evolutions are compatible with a gelation mechanism which could possibly be associated with entanglement effects of large interacting flowing structures. Received: 3 March 1998 / Revised: 16 June 1998 / Accepted: 3 July 1998     

Evolution of shapes in 59Cu

High-spin states in ⁵⁹Cu were populated using the fusion-evaporation reaction ²⁸Si + ⁴⁰Ca at a beam energy of 122 MeV. The Gammasphere Ge-detector array in conjunction with the 4π charged-particle detector array Microball allowed for the detection of γ-rays in coincidence with evaporated light particles. The resulting extensive high-spin decay scheme of ⁵⁹Cu is presented, which comprises more than 320 γ-ray transitions connecting about 150 excited states. Their spins and parities have been assigned via directional correlations of γ-rays emitted from oriented states. Average quadrupole moments of rotational bands have been determined from the analysis of residual Doppler shifts. Shell model calculations in the fp shell are invoked to study some of the low-spin states, while the experimental characteristics of the rotational bands are analyzed in the configuration-dependent cranked Nilsson-Strutinsky (CNS) approach. Received: 15 February 2002 / Accepted: 23 April 2002     

Guaranteed-accuracy approximation of reachable sets for a linear dynamic system subject to impulse actions

A method is proposed for approximating the reachable set of a dynamic system with a state space dimension no higher than six-eight considered on a finite time interval. The system is governed by linear differential equations with piecewise constant coefficients and impulse actions specified at prescribed times. The method is based on guaranteed-accuracy polyhedral approximations of reachable sets at researcher-specified times. Every approximation is constructed using the preceding one. A procedure is described for choosing parameters of the method that ensure the required accuracy with close-to-minimal time costs.     

Characterization of semiconductor laser frequency chirp based on signal distortion in dispersive optical fiber

In the paper, the simple method of laser chirp parameters estimation is presented. It is based on measuring time-domain distortions of chirped signal transmitted through dispersive fiber and finding laser chirp parameters by matching measured distortions to calculated ones. Experiments undertaken with 1.55 μm telecommunication grade distributed feedback (DFB) lasers and standard single-mode fiber are described, together with some practical remarks on measurement setup and main conclusions.     

XPS, electric and photoluminescence-based analysis of the GaAs (1 0 0) nitridation

In this paper, nitridation process of GaAs (1 0 0) substrates was studied in-situ using X-ray photoelectron spectroscopy (XPS) and ex-situ by means of electrical method I-V and photoluminescence surface state spectroscopy (PLS³) in order to determine chemical, electrical and electronic properties of the elaborated GaN/GaAs interfaces.The elaborated structures were characterised by I-V analysis. The saturation current I_S, the ideality factor n, the barrier height Φ_Bn and the serial resistance R_S are determined.The elaborated GaN/GaAs structures are also exhibited a high PL intensity at room temperature. From the computer-aided analysis of the power-dependent PL efficiency measurements (PLS³ technique), the value of the interface state density N_SS(E) close to the mid-gap was estimated to be in the range of 2-4 × 10¹¹ eV⁻¹ cm⁻², indicating a good electronic quality of the obtained interfaces.Correlation among chemical, electronic and electrical properties of the GaN/GaAs interface was discussed.     

Reliable evaluation of temperature-independent parameters in correlation of vapour–liquid equilibrium data

A new algorithm/program has been elaborated for simultaneous processing of different sets of vapour–liquid equilibrium data. The program was tested with six binary hexane + isomeric pentanol systems, each of them measured at three different isobaric conditions and one isothermal system of tert-butyl-methyl-ether + 2-methyl-2-propanol measured at three different temperatures. The correlation uses the maximum likelihood method, taking into account real behaviour of vapour phase. The parameters obtained are valid within the whole temperature range of the data, and are consistent in comparison with those obtained from individual correlations of isobars or isotherms. Results are presented for the Wilson and NRTL equations.     

Sub-zero temperature behavior of water in non-ionic microemulsions

Sub-zero temperature DSC measurements were conducted to evaluate the behavior of water in non-ionic microemulsions. Two surfactant systems were studied. The first, based on ethoxylated fatty alcohol, octaethylene glycol monon-dodecylether [hereafter referred to as C₁₂(EO)₈] and also containing water, pentanol and dodecane at a fixed weight ratio of 1:1. The second system, based on oligomeric ethoxylated siloxanes, water and dodecanol as oil phase. In both systems it was found that in up to 30 wt.% of the total water content, all water molecules solubilize in the amphiphilic phase and are bound to the ethylene oxide (hereafter referred to as EO) head-groups. No free water exists in the surfactant aggregates’ core. Up to three molecules of water are bound to each EO group. In the first system, the behavior changes significantly upon adding more water. The added pentanol allows further swelling and the water penetrates into the amphiphile structures and forms a reservoir of free water. Structures are deformed and grow from elongated channels (up to 15–20 wt.% water), via illdefined (one-dimensional growth) local lamellar structures (up to ca. 60 wt.% water) to spherical normal, O/W micelles (at ≥85 wt.% water). In contrast, the oligomeric systems, due to geometrical restrictions of the amphiphiles and the nature of their curvature that prevents inversion, cannot further solubilize water in the surfactant aggregates’ core, causing phase separation to occur. Part of the results presented in this paper were included in S. E.’s doctoral thesis in Applied Chemistry at The Hebrew University of Jerusalem, Israel.     

Study of migration of active components of phosphorescent oxygen sensors for food packaging applications

A study of migration of the active components of oxygen sensors into food is presented. Six types of sensors, based on different oxygen sensitive dyes (two metalloporphyrins and one ruthenium dye), polymers (polystyrene and polysulfone) and support materials, were exposed to a number of standard ‘food simulants’ recommended by FDA/EU guidelines and then assayed for migration or sensor components and changes in oxygen calibration. Both metalloporphyrin sensor dyes leached only in olive oil and in 95% ethanol (used as a positive control), at maximum levels of 19.22 μg/dm² for PtOEPK and 113.96 μg/dm² for PtTFPP. The RuDPP dye showed maximum leaching in 95% ethanol (25.19 μg/dm²) while also migrating in an acidic aqueous simulant. Planar supports such as polyester tended to enhance the stability of the sensor. Migration of the styrene monomer from the polystyrene encapsulation medium was concluded to be low enough to be insignificant. Migration of sensor components was shown to correlate with the changes in sensor response to oxygen. Based on these results, sensor combinations were ranked on the basis of their resistance to leaching and their general stability, safety and suitability for use on a large scale in packaged foods and related food applications was proven.     

Thermal and structure analysis of FeSO4·H2O-BaO2 mixtures

Investigations on the thermal decomposition of FeSO₄·H₂O-BaO₂ mixtures were carried out under isothermal conditions by using simultaneously solid electrolyte cell (EMF-method). Evoked interactions producing oxygen in the temperature range 553-673 K were established by means of a solid electrolyte oxygen analyzer. Based on Mössbauer spectroscopy data and X-ray analysis it was proved that these reactions were associated with the release of oxygen from barium peroxide, oxidation of ferrosulphate-monohydrate to FeOHSO₄, and formation of barium ferrites such as BaFe₂O₄ and BaFe₁₂O₁₉.