负载型纳米TiO2复合载体及其CoMo催化剂的酸性及孔特性的研究

总结了复载不同纳米尺度的复合载体及其CoMo催化剂的表面酸性及孔结构特性的表征结果。结果表明，负载型纳米TiO2与基载体γ-Al2O3存在着相互作用。当负载比较少量的纳米TiO2时，复合载体的总酸量随着TiO2含量的增加而增加，超过γ-Al2O3的酸量，但当 TiO2的含量比较高时复合载体的酸量又降低，纳米TiO2优先负载在γ-Al2O3的强酸中心位；负载了CoMo活性组分后酸量增加。不同粒径的纳米TiO2对复合载体和催化剂的酸分布没有明显影响，但对总酸量有影响。对不同尺度TiO2，随着TiO2负载量的增加以及负载金属活性组分的增加，表面积、孔容和最可几孔径均有不同程度的减少。     

Fabrication, Characterization and Electrocatalysis of an Ordered Carbon Nanotube Electrode

A method for fabrication of ordered carbon nanotube (CNT) film,which was template-synthesized within the highly ordered pores of a commercially available alumina template membrane,modified glassy carbon(CNT/GC) electrode was established.The CNT/GC electrode showed excellent electrocatalytic activity toward dopamine electrochemical reaction without introducing any electrochemically active group into CNT film or activating any electrochemically active group into CNT film or activating the electrode electrochemically.DA undergoes ideal reversible electrochemical reaction on CNT/GC electrode at low scan rate(≤20mV/s) with an excellent reproducibility and stability.The CNT/GC electrode might be used in biosensors because the highly ordered CNT may present a steric effect on more efficient redox reactions of biomolecules.     

Tris(2,2′-bipyridyl)ruthenium(II) electrogenerated chemiluminescence sensor based on carbon nantube dispersed in sol-gel-derived titania-Nafion composite films

A highly sensitive and stable tris(2,2′-bipyridyl)ruthenium(II) (Ru(bpy)₃²⁺) electrogenerated chemiluminescence (ECL) sensor was developed based on carbon nanotube (CNT) dispersed in mesoporous composite films of sol-gel titania and perfluorosulfonated ionomer (Nafion). Single-wall (SWCNT) and multi-wall carbon nanotubes (MWCNT) can be easily dispersed in the titania-Nafion composite solution. The hydrophobic CNT in the titania-Nafion composite films coated on a glassy carbon electrode certainly increased the amount of Ru(bpy)₃²⁺ immobilized in the ECL sensor by adsorption of Ru(bpy)₃²⁺ onto CNT surface, the electrocatalytic activity towards the oxidation of hydrophobic analytes, and the electronic conductivity of the composite films. Therefore, the present ECL sensor based on the CNT-titania-Nafion showed improved ECL sensitivity for tripropylamine (TPA) compared to the ECL sensors based on both titania-Nafion composite films without CNT and pure Nafion films. The present Ru(bpy)₃²⁺ ECL sensor based on the MWCNT-titania--Nafion composite gave a linear response (R² = 0.999) for TPA concentration from 50 nM to 1.0 mM with a remarkable detection limit (S/N = 3) of 10 nM while the ECL sensors based on titania-Nafion composite without MWCNT, pure Nafion films, and MWCNT-Nafion composite gave a detection limit of 0.1 μM, 1 μM, and 50 nM, respectively. The present ECL sensor showed outstanding long-term stability (no signal loss for 4 months).     

Preparation of Titania from Tetrakis(diethylamino)titanium via Hydrolysis

The conversion of tetrakis(diethylamino)titanium (Ti(NEt₂)₄) into titania via either a combination of hydrolysis (Ti(NEt₂)₄ : THF : H₂O = 1 : 10 : x, x = 2, 4, 10) at ambient conditions and calcination (method A) or hydrolysis in a water-tetrahydrofuran (THF) mixture (Ti(NEt₂)₄ : THF : H₂O = 1 : 10 : 100) at reflux (method B) was investigated. Titanium tertiary butoxide (Ti(O ^t Bu)₄) was also used as a substitute for Ti(NEt₂)₄. The hydrolysis via method A resulted in the formation of amorphous solids containing organics. Thermal analyses showed that the hydrolysis products showed mass losses up to 500°C probably due to the presence of diethylamine (Et₂NH) formed via the hydrolysis of Ti(NEt₂)₄ in the hydrolysis products, while a mass loss of the hydrolysis product from Ti(O ^t Bu)₄ was completed up to about 200°C. After calcination at 600°C, anatase or a mixture of anatase and rutile was obtained. The crystallization behavior of the hydrolysis products from Ti(NEt₂)₄ was different from that of the hydrolysis product from Ti(O ^t Bu)₄. The hydrolysis via method B gave only an amorphous material from Ti(NEt₂)₄, while a crystalline titania (anatase and brookite) formed from Ti(O ^t Bu)₄.     

