A fixed-point equation for the high-temperature phase of discrete lattice spin systems

A fixed-point equation on an infinite-dimensional space is proposed as an alternative to the usual definition of the infinite-volume limit in discrete lattice spin systems in the high-temperature phase. It is argued heuristically that the free energy and correlation functions one obtains by solving this equation agree with the usual definitions of these quantities. A theorem is then proved that says that if a certain finite-volume condition is satisfied, then this fixed-point equation has a solution and the resulting free energy is analytic in the parameters in the Hamiltonian. For particular values of the temperature this finite-volume condition may be checked with the help of a computer. The two-dimensional Ising model is considered as a test case, and it is shown that the finite-volume condition is satisfied for0.77 _critical.     

Pressure and temperature effects on the excess deuteron and proton conductance

The limiting molar conductances ° of deuterium chloride DCl in D₂O were determined as a function of pressure and temperature in order to examine the proton-jump mechanism in detail. The excess deuteron conductances °_E(D ⁺), as estimated by the equation [°_E(D ⁺) = °(DCl/D ₂ O) – °(KCl/D ₂ O)], increases with an increase in the pressure and temperature as well as the excess proton conductance [°_E(H ⁺) = °(HCl/H ₂ O) – °(KCl/H ₂ O)]. The isotope effect on the excess conductances, however, depends on the pressure and temperature contrary to the model proposed by Conway et al.: °_E(H ⁺)/°_E(D ⁺) decreases with increasing pressure and temperature. The magnitude of the decrease with pressure becomes more prominent at lower temperature. These results are discussed in terms of the pre-rotation of adjacent water molecules, the bending of hydrogen bonds with pressure, and the difference in strength of hydrogen bonds between D₂O and H₂O.     

MgO•3B2O3-18%MgSO4-H2O过饱和溶液析出固相组成和机理研究

针对青藏高原盐湖卤水析盐过程的特点, 模拟合成MgO•3B₂O_3-18%MgSO_4-H₂O过饱和溶液, 在150 ℃水热条件下对析出固相进行研究. 用化学分析方法、X射线衍射、红外光谱进行物相鉴定. 提出了可能的结晶反应机理, 分析了水热温度对析出物相的影响及MgSO₄对硼酸镁盐的盐溶效应随水热温度的变化.     

Partial molal heat capacities of aqueous tetraalkylammonium bromides as functions of temperature

Enthalpies of solution have been measured from 5 to 85°C for aqueous tetraethyl- and tetrapropylammonium bromides, and the integral heat method is employed to evaluate for these electrolytes over a wide temperature range. Data taken from the literature have been used to evaluate for aqueous Bu₄NBr over a similar temperature range. These data, along with similar data for Me₄NBr, previously reported, have been used to evaluate absolute ionic heat capacities. While the absolute values agree only qualitatively with two other methods of division, the temperature dependences of the three methods essentially agree up to 65°C. Heat capacities due to structural effects on the solvent, obtained by subtracting the inherent heat capacities of the ions, are extraordinarily positive for all four tetraalkylammonium ions and have negative temperature coefficients, indicating that all four ions, including the tetramethylammonium ion, are structure-making ions.     

Thermal coefficient of linear expansion of non-crystalline chalcogenides in the As-S-Se-Te-I system

The object of the paper is an investigation of the glasses of the (As₂S₃)_x(AsSe_0.5Te_0.5I)_100-x. type for 65≤;x≤;95, using methods of thermomechanical analysis. Values of the thermal coefficients of linear expansion in solid and visco-plastic phase were determined. it was shown that introducing arsenic-sulfide in glass-matrix AsChI, i.e. (AsSe_0.5Te_0.5I), leads to an increasing stability of these glasses. The characteristic temperatures of softening Tg and the temperature of the beginning of deformation t_w increase by increasing content of As₂S₃. The analytical forms of dependence of four significant physical values α_g, α_l, Tg, Tw, as a function of As₂S₃ content in the structure of glasses were fitted. This revised version was published online in July 2006 with corrections to the Cover Date.     

