碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

MNDO study of reaction paths: Diboration of acetylene

The reaction of B₂H₄ with acetylene has been studied by the MNDO method. It is shown that the reaction is exothermic and proceeds in two steps. The first step is the formation of a three-center -complex and this is the rate-determining step of the reaction. The second step is the rearrangement of the -complex to the product and this step requires a very small amount of activation energy. The activation barrier for the diboration reaction is 12.8 kcal/mol.The proposed mechanism is significantly different from those proposed earlier and explains all experimental data relating to this reaction.     

Some Conversions of Thiazoline Carboxylic Acid Esters

We have carried out solvolysis of the previously described ethyl esters of 3-methyl(aryl)-4-methyl-2-thioxothiazoline-5-carboxylic acids, leading to the corresponding acids without breaking down the heterocycle. We synthesized a series of novel esters from the latter by treatment with dimethyl sulfate or reactive halides. Of these, only in the case of the ethyl ester of 3,4-dimethyl-2-thioxothiazoline-5-carboxylic acid did we obtain the hydrazinolysis product (the hydrazide), from which we synthesized novel hydrazones by treatment with aldehydes and ketones.     

Summary of ISO/TC 201 Standard XI. ISO 17974:2002—Surface chemical analysis—High‐resolution Auger electron spectrometers—Calibration of energy scales for elemental and chemical‐state analysis

This International Standard specifies a method for calibrating the kinetic energy scales of Auger electron spectrometers for elemental and chemical‐state analysis at surfaces. It is only applicable to instruments that incorporate an ion gun for sputter cleaning. This International Standard further specifies a method to establish a calibration schedule, to test for the kinetic energy scale linearity at one intermediate energy, to confirm the uncertainty of the scale calibration at one low and one high kinetic energy value, to correct for small drifts of that scale and to define the expanded uncertainty of the calibration of the kinetic energy scale for a confidence level of 95%. This uncertainty includes contributions for behaviours observed in interlaboratory studies but does not cover all of the defects that could occur. This International Standard is not applicable to instruments with kinetic energy scale errors that are significantly non‐linear with energy, to instruments operated at relative resolutions poorer than 0.2% in the constant ΔE/E mode or poorer than 1.5 eV in the constant ΔE mode, to instruments requiring tolerance limits of ±0.05 eV or less or to instruments equipped with an electron gun that cannot be operated in the energy range 5–10 keV. This standard does not provide a full calibration check, which would confirm the energy measured at each addressable point on the energy scale and should be performed according to the manufacturer's recommended procedures. Crown Copyright © 2003. Published by John Wiley & Sons, Ltd.     

Intermediates in the photochemical reaction for the formation of 2,7-dimethylacridine from ditolylamine and bromoform

The reaction of the photochemical synthesis of 2,7-dimethylacridine from di(para-tolyl)amine and bromoform was studied utilizing the method of microsecond impulse photolysis. The proposed new scheme for the formation of acridine assumes the recombination of the primary alkyl radicals at the nitrogen atom of the cation radical and/or the radical of the amine as the main route of the reaction. The data obtained indicate the common character of the nature of some intermediate stages and the structures of the intermediates in the photochemical formation of acridine compounds and triphenylmethane dyes from aromatic amines and halogenomethanes.Institute of Chemical Physics, Chernogolovka, Russian Academy of Sciences, 142432 Chernogolovka. Translated from Izvestiya Akademii Nauk, Seriya Khimicheskaya, No. 9, pp. 2044–2052, September, 1992.     

Photochemical properties and structures ofN-amino andN-azomethine derivatives of 2,4,6-triphenylpyridinium perchlorates

The molecular structures of the initial compounds and the products of photocyclization involving amino and azomethine groups in perchlorates ofN-amino (1) andN-azomethine (2) derivatives of 2,4,6-triphenylpyridinium cations were studied. Cations1 and2 have an essentially non-coplanar arrangement of the -Ph rings, and the product of photocyclization of2, cation3, is characterized by a flattened structure. It was found that the orientation of the lone electron pair of the N atom with respect to one of the planes of the -Ph rings in molecule1 is more favorable for monocyclization involving the amino group. The structure of molecule2 allows two routes of the photoreaction,viz., O N proton transfer and monocyclization with an -Ph ring. However, the structural features of molecule2 are more favorable for photocyclization.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 2, pp. 296–301, February, 1995.     

Obtaining Kinetic Parameters by Modulated Thermogravimetry

A new technique, called modulated thermogravimetry, is introduced as a tool for obtaining continuous kinetic information for decomposition and volatilization reactions. The approach makes use of an oscillatory temperature program to obtain kinetic parameters during a mass loss. MTGA™ may be used under quasi-isothermal conditions to observe a single mass loss or may be combined with linear heating rate or Hi-Res™ controlled rate thermogravimetry to scan from one mass loss region to another. Results obtained are in agreement with those obtained by other kinetic methods. This revised version was published online in July 2006 with corrections to the Cover Date.