纳米CoSe修饰氮掺杂多孔碳的可控制备及其锂硫电池多硫化物的催化转化效应

锂硫电池中较差的循环稳定性和倍率性能是实现锂硫电池商业化的技术障碍,其主要原因之一是多硫化物在硫电极内的电化学转化动力学较为缓慢。为此,我们以ZIF-9为前驱体,采用先碳化,再酸化刻蚀,最后硒化的方法合成了含少量催化剂的CoSe修饰氮掺杂多孔碳(CoSe/NC)电极材料,以期提高硫电极内多硫化物的电化学转化动力学性能,并通过流动液相三电极体系对该材料进行电化学动力学表征。结果显示,相较于对比材料,CoSe/NC能够加快多硫化物的氧化还原反应速率,在 0.2mA·cm^-2电流密度下,多硫化物氧化还原反应在CoSe/NC电极上有最小的反应过电位;同时,在0.1 V过电位下,各氧化还原反应也有最大的响应电流。因此,将 CoSe/NC作为硫宿主材料组装电池展现了优异的电化学性能：在 1C(1C=1 675 mA·g^-1)下初始放电比容量为1 068 mAh·g^-1,经过500次循环后,可逆容量仍保持在693 mAh·g^-1。另外,在3C的高电流密度下,放电比容量可高达819 mAh·g^-1。     

Sample Injection for Capillary Electrophoresis on a Micro Fabricated Device/On Chip CE Injection

Abstract

Reproducible injection for capillary electrophoresis on a micro device/Lab on chip is not an easy task. Different injection designs (e.g., T‐type, double T‐type, cross) and different injection modes have been applied (pinched injection, gated injection, optically gated injection, pressure/pneumatic injection, double L injection) with various analytes. Problems and properties of the different modes are described.     

The Review of the Catalyst System of Poly（ethylene oxide）

聚氧化乙烯（PEO）是环氧乙烷经开环聚合而成的一种多功能水溶性聚合物,性能优异,用途广泛。本文简述了聚氧化乙烯的典型特征和国内外研究进展,综述了聚氧化乙烯制备的各类催化剂体系,描述了催化剂聚合环氧乙烷的聚合机理,重点介绍了几种具有工业应用前景的催化剂体系：烷基金属催化剂体系、烷氧基金属催化剂体系和碱土金属氨化物催化痢体系。并对其技术发展和应用进行了展望。     

温控聚乙二醇两相体系中纳米钯催化肉桂醛选择性加氢反应

将具有“高温混溶、室温分相”功能的聚乙二醇4000(PEG₄₀₀₀)与甲苯-正庚烷组成的两相体系用于纳米钯催化的肉桂醛选择性加氢反应中.在优化的反应条件下,肉桂醛转化率和氢化肉桂醛选择性分别为99%和98%.钯纳米催化剂经简单分相即可与产物分离,且循环使用8次,其活性和选择性基本保持不变.     

Theoretical and experimental study of the biamperometry for irreversible redox couple in flow system

The biamperometry for the direct determination of irreversible redox analytes in flow system has been proposed based on coupling two independent and irreversible couples to form the biamperometric detection scheme. In this work, the method is studied both theoretically and experimentally. Equations describing the current–voltage characteristics and the current–concentration relationship are presented. The influence of the applied potential difference (ΔE) and the half-wave potential difference (ΔE_1/2) between two irreversible couples on the method are discussed. It shows that small ΔE_1/2 is favorable to construct the biamperometric detection system and to achieve high sensitivity and selectivity. Increasing ΔE leads to an increase in sensitivity. This is, however, accompanied by a decrease in selectivity and signal-to-noise ratio. To construct the biamperometric scheme for the irreversible systems with large ΔE_1/2, two approaches, adjusting acidity of supporting electroyte or adding new irreversible couple, are proposed by taking uric acid/platinum oxide and phenol/permanganate systems as examples. Uric acid and phenol are, respectively, detected in a flow injection system with a biamperometric detector.     