铁掺杂TiO2纳米管阵列对不锈钢的光生阴极保护

在含FeSO4的HF、H2SO4/HF、NaF/Na2SO4溶液中,通过电化学阳极氧化直接在纯钛表面制备Fe 掺杂的TiO2(Fe-TiO2)纳米管阵列. 应用X射线衍射(XRD)、扫描电子显微镜(SEM)、紫外-可见吸收光谱(UV-Vis)、X 射线光电子能谱(XPS)等手段对纳米管阵列的结构、形貌及化学组成进行表征. 利用光电化学测量研究Fe-TiO2纳米管阵列在不同波长范围内的光电响应特性和光生阴极保护行为. 考察了温度、时间、掺杂含量等参数对TiO2纳米管阵列的几何尺寸、形貌和光电性能的影响. 结果表明, Fe掺杂可有效减缓TiO2纳米管阵列载流子的复合, 窄化TiO2带隙宽度, Fe-TiO2在410-650 nm范围显示强吸收, 并使光谱响应扩展到波长大于400 nm 的可见光区. 实验结果还表明, Fe-TiO2纳米管阵列对316不锈钢(316L)具有良好的光生阴极保护作用, 暗态下阴极保护作用可继续维持.     

Effect of chemical potential on the computer simulation of hydrogen storage in single walled carbon nanotubes

Hydrogen is a kind of clean, sustainable and renewable energy carrier. Of the problems to be solved for the utilization of hydrogen energy, how to store and transport hydrogen has been given high priority on the research agenda. Recently, carbon nanotubes (CNTs) were reported to be very promising candidates for hydrogen uptake[1], which may have possibility to satisfy the benchmark set by the US Department of Energy (DOE) Hydrogen Plan for fuel cell powered vehicles: a gravimetric density …     

Temperature programmed desorption analysis of sol-gel-derived titania films

Sol-gel-derived titania films were analyzed by temperature programmed desorption (TPD) and X-ray diffraction (XRD) techniques. The relationship between the TPD curves measured for two types of titania gel films and their crystal structures was investigated. On the basis of the analyses, a preparation process for a titania sol solution containing anatase nanocrystals was designed and developed. Using this process, a colloidal anatase titania sol solution was prepared by heating aqueous titanium hydroxide containing HCl at 60°C for 2 h. The nanocrystal structure of the titania films obtained by coating the sol on glass substrates was confirmed by TPD and XRD measurements.     

锐钛相虫蛀状介孔二氧化钛的表征

0IntroductionMesostructuredtitania(TiO2)hasattractedagreatdealofattention,inviewofcontrolleddelivery,catalytic,photocatlytic,orenergyconversionapplica-tions犤1犦.Theuseoftitaniumisopropoxidebis-acetylace-tonateprecursors,combinedwithalkylphosphatean-ionicsurfactantsastemplate,ledtothefirstdocu-mentedpuremesoporousTiO2犤2犦.Insubsequentyears,moresyntheticstrategieshavebeendevelopedusingavarietyofstructure-directingagents,forexample,car-boxylicacids犤3犦,alkylamine犤4犦,aminium犤5犦,blockcop-o…     

Electrochemical Behavior and Determination of Uric Acid at Single-Walled Carbon Nanotube Modified Gold Electrodes

The voltammetric behavior of uric acid was studied at a single-walled carbon nanotube (SWNT) modified gold electrode. Uric acid can effectively accumulate at this electrode and produce an anodic peak at about 0.45 V (vs. SCE) in pH 5.0 sodium acetate buffer solutions (HAc-NaAc). The experimental parameters, such as solution pH, accumulation time, and amount of SWNT, were optimized for determination. Under the optimum conditions, the anodic peak current is linear to the uric acid concentration over the range of 1.0×10⁻⁷ M to 2.5×10⁻⁵ M with a correlation coefficient of 0.998. The detection limit was 5.0×10⁻⁸ M for 60 s accumulation. The electrode could be easily regenerated and exhibited good stability. A 5.0×10⁻⁶ M uric acid solution was measured ten times using the same electrode, and the relative standard deviation of the peak current was 1.3%. This method was successfully applied to the determination of uric acid in human urine samples, and the recovery was 97–99%. The feasibility for simultaneous determination of xanthine, ascorbic acid and uric acid was discussed. These species did not interfere with each other in a certain concentration range. The influence of some surfactants on the anodic peak was also examined.     

Formation of supported size-controlled nanoparticles of sulfated zirconia

Methods of the preparation of catalysts for alkane skeletal isomerization based on uniform nanoparticles of sulfated zirconia anchored to different supports were investigated. These catalysts were characterized by using the ICP, HRTEM and BET techniques. The activities of the catalysts in the reaction of n-butane isomerization were measured and compared with those of bulk catalysts.