A RAPID APPROXIMATION FOR PREDICTING THE HYDROCARBON DISCOVERY RATE: PART 1. ASSESSING THE ACCURACY

The hydrocarbon discovery prediction problem is important to firms having to make decisions about the deployment of scarce exploration resources. Traditional methods for estimating the discovery rate rely on the completion of time consuming simulation experiments. A rapid approximation that does not require the completion of simulation exists and has been shown to have some promise as a prediction tool. This paper investigates the accuracy of the approximation method under a wide variety of distributional and drilling efficiency assumptions. The results indicate that the approximation produces predictions close to those of simulation under most of the tested conditions. This suggests that resource exploration firms could conveniently use the method for a wide variety of planning purposes without incurring the same costs in time and personnel required for simulation.     

斜孔气膜冷却数值模拟分析

本文通过数值模拟分析圆柱孔和扩散孔的单斜孔气膜冷却特性,考察复合角、孔型和吹风比对流场和气膜冷却效果的影响。结果表明,复合角的引入使气膜侧向分布更宽,但冷却效果沿主流方向衰减更快。适中吹风比得到的气膜能更有效的保护壁面。在相同吹风比和复合角条件下,扩散孔的气膜冷却效率比圆柱孔更好,且冷却更为均匀持久。     

用频域法实现圆环形目标物的计数

研究了用频域法实现圆环形目标物计数的方法。对空域中含有圆环形目标物的二值图像，经傅里叶变换后在频域内进行滤波，再经傅里叶反变换后取一阈值进行处理，则对应于圆环形目标物即变为一个实心体，然后对实心体进行计数即可实现对圆环形目标物的计数。对该方法进行了数学描述，并分别用模拟图像和实际图像进行了实验。结果表明，该方法消除噪声的效果好，对部分封闭圆的检测同样有效，且可用于目标物有粘连的情况。该方法对圆环形目标物的尺寸相差不大的情况更为有效。     

CdZnTe核探测器的蒙特卡罗模拟的初步研究

以CdZnTe核探测器的工作原理为依据,探测器内反应的随机性和反应产生的电子空穴对数目的统计规律为物理模型,应用Visual C + + 自行编制了蒙特卡罗模拟软件.模拟了γ射线在CdZnTe探测器中的响应能谱,并将模拟结果与实际器件的测试结果进行了比较讨论.模拟能谱与实际测得的能谱的主峰符合较好.此外,通过分析⁵⁷Co源辐照下探测效率与器件厚度的关系,可以推测探测效率达到最大时所对应CdZnTe探测器的理想厚度     

Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Simplified analytic solutions and a novel fast algorithm for Yb-doped double-clad fiber lasers

In this paper, continuous wave Yb³⁺-doped double-clad fiber lasers (DCFLs) with linear-cavity are investigated theoretically and numerically using the rate equations. Under the steady state conditions, the simplified analytic solutions of Yb³⁺-doped DCFLs under considering the scattering loss are deduced in the strongly pump condition. Compared with the known analytic solutions in published literatures, our analytic solutions are more accurate, especially, at higher reflectivity of output mirror. In addition, a fast and stable algorithm based on the Newton-Raphson method is proposed to simulate numerically Yb³⁺-doped DCFLs. The results by simplified analytic solutions are in good agreement with those by the numerical simulation. Moreover, we have performed the optimization of an Yb³⁺-doped DCFL using the simplified analytic solutions and the numerical simulations, respectively.     

Estimating tail probabilities of heavy tailed distributions with asymptotically zero relative error

Efficient estimation of tail probabilities involving heavy tailed random variables is amongst the most challenging problems in Monte-Carlo simulation. In the last few years, applied probabilists have achieved considerable success in developing efficient algorithms for some such simple but fundamental tail probabilities. Usually, unbiased importance sampling estimators of such tail probabilities are developed and it is proved that these estimators are asymptotically efficient or even possess the desirable bounded relative error property. In this paper, as an illustration, we consider a simple tail probability involving geometric sums of heavy tailed random variables. This is useful in estimating the probability of large delays in M/G/1 queues. In this setting we develop an unbiased estimator whose relative error decreases to zero asymptotically. The key idea is to decompose the probability of interest into a known dominant component and an unknown small component. Simulation then focuses on estimating the latter ‘residual’ probability. Here we show that the existing conditioning methods or importance sampling methods are not effective in estimating the residual probability while an appropriate combination of the two estimates it with bounded relative error. As a further illustration of the proposed ideas, we apply them to develop an estimator for the probability of large delays in stochastic activity networks that has an asymptotically zero relative error.      

Memory management optimization problems for integrated circuit simulators

In hardware design, it is necessary to simulate the anticipated behavior of the integrated circuit before it is actually cast in silicon. As simulation procedures are long due to the great number of tests to be performed, optimization of the simulation code is of prime importance. This paper describes two mathematical models for the minimization of the memory access times for a cycle-based simulator.An integrated circuit being viewed as a directed acyclic graph, the problem consists in building a graph order on the vertices, compatible with the relation order induced by the graph, in order to minimize a cost function that represents the memory access time. For both proposed cost functions, we show that the corresponding problems are NP-complete. However, we show that the special cases where the graphs are in-trees or out-trees can be solved in polynomial time.     

<Emphasis Type="Italic">Comment on</Emphasis>¶Low temperature specific heat of blue bronze K <Emphasis Type="Bold">0.30</Emphasis>MoO <Emphasis Type="Bold">3</Emphasis>, by J. Odin,J.C. Lasjaunias,K. Biljaković, K. Hasselbach,and P. Monceau

Eur. Phys. J. B 24, 315 (2001) Here we comment on a recently published paper on the presence of a phason contribution in the low temperature heat capacity data of the charge-density-wave compounds K_0.3MoO₃ and (TaSe₄)₂I. We have shown that the anomaly in the C _P / T ³ data reported by Odin et al. is straightforwardly interpreted in terms of low energy phonon modes resulting from the peculiar topology of these compounds. Received 21 February 2002 Published online 19 July 2002