光固化环氧丙烯酸酯/SiO2杂化材料的研究

用FTIR、SEM、DSC和TGA表征了光固化环氧丙烯酸酯／SiO2杂化材料[(EA-TMSPM)／SiO2]，研究了盐酸、γ-甲基丙烯酰氧丙基三甲氧基硅烷(TMSPM)和无机物浓度对(EA-TMSPM)／SiO2结构与性能的影响。结果表明，无机物浓度高的(EA-TMSPM)／SiO2杂化体系中SiO2粒子尺寸略大于无机物浓度低的体系；盐酸和无机物浓度的增加，都可以增强杂化材料的耐磨性。     

THE EFFECT AND FUNCTION OF AliBu_2OR'''' ON BUTADIENE-PROPYLENE ALTERNATING COPOLYMERIZATION CATALYZED BY VO(OR)_2Cl-AIiBu_3 SYSTEM

Four kinds of AliBu_2OB' with different R' were synthesized. The effect of AliBu_2OR'/AliBu_3 mole ratio on the conversion, the [η] of copolymer and catalytic efficiency were studied. The conversion was increased obviously and the catalytic efficiency was 2.7 times higher than before. The effect of the amount of AliBu_2OR' on the valence state of vanadium ion and the change of the valence state of vanadium ion with reaction temperature and time were studied. The VIS and IR spectra of the trinary-component catalyst system were measured. The model of active center including AliBu_2OR' was proposed. The function of AliBu_2OB was explained.     

The influence of the pore size, the foaming temperature and the viscosity of the continuous phase on the properties of foams produced by membrane foaming

Membrane foaming is a new method of foaming. To enlarge the knowledge about the influencing factors and to know how to vary the structure of the resulting foam, different factors were evaluated. A whey protein solution with 10% protein was foamed as a model solution by means of a tubular cross-flow filtration membrane. The pore size of the membrane was varied. The smaller the pore size, the smaller the bubbles produced. As a result, the foam firmness increases and less drainage was observed when smaller pore sizes were applied.

An important factor is that the added amount of gas must be stabilised as completely as possible in the foam. In order to achieve this, both the process and the product parameters were varied. Raising the foaming temperature increased the quantity of stabilised gas. The whey proteins then diffuse faster to the bubble surfaces and stabilise these by unfolding and networking reactions to prevent the coalescence of the bubbles.

The product parameter viscosity was found to influence the foaming result in such a way that up to a viscosity of 40 mPa s the incorporated gas bubbles are stabilised by the higher viscosity. At viscosities higher than 40 mPa s it is difficult to incorporate in the bubbles, and the foam structure becomes coarser due to increased coalescence at the pores of the membrane. The foam stability is enhanced with higher viscosities.     

1,1,3,3-四(全氟己基乙基)二锡氧烷二聚体在环氧化合物开环反应中的催化作用

采用氟碳-有机溶剂两相催化体系,考察了1,1,3,3-四(全氟己基乙基)二锡氧烷二聚体(1)在环氧化合物开环反应中的催化作用.结果表明,催化剂(1)在氟碳-有机溶剂两相体系中使环氧苯乙烯和甲醇的开环反应产率高达95%,¹³CNMR谱表明,开环反应的区域选择性为100%.在氟碳-有机溶剂两相催化体系中以一锅法制备了3-苯基丙酸2-甲氧基-2-苯乙醇酯,收率高,方法简便,催化剂几乎可以定量回收循环使用.     

水分散体系中苯乙烯和甲基丙烯酸甲酯梯度共聚物的合成与表征

以2-溴代异丁酸乙酯(EBiB)为引发剂,CuBr/CuBr₂/1,10-邻二氮菲(phen)为复合催化剂,十二烷基磺酸钠(SLS)为乳化剂,考察了水分散体系中苯乙烯(St)和甲基丙烯酸甲酯(MMA)的原子转移自由基共聚合的可控性和相对反应活性.在此基础上,通过反应进料法在水分散体系中进行了St和MMA的梯度共聚合,反应表现出“活性”聚合的特征,即所得共聚物的数均分子量随着单体转化率的增加而增大,分子量分布较窄(M_w/M_n<1.50).用¹HNMR跟踪分析了聚合反应过程中共聚物微观组成的变化规律,结果表明,共聚物链中MMA链节的累积含量和瞬时含量都随着共聚物相对链长的增加而增加,即随着聚合物相对链长的增加共聚物的微观组成从St链节占主导地位逐渐变化为以MMA链节占主导地位,表明确实形成了St和MMA的梯度或渐变共聚物.