环形电极单间隙电晕放电伏安特性

基于用于直线变压器型驱动源的多间隙气体开关结构,提出一种环形放电间隙与电晕针并联的气体火花间隙。通过测量间隙耐压过程中电晕放电的伏安特性,研究了气体介质、气压、电晕极性、电晕针长度以及针尖对应电极结构等因素对伏安特性的影响。结果表明:以空气为绝缘气体,负极性电晕可获得较稳定的伏安特性;改变电晕针长度和针尖对应电极结构可方便地实现对电晕放电伏安特性的调节以满足开关要求。     

单源单极等离子体天线辐射特性实验研究

为了对等离子体天线进行更深入的研究,必须结合实验获得其真实辐射特性,为此搭建了天线辐射特性测量平台,对单源单极等离子体天线的辐射特性进行了详细的实验研究。通过测量辐射远场区接收天线感应电压数据,得出了天线的辐射方向图、主旁瓣宽度和方向系数;通过与金属天线的辐射场最大值对比,得出了天线的辐射效率;通过测量输入功率和反射功率得出了天线的输入阻抗。此项工作弥补了在等离子体天线研究中实验研究不足的问题。     

Protection of iron corrosion by stearic acid and stearic imidazoline self-assembled monolayers

A type of stearic imidazoline (IM) inhibitor was prepared using stearic acid (SA) and diethylenetriamine (DETA) as raw materials. The monolayers of IM and SA were assembled on the iron surface. The electrochemical characterization of stearic acid (SA) and stearic imidazoline (IM) on an oxide free iron surface had been studied. The monolayers of IM inhibitor were characterized by electrochemical impedance spectroscopy (EIS), electrochemical polarization curves, double layer capacitance, X-ray photoelectron spectroscopy (XPS) and molecular simulation. The results of electrochemical studies had illustrated that the inhibition efficiency of IM was higher than SA. XPS showed that the IM molecules adsorbed on the iron surface. The molecular simulation calculations showed that the IM molecules were tilted at an angle on the iron surface.     

Electrochemical impedance spectroscopy and linear polarization applied to evaluation of porosity of phosphate conversion coatings on electrogalvanized steels

In this work, electrochemical impedance spectroscopy and linear polarization are used in determining porosity of zinc phosphates, and of nickel and manganese modified zinc phosphates on electrogalvanized steel. The porosity of the phosphate layers ranges from 0.1% for the manganese-modified hopeite to 8% for hopeite, using the linear polarization and the electrochemical impedance spectroscopy techniques. The porosity values measured using the two techniques were in agreement. All impedance spectra of coated samples showed two steps, with two capacitive arcs and an inductive looping.     

大面积染料敏化太阳电池的串联阻抗特性研究

在电子扩散微分方程的基础上,研究了染料敏化太阳电池光生电流和光生电压随光照强度不同的变化关系.提出敏化太阳电池串联阻抗功率损耗模型,理论模拟了大面积电池（有效面积>1 cm²）光电转换效率随多孔薄膜有效面积宽度变化的曲线、透明导电基底膜与银栅极的比接触电阻以及在不同入射光强下银栅极体电阻对大面积染料敏化太阳电池光伏性能的影响.结果表明透明导电基底膜的方块电阻和银栅极体电阻对大面积染料敏化太阳电池的性能有很大影响,而这种影响随光强的减弱逐渐减小. 关键词： 染料敏化 太阳电池 串联阻抗 光电转换效率     

Tunable acoustic radiation pattern assisted by effective impedance boundary

The acoustic wave propagation from a two-dimensional subwavelength slit surrounded by metal plates decorated with Helmholtz resonators(HRs) is investigated both numerically and experimentally in this work. Owing to the presence of HRs, the effective impedance of metal surface boundary can be manipulated. By optimizing the distribution of HRs,the asymmetric effective impedance boundary will be obtained, which contributes to generating tunable acoustic radiation pattern such as directional acoustic beaming. These dipole-like radiation patterns have high radiation efficiency, no fingerprint of sidelobes, and a wide tunable range of the radiation pattern directivity angle which can be steered by the spatial displacements of HRs.     

