检测实验室如何开展管理评审工作

详细论述了管理评审的基本概念、如何开展管理评审工作以及中国实验室国家认可委员会的有关政策。     

Physico-Chemistry of the Limestone Sulphation Process

Aspects of the mechanism of the overall reaction between CaCO₃/CaO and SO₂/SO₃ under oxidizing conditions are discussed. The limestone and lime sulphation processes were carried out in a thermobalance under conditions relevant to atmospheric fluidized bed combustion. Sulphated samples, prepared in the form of cross-section particles, were examined in a scanning electron microscope by energy-dispersive X-ray and back-scattered electron imaging. Photomicrographs are presented. The reaction proceeded from the outer surface of the particles and along the pores. Surface textural changes during the reaction were considered. The layer of products was identified as controlling both the rate and extent of limestone/lime sulphation. In the products, two sulphur-bearing solids (CaSO₄ and CaS) were identified. The presence of CaS, which may cause difficulties in practice, is attributed to CaSO₃ disproportionation. This revised version was published online in August 2006 with corrections to the Cover Date.     

Studies of solvent effects

The effect of water on the conformational preferences of acetylcholine has been studied within the discrete, the continuum and the combined discrete-continuum models described in parts I and II of this series. All the models lead to the conclusion that the trans-gauche form which is, following refined quantum-mechanical computations, the intrinsically preferred one and the one observed in the crystal of acetylcholine and of a number of analogues should remain also the preferred conformation in water. This result agrees with NMR studies. The results of the empirical discrete model used here compare favorably to those obtained by an ab initio super-molecule treatment. The continuum model utilized here represents a net improvement above such models utilized in other works.     

Study of the absorption spectra and ionic equilibria of cationic-anionic polymethine dyes

The absorption spectra of a number of cationic-anionic polymethine dyes in polar, low-polarity, and nonpolar solvents were studied. It was established that in polar solvents the absorption spectra represent the sum of the absorption spectra of the cation and anion, whereas in nonpolar and low-polarity solvents, in many cases the appearance of a short-wave absorption band is observed, due to interaction of the chromophores of the cation and anion in ion pairs. In solvents of intermediate polarity (for example, in chloroform and ethyl acetate), a concentration dependence of the absorption spectra is observed, determined by the equilibria of ionic dissociation. The ionic dissociation constants of a number of cationic-anionic dyes in chloroform and ethyl acetate were determined by a conductometric method. The thermodynamic data obtained are compared with the spectral data.N. N. Semenov Institute of Chemical Physics, Russian Academy of Sciences, 117977 Moscow. Translated fromIzvestiya Akademii Nauk, Seriya Khimicheskaya, No. 11, pp. 2524–2532, November, 1992.     

氮杂冠醚研究Ⅶ、双仲胺型氮杂冠醚对过渡金属离子的选择性萃取作用

合成了五种新型双仲胺型氦杂冠醚，研究了它们对过渡金属离子进行液—液萃取，并用原子吸收法测定其浓度。实验结果表明：这类冠醚对Ａｇ￣＋、Ｐｄ￣（２＋）、和Ｐｔ￣（４＋）等贵金属离子有较强的选择配位性能，对选择性分离这些金属离子有重要的意义。     

Reagentless system for sulphite determination based on polyaniline

A new reagentless system for sulphite (or sulphur dioxide) determination is reported based on the use of an organic conducting polymer, polyaniline, and its absorbance variation at 550 nm, depending on the sulphite concentration. After chemical polymerisation of aniline a very thin film of polyaniline is obtained. Although the response is not fully reversible, each film can be used for at least 10 measurements for low analyte concentrations (up to 0.5 mg l⁻¹) and five measurements for higher sulphite concentrations. Moreover, the reproducibility, ease of preparation and low cost of the films, permit the use of a new disposable system for each measurement. When the change in absorbance at 550 nm was measured for 210 s (stabilisation time), the system showed a linear response, which ranged from 0.025 to 1.50 mg l⁻¹ of sulphite. A theory with regard to the reaction mechanism between the polyaniline films and sulphite is also proposed. The system was applied to sulphite determination in wine samples and the results were in agreement with those obtained by the Official Method of Analysis (iodometric titration).     

一种测定蛋白质的分子吸收光谱分析新体系

使用四溴荧光素(TBFS)作为蛋白质的染色剂,建立了一种测定蛋白质的分子吸收光谱分析新体系———BSA 四溴荧光素,体系十分简单,BSA浓度在0.11～60.0μg·ml-1范围符合比耳定律;测定15.0μg·ml-1BSA溶液10次,求得相对标准偏差为1.26%,桑德尔灵敏度为0 094μg·cm-2。可直接用于血清样品中蛋白质的测定,测得质量控制血清样品中蛋白质质量为35.4±2.4mg,与标准值36.9mg吻合。回收率在97.0%～108.3%之间,结果满意。     

Magnetic behavior of copper diethyldithiocarbamate at low temperatures: A reinvestigation

The title compound, Cu(S₂CNEt₂)₂, behaves at low temperatures (1–20 K) as a normal spin-1/2 molecule, with 〈g〉 =2.06 and the Curie-Weiss θ = +0.25 K. This result contradicts an earlier investigation that led to the suggestion that the crystallographically-occurring dimers are coupled ferromagnetically.     

Determination of heavy metal concentration in feed and permeate streams of polymer enhanced ultrafiltration process

Polymer enhanced ultrafiltration (PEUF) is a newly developed method for the removal of heavy metals from aqueous solutions. This method was applied for the removal of mercury and cadmium with the presence of polyethyleneimine (PEI) as a water soluble polymer. After ultrafiltration experiments for metal–polymer mixtures, two separate streams, namely, retentate and permeate, former of which contains mainly metal–polymer complex and free polymer molecules while latter of which mainly contains free metal ions, were obtained. At the end of PEUF experiments, performance of operation was determined by concentration analyses which was achieved by atomic absorption spectroscopy (AAS) applied in a different way for permeate and retentate streams considering the effect of presence of polymer. For mercury analysis, cold vapor AAS was applied. It was observed that the presence of PEI did not affect the atomic absorption signal when 10% HCl was added to the sample solutions. For calcium and cadmium, flame AAS was used. It was observed that change in PEI concentration results in change in measured concentration of calcium and cadmium. Therefore, two new approaches were developed for accurate measurement of concentrations of calcium and cadmium. It was also observed that presence of other metals did not affect the accuracy of the measurement of a particular metal in the concentration range studied.