Vehicle density and velocity estimation on highways for on-ramp metering control

A scheme for vehicle density and velocity estimation in a stretch of highway based on a modified cell transmission model [C. F. Daganzo, Transportation Research, Part B, 28B(4),269–287, 1994. Elsevier is presented. The scheme is intended for use with on-ramp metering control algorithms, providing local knowledge of densities and velocities that is helpful to improve on-ramp metering control performance. Estimation of density is obtained by nonlinear estimators, while velocity estimation is obtained by gradient algorithms. There is one density–velocity estimator for free traffic flow and other for congested traffic flow. Both estimator schemes work in parallel. The final estimation of density and velocity results from a convex combination of the predictions of the two estimators. This combination depends on occupancy or density measurements at the boundaries of the stretch and is produced by a fuzzy inference system. Stability and convergence of the density and velocity estimation scheme is proved by Lyapunov based techniques. Simulation results comparing measured and estimated traffic data are presented. They confirm good performance of the estimators. Research sponsored by grants UNAM PAPIIT IN110403 and CONACYT 47583.     

Ageing of wet-synthesized oxide powders

Wet chemical synthesis of precursor oxide ceramics is a method to obtain small particulate powders. Such powders are far more prone to ageing in air than more traditional precursors. Thermogravimetric analysis is used to highlight the species responsible for the ageing of ceramic precursors. Indeed water and carbon dioxide are observed to evolve from aged powders. Ceramics obtained from aged precursors can reach a very low final density with respect to the theoretical value. A large degree of the original sintering properties can be recovered after washing the aged powders with ethanol in a basic medium.     

Duality theorems for convex problems with time delay

In this paper, we examine a class of convex problems of Bolza type, involving a time delay in the state. It encompasses a variety of time-delay problems arising in the calculus of variations and optimal control. A duality analysis is carried out which, among other things, leads to a characterization of minimizers in terms of the Euler-Lagrange inclusion. The results obtained improve in significant respects on what is achievable by techniques previously employed, based on elimination of the time delay by introduction of an infinite-dimensional state space or on the method of steps.     

Generic existence of Lipschitzian solutions of optimal control problems without convexity assumptions

The Tonelli existence theorem in the calculus of variations and its subsequent modifications were established for integrands f which satisfy convexity and growth conditions. In this paper we consider a large class of optimal control problems which is identified with a complete metric space of integrands without convexity assumptions and show that for a generic integrand the corresponding optimal control problem possesses a unique solution and this solution is Lipschitzian.     

Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Semideterministic Global Optimization Method: Application to a Control Problem of the Burgers Equation

This paper has two objectives. We introduce a new global optimization algorithm reformulating optimization problems in terms of boundary-value problems. Then, we apply this algorithm to a pointwise control problem of the viscous Burgers equation, where the control weight coefficient is progressively decreased. The results are compared with those obtained with a genetic algorithm and an LM-BFGS algorithm in order to check the efficiency of our method and the necessity of using global optimization techniques.     

Some results on controllability of a nonlinear degenerate parabolic system by bilinear control

In this paper, we discuss the controllability of a nonlinear degenerate parabolic system with bilinear control. Based on the shrinking property of the solutions, we prove that the system is not globally approximately controllable. Furthermore, we give an approximate null controllability result. We also prove that the system is not globally exactly null controllable by a comparison principle.     

LD端抽运平直腔Nd:YVO4固态激光器的输出功率特性研究

对LD端抽运平直腔Nd:YVO₄固态激光器输出功率特性受激光器内在诸因素(热透镜效应、腔长、激活孔径等)的制约关系进行了研究.并用传播圆-变换圆图解分析方法给出了合理的解释，同时，对进一步提高其输出功率特性指出了方向. 关键词： 固体激光器 热透镜 变换圆 平直腔     

挖坑机钻头主轴纵向振动系统模型的建立与控制

首先利用弹性杆理论和H am ilton变分原理建立了挖坑机钻头主轴及钻尖在工作过程中由于外激励的作用使钻尖与土壤互相作用而产生纵向振动的动力学模型,同时给出边界条件和初始条件.其次通过把系统外激励函数当作控制变量,利用Banach空间几何性质证明了此系统存在唯一最优控制元.