Time-resolved fluorescence spectra of a bichromophoric molecule, 2-methyl-1,2,3,4-tetrahydroisoquinoline in various media

Time-resolved fluorescence spectra of a title molecule (with benzene and aliphatic amine parts) in various media, after excitation by several lasers were observed to complement the previous work by conventional spectroscopy [N. Kanamaru, J. Tanaka, J. Phys. Chem. 95 (1991) 6441]. Though complex with many new features, the results were roughly consistent with the previous ones. The significant conclusions are as follows: (1) The emission to be ascribed to the amine (N) part, with more than one component (of nN and aN types) is observed not only for the acetonitrile solution (as previously reported) but also for all the other media. (2) Contrary to the case of a nonpolar hexane solution, both of N fluorescences in the other media reveal unusually long-lived decay components. This can be interpreted by assuming the so-called charge-transfer-to-solvent (CTTS) state that is nonfluorescent and lies just below the fluorescent state. (3) This observation in the protic media can also be taken as another evidence of the peculiar hydrogen bonding between this amine and the protic solvent molecules [N. Kanamaru, J. Tanaka, J. Phys. Chem. 95 (1991) 6441]. (4) Thus, the unexpectedly large quantum yields of N fluorescences in the polar media are now interpreted as arising due to the slow S₁^N→(CTTS)→S₀ internal conversions.     

Monitoring the Aggregation of Dansyl Chloride in Acetone through Fluorescence Measurements

The aggregation of dansyl chloride (DNS-Cl) in acetone has been studied in detail by steady-state fluorescence techniques.It has been demonstrated that DNS-Cl is stable in acetone during purification and aggregation study processes.The aggregates are not solvolyzed in acetone,and do not take part n any chemical reactions either.It has been found that DNS-Cl tends to aggregate even when its concentration is much lower than its solubility in acetone.The aggregation is reversible,and both the aggregation and the deaggregation are very slow processes.Introduction of SDS has a positive effect upon the formation and stabilization of the aggregates.     

双面金属包覆介质波导模序数的判别方法

在双面金属包覆介质波导中 ,随着介质层厚度的变化 ,会出现TM0 模与TM1 模的分离和简并两种状态 ,从而影响衰减全反射 (ATR)谱中模序数的确认。通过对金属波导的理论分析和实验研究 ,提出了三种模序数确认方法 :本征角计算法、吸收峰全峰半宽比较法和吸收峰峰间距比较法 ,实现了两种状态下对模序数的准确判断     

一类新的表面活性剂——长链烷基三苯基鏻——Ⅵ.稳态荧光猝灭法测定十二烷基三苯基溴化鏻胶束的平均簇集数

研究了十二烷基三苯基溴化鏻(C_(12)PBr)胶束中N,N-二甲基苯胺(DMA)和二苯甲酮(DPK)对芘的荧光猝灭,发现DMA的猝灭行为不符合Stern-Volmer动态猝灭和Turro静态猝灭模型;DPK的猝灭行为不符合Stern-Volmer猝灭模型,但遵从Turro静态猝灭模型。根据DPK的静态猝灭性质测得C_(12)PBr胶束的平均簇集数为15士2,并相应地得到C_(12)PBr的临界胶束浓度为(1.77±0.09)×10~(-3)mol/L,后者与文献值一致。     

Laser vaporization: A versatile method for studying metal clusters

Vaporizing solid samples of metals and semiconductors with a YAG Laser is a method well suited for producing molecules and clusters of those materials. The clusters are examined by either laser-induced fluorescence (LIF) or mass spectroscopic methods. The technique is valuable for both gas phase and matrix studies. The method is described and some applications, studying either the structure of small metal molecules or their reactions, are reviewed, with emphasis on our recent results from the LIF studies of LiBe, Al₂ and the reaction of Al with oxygen, yielding A1₂O. For larger clusters, Ion Cyclotron Resonance is an extremely valuable method, as we demonstrate by its application to the reactions of small charged silicon clusters with strong oxidising agents.     

总延误问题顺时安排法的性能比

给定一组工件的加工时间与工期，要求确定这些工件在一台机器上的加．工排列，使相应的总延误达到最小，这就是总延误问题．该问题在近年已被证明是NP困难的．由Wilkermn和Irwin（1971），林勋（1983）等所研究的顺时安排法能得到相邻交换意义下的局部解．在本文中，我们进一步证明该算法能得到前移邻域意义下的局部解，并确定了该算法的性能比．     

Study of photon-induced L3 vacancy alignment for elements La to U

Alignment of photon-induced L₃ vacancies is studied in rare earth and highZ elements at energies of experimental interest, near thresholds to 60 keV, under nonrelativistic dipole approximation. Numerical calculations of the matrix element are undertaken to produce theoretical data for comparison with the experimental findings. The A₂ values being s>0.1 at photoelectron energies <20 keV are certainly higher than 5–8% uncertainties quoted in experimental results. Present findings are from a very basic model, hydrogen-like and can further be treated as reference to observe the impact of screening, relativistic, multipole and retardation corrections to the model     

K2O-ZnO-Al2O3-B2O3-SiO2系掺Cr3+透明莫来石微晶玻璃的研究

采用了X射线衍射、透射电镜和吸收光谱及荧光光谱技术研究了K2O－ZnO-Al2O3-B2O3－SiO2系掺Cr^3 玻璃的析晶性能和光谱。研究结果表明：在K2O－Al2O3-B2O3-SiO2系掺Cr^3 玻璃的基础上引入ZnO后，析晶性能明显改善；析晶温度降低，析出的纳米莫来石微晶均匀、规则；微晶玻璃的发光强度明显增强。     

Photoelastic stress freezing analysis of total shoulder replacement systems

Photoelastic stress freezing analyses in the orthopaedic literature have, in the past, been limited to studies where bone-on-bone, bone-on-metal or ultra-high molecular weight polyethylene (UHMWPE)-on-metal constructs are modeled. In these cases photoelastic plastics are used to simulate either bone or UHMWPE as it interacts with a metal implant. In joints such as the shoulder, a UHMWPE component is often cemented directly into the scapula's glenoid concavity using polymethylmethacrylate (PMMA). While a photoelastic material can be used to simulate bone with proper load scaling, UHMWPE and PMMA have very different mechanical properties at elevated stress freezing temperatures as compared within vivo body temperature. In this study, materials were identified such that proper scaling of elastic properties at elevated temperatures was utilized to simulate the metal-UHMWPE-PMMA-bone construct. Stresses on orthogonal planes throughout the glenoid were compared for two different UHMWPE component anchoring geometries (keeled and pegged). High stresses were found at the neck of the glenoid and also at the component-bone interface beneath simulated PMMA inclusions.     

Illuminating Molecular Processes in Living Cells

Lately, scientists have explored approaches to developing fluorescent and/or bioluminescent indicators to pinpoint cellular processes in single living cells. These analytical methods have become a key technology for visualizing and detecting what was otherwise unseen in live cells. The target signaling included second messengers, protein phosphorylations, protein–protein interactions, and protein localizations.