嵌入到Fabry-Perot谐振腔的双晶约瑟夫森结阵列的阻抗匹配和相位锁定研究

在He等人所做的嵌入到Fabry-Perot谐振腔中约瑟夫森结阵列的微波辐照研究基础上,提出了同时实现约瑟夫森结阵列阻抗匹配和相位锁定的方法,进行了相关的电磁仿真和数值计算.双晶约瑟夫森结阵列被制作在YSZ双晶基片上,同时被嵌入到Fabry-Perot谐振腔内.通过在基片上制作与结阵列集成的串联馈电半波偶极天线阵,并对其结构进行优化实现了结与天线的匹配,数值计算表明结的辐射效率达到94%;利用天线阵辐射场的特征和对模型合理的设计,使Fabry-Perot谐振腔和基片同时谐振在合适的模式下,从而使结阵列与谐 关键词： 约瑟夫森结阵列 阻抗匹配 相位锁定 Fabry-Perot谐振腔     

新型掺碳二氧化硅-薄膜体声波谐振器结构及其仿真验证

一定厚度的低声阻抗支撑层可以在薄膜体声波谐振器(FBAR)与衬底之间形成声学隔离层,防止声波泄漏到衬底当中。掺碳二氧化硅(CDO)是一种低声阻抗材料,对FBAR具有较好的温度补偿效果,可以作为FBAR与衬底之间的声学隔离层,从而构成一种新型的CDO-FBAR。为了分析CDO-FBAR与通孔型FBAR相比性能是否退化,以及CDO声学隔离层所需厚度,采用多物理场耦合仿真软件分析了CDO-FBAR和通孔型FBAR的谐振频率、Q值、有效机电耦合系数和S参数,并提取了CDO-FBAR纵向振动位移。分析结果表明：CDO-FBAR的谐振频率整体向下漂移;CDO声学隔离层导致S参数的寄生干扰;由于声学损耗增加,Q值略有降低,其中并联谐振点处的Q值降幅更大;有效机电耦合系数略有降低;声波传播到声学隔离层中9 m处就完全衰减,即只需要9 m厚的CDO声学隔离层就能在FBAR与衬底之间形成有效的声学隔离。由此,仿真验证了这种新颖的CDO-FBAR结构的可行性。     

基于缺陷地结构的微带低通滤波器设计

提出了一种具有宽带带外抑制的小型化微带低通滤波器。该滤波器由缺陷地结构和两阶阶跃阻抗单元结构构成。利用ANSYS HFSS建立三维全波电磁模型并仿真优化,仿真结果表明：该低通滤波器的截止频率为1.4 GHz,通带宽度为0~1.4 GHz,通带内的插入损耗小于0.5 dB,带外抑制频率范围为2.1~11 GHz,在阻带范围内的带外抑制能力接近20 dB。为验证仿真和测试结果,加工并测试了经全波电磁优化后的缺陷地结构微带低通滤波器。测试结果和仿真结果吻合得较好,证明了所提出的缺陷地结构在实现滤波器小型化和宽阻抗带宽上有着重要的作用,能够使该滤波器具有较好的低通滤波特性。     

窗口声阻抗对锆相变动力学的影响

基于磁驱动加载装置CQ-4开展了锆的斜波压缩相变实验,研究了锆样品后表面窗口声阻抗对相变波形的影响.实验结果显示,锆后表面为较低声阻抗窗口(自由面和LiF窗口)时,相变起始对应的特征粒子速度约331.0 m/s,而高阻抗蓝宝石窗口时,特征粒子速度约301.9 m/s,特征速度对应的压力从约9.14 GPa下降到8.27 GPa.相变对应的速度特征拐点是与多种因素相关的实验信息,因此它对应的压力并不是材料属性参数相变压力.结合基于热力学Helmholtz自由能的多相状态方程和非平衡相变动力学方程开展了锆的相变动力学数值模拟研究,相变弛豫时间为30 ns,计算结果与三种情况的实验结果符合良好,可以较好地模拟斜波压缩下锆的弹塑性转变、相变等物理过程.在压力-比容和温度-压力热力学平面,相变前锆的准等熵线与冲击绝热线差异很小,相变后准等熵线都位于冲击绝热线下方,随着压力的增加准等熵线和冲击绝线偏差越来越大,温度-压力平面中在20 GPa时相差约100 K.相变开始后,由于相变引起比容的间断,导致锆的拉氏声速迅速下降约7%,相变完成后拉氏声速恢复到体波声速.