一阶最优性条件研究

本对由Botsko的关于多变量函数取极值的一阶导数检验条件定理^[1]进行了分析研究，给出了更实用而简捷的差别条件。最后，举出若干例子予以说明。     

压力淬火过程中锗的相结构研究

 应用高压原位差热方法，直接测量了压力下锗的固化参数─—固化温度与过冷度。高压差热信号表明，当压力大于3 GPa时，锗在凝固过程中可能发生结构相变。X射线结构分析表明，在最终的样品中除GeⅠ相外，还形成GeⅢ相和GeⅣ相。     

二氧化钒薄膜的低温制备及其性能研究

针对VO₂薄膜在微测辐射热计上的应用，采用射频反应溅射法，在室温下制备氧化钒薄膜；研究了氧分压对薄膜沉积速率、电学性质及成分的影响.通过调节氧分压，先获得成分接近VO₂的非晶化薄膜，再在400℃空气中氧化退火，便可制得高电阻温度系数，低电阻率的VO₂薄膜，电阻温度系数约为-4%/℃，薄膜方块电阻为R_□为100—300kΩ；薄膜在室温下沉积，400℃下退火的制备方法与微机电加工(micro electromechanic 关键词： 二氧化钒 电阻温度系数 氧分压 射频反应溅射法     

Nonsensitiveness Regions for Threshold Ellipsoids

The problem is to determine nonsensitiveness regions for threshold ellipsoids within a regular mixed linear model.     

Numerical solutions of the shallow water equations with discontinuous bed topography

A simple scheme is developed for treatment of vertical bed topography in shallow water flows. The effect of the vertical step on flows is modelled with the shallow water equations including local energy loss terms. The bed elevation is denoted with z_b^‐ for the left and z_b⁺ for the right values at each grid point, hence exactly representing a discontinuity in the bed topography. The surface gradient method (SGM) is generalized to reconstruct water depths at cell interfaces involving a vertical step so that the fluxes at the cell interfaces can accurately be calculated with a Riemann solver. The scheme is verified by predicting a surge crossing a step, a tidal flow over a step and dam‐break flows on wet/dry beds. The results have shown good agreements compared with analytical solutions and available experimental data. The scheme is efficient, robust, and may be used for practical flow calculations. Copyright © 2002 John Wiley & Sons, Ltd.     

New universality classes in “Percolative” dynamics

We study a site analogue of directed percolation. Random trajectories are generated and their critical behavior is studied. The critical behavior corresponds to that of simple percolation in some of the parameter space, but elsewhere the exponents reveal new universality classes. As a byproduct, we use the model to make an improved estimate of the percolation hull exponents and to calculate the site percolation probability for the square lattice.     

A stochastic algorithm using one sample point per iteration and diminishing stepsizes

A stochastic algorithm for finding stationary points of real-valued functions defined on a Euclidean space is analyzed. It is based on the Robbins-Monro stochastic approximation procedure. Gradient evaluations are done by means of Monte Carlo simulations. At each iteratex _i , one sample point is drawn from an underlying probability space, based on which the gradient is approximated. The descent direction is against the approximation of the gradient, and the stepsize is 1/i. It is shown that, under broad conditions, w.p.1 if the sequence of iteratesx ₁,x ₂,...generated by the algorithm is bounded, then all of its accumulation points are stationary.     

超临界流体触媒作用下石墨-金刚石转变

 研究了超临界流体CO₂在石墨-金刚石转变中的触媒作用。实验中，采用Ag₂O作为流体触媒的先驱材料，在7.7 GPa压力下，Ag₂O在1 200 ℃分解成Ag和O₂，O₂与石墨套管在高温高压下反应形成CO₂超临界流体。研究结果表明，在7.7 GPa和1 500 ℃以上温度条件下，石墨在CO₂流体触媒的作用下可转变为金刚石晶体，在1 500～1 700 ℃温度范围内合成出的金刚石具有完好的八面体形貌，与天然金刚石的生长特征非常相似。     

High pressure X-ray diffraction study of CdAl2Se4 and Raman study of AAl2Se4 (A=Hg, Zn) and CdAl2X4 (X=Se, S)

We report the results of an X-ray diffraction study of CdAl₂Se₄ and of Raman studies of HgAl₂Se₄ and ZnAl₂Se₄ at room temperature, and of CdAl₂S₄ and CdAl₂Se₄ at 80 K at high pressure. The ambient pressure phase of CdAl₂Se₄ is stable up to a pressure of 9.1 GPa above which a phase transition to a disordered rock salt phase is observed. A fit of the volume pressure data to a Birch-Murnaghan type equation of state yields a bulk modulus of 52.1 GPa. The relative volume change at the phase transition at ∼9 GPa is about 10%. The analysis of the Raman data of HgAl₂Se₄ and ZnAl₂Se₄ reveals a general trend observed for different defect chalcopyrite materials. The line widths of the Raman peaks change at intermediate pressures between 4 and 6 GPa as an indication of the pressure induced two stage order-disorder transition observed in these materials. In addition, we include results of a low temperature Raman study of CdAl₂S₄ and CdAl₂Se₄, which shows a very weak temperature dependence of the Raman-active phonon modes.     

Convergent Flows of Molten Polymers Modeled by Generalized Second-Grade Fluids of Power-Law Type

The molding processes of polymer melts involve geometrically complex dies. Such dies are usually tapered or streamlined to achieve a maximum output rate under conditions of laminar flow. The model of a generalized second-grade fluid of power-law type is used and the results obtained are illustrated by examples of convergent flows in conical and wedge-shaped dies.