Sub-zero temperature behavior of water in non-ionic microemulsions

Sub-zero temperature DSC measurements were conducted to evaluate the behavior of water in non-ionic microemulsions. Two surfactant systems were studied. The first, based on ethoxylated fatty alcohol, octaethylene glycol monon-dodecylether [hereafter referred to as C₁₂(EO)₈] and also containing water, pentanol and dodecane at a fixed weight ratio of 1:1. The second system, based on oligomeric ethoxylated siloxanes, water and dodecanol as oil phase. In both systems it was found that in up to 30 wt.% of the total water content, all water molecules solubilize in the amphiphilic phase and are bound to the ethylene oxide (hereafter referred to as EO) head-groups. No free water exists in the surfactant aggregates’ core. Up to three molecules of water are bound to each EO group. In the first system, the behavior changes significantly upon adding more water. The added pentanol allows further swelling and the water penetrates into the amphiphile structures and forms a reservoir of free water. Structures are deformed and grow from elongated channels (up to 15–20 wt.% water), via illdefined (one-dimensional growth) local lamellar structures (up to ca. 60 wt.% water) to spherical normal, O/W micelles (at ≥85 wt.% water). In contrast, the oligomeric systems, due to geometrical restrictions of the amphiphiles and the nature of their curvature that prevents inversion, cannot further solubilize water in the surfactant aggregates’ core, causing phase separation to occur. Part of the results presented in this paper were included in S. E.’s doctoral thesis in Applied Chemistry at The Hebrew University of Jerusalem, Israel.     

还原温度对超细K－Co－Mo催化剂合成低碳醇性能的影响

 用溶胶－凝胶法合成了K－Co－Mo催化剂．样品经不同温度还原后，用于低碳醇的合成．XRD和HRTEM结果表明，样品是超细粒子，粒子尺寸为2～5nm．考察了催化剂的还原温度和反应条件对催化剂性能的影响．实验结果表明，还原温度对催化剂的活性有较大的影响，最佳还原温度为500℃．最佳反应温度范围为310～330℃．升高压力和空速可以提高醇的收率和选择性．在空速14400h－1，压力6．0MPa和温度310℃的条件下，醇的选择性为55．8％，收率为520．0g／（kg·h），MeOH／C2＋OH为0．27．催化剂稳定性良好，在200h的寿命实验中，活性基本不变．与文献中催化剂相比，超细K－Co－Mo催化剂对合成醇具有较高的活性和选择性，尤其是对C2＋OH的合成明显高于其他合成醇催化剂体系．     

纳米氧化铜的制备及常温脱硫效能研究

采用硝酸铜为原料、氢氧化钠溶液为沉淀剂、使用体积比为1∶1的乙醇-水溶液为分散剂的直接沉淀法制备，通过改变工艺条件得到了三种纳米氧化铜产品，平均粒径分别为25.63，10.74和7.57 nm。采用TG-DTA、FIR、XRD和TEM等对纳米氧化铜进行表征。对产品的常温脱硫活性进行了穿透试验，并与已开发的其他常温精脱硫产品进行了比较，结果表明纳米氧化铜应用于H₂S脱硫，可在常温条件下具有优异的脱硫活性，对H₂S的脱除精度可以达到0.05 mg·m^-3以下。经过优选，产品在3 000 h^-1空速下穿透硫容达到25.3%，高于同类型的其他脱硫剂产品。     

溶液酸度和反应温度对CaMoO4薄膜电化学制备的影响

本工作研究了恒电流电化学技术制备CaMoO₄薄膜工艺中，溶液酸度和反应温度对薄膜形成的影响。结果表明，酸度会影响薄膜的生长时间和光致发光特性，在较低酸度沉积薄膜时，容易造成薄膜的团簇生长和不确定相的形成；适当升高反应温度会加快晶粒的生长、提高薄膜的纯度、增加薄膜发射光谱的相对强度。在CaMoO₄薄膜电化学制备工艺中，溶液pH值控制在12.0附近和反应温度控制在60 ℃的左右比较好。     

Freezing temperatures and densities of solutions of some hydrocarbons and sodium oleate inN-methylacetamide. Evidence for a solvophobic interaction

The freezing temperatures and densities (at 31°C) of solutions of octane, nonane, decane, 3,3-diethylpentane, and sodium oleate inN-methylacetamide (NMA) have been measured. The molality of the freezing solution was calculated from the density. The solubilities of octane, nonane, and decane inN-methylacetamide are also reported. Apparent molal volumes calculated from the densities are close to the values in the pure hydrocarbons and are not strong functions of the concentration. This indicates the absence of any unusual packing effect. The calculated free energies of transfer of the hydrocarbons from pure hydrocarbon to NMA solution are much less negative than the corresponding values for water, showing that the bulk solvophobic interaction inN-methylacetamide is smaller than in water. This is consistent with the freezing temperatures of sodium oleate which show that micelles do not form below 0.1 mole-kg^–1. The osmotic coefficients of the hydrocarbons calculated from the freezing temperatures showed negative deviations from ideality that were larger for the hydrocarbons with the higher molecular weights. Two estimates of the pairwise solvophobic interaction inN-methylacetamide indicate that it is also smaller than in water. The solvophobic effect in this solvent does not include the large entropy and enthalpy effects found in aqueous solutions.