柠檬酸络合法制备的Co/CeO2催化剂上中温乙醇水蒸气重整性能（英文）

采用柠檬酸络合法制备了Co/CeO2及其钙掺杂系列催化剂,并对催化剂进行了低温N2物理吸附、X射线衍射、H2程序升温还原、傅里叶变换红外光谱、高分辨透射电镜表征以及乙醇水蒸气重整催化性能测试.结果表明,所制Co/CeO2催化剂具有良好的乙醇水蒸气重整催化性能,500oC时乙醇能全部转化为C1,氢气产率高达85%以上.Ca掺杂减小了载体CeO2纳米颗粒尺寸,但对还原后Co0尺寸的影响较小.当Ca掺杂量大于5.0%时,催化剂氧化还原性能和乙醇水蒸气重整催化性能下降.较高的还原温度有利于体相Ce4+还原为Ce3+,并且提高了催化活性,认为金属-氧化物边界的增加提高了催化活性.初步稳定性考察结果表明,5%钙掺杂后的催化剂具有更好的抗积炭性能.     

Numerical analysis and experimental study of hydrogen production from dimethyl ether steam reforming

An experimental and theoretical study of steam reforming of dimethyl ether was carried out in a processor for fuel cell vehicles to explore the effect of temperature gradient and hydrogen content of the processor.A steady-state,laminar,two-dimensional axi-symmetric model was proposed to investigate the fluid flow,heat transfer and chemical reactions in the dimethyl ether steam reforming processor using porous medium approach.The numerical model was established with Star-CD program using SIMPLE algorithm and finite volume method.Experimental verification of the two-dimensional mathematical model was conducted.The numerical results coincided well with the experimental data.The effects of the parameters on the temperature gradient and hydrogen content of the processor were studied using the numerical model.     

甲醇水蒸汽催化重整过程的研究进展

甲醇水蒸汽重整是车载燃料电池较为理想的氢源,其中选择合适的催化剂又是重整反应的一个关键问题.本文综述了应用于甲醇水蒸汽重整反应的常用催化剂,如含Cu、Ni、Cr、Pd等,包括这些催化剂的催化性能、反应条件、产物分析等,并对部分催化剂的催化机理和动力学分析进行了概述.另外,还简要地介绍了应用于氧化水蒸汽重整反应的催化剂。     

水蒸气处理对HZSM-5分子筛催化剂的酸性及孔结构的影响

通过XRD，NH3-TPD，IR，比表面与孔结构测定等方法，研究了HZSM-5分子筛（硅铝比为38）在不同温度下进行水热处理时的酸性与孔结构。结果表明，随着水热处理温度的提高，HZSM-5分子筛的结晶度稍有增大；酸性明显减弱，弱酸位增多，强酸位相对减少；IR谱图上有一定的蓝移；比表面与微孔体积减小，介孔体积增大。     

水蒸气气氛煤中温催化气化动力学研究

以碳酸钾为催化剂,用热天平的等温热重法研究了四种不同变质程度煤焦常压下水蒸气催化气化反应动力学。在加和不加碳酸钾条件下,测定了温度为700~850℃煤焦的化学反应控制条件下的碳转化率与时间的关系。碳酸钾催化剂的加入对变质程度越高煤的气化催化作用越大。加碳酸钾的碳转化率与时间的关系用混合模型和修正随机孔模型可以良好的拟合关联,均相模型关联较差。利用修正随机孔模型拟合关联出了四种煤焦催化水蒸气气化反应的活化能和指前因子,活化能为90.317~167.861kJ/mol,指前因子和活化能之间具有补偿效应。     

Dual‐Function Cobalt–Nickel Nanoparticles Tailored for High‐Temperature Induction‐Heated Steam Methane Reforming

The tailored chemical synthesis of binary and ternary alloy nanoparticles with a uniform elemental composition is presented. Their dual use as magnetic susceptors for induction heating and catalytic agent for steam reforming of methane to produce hydrogen at temperatures near and above 800 °C is demonstrated. The heating and catalytic performance of two chemically synthesized samples of CoNi and Cu ? CoNi are compared and held against a traditional Ni‐based reforming catalyst. The structural, magnetic, and catalytic properties of the samples were characterized by X‐ray diffraction, elemental analysis, magnetometry, and reactivity measurements. For induction‐heated catalysts, the conversion rate of methane is limited by chemical reactivity, as opposed to the case of traditional externally heated reformers where heat transport limitations are the limiting factor. Catalyst production by the synthetic route allows controlled doping with miniscule concentrations of auxiliary metals.     

CeO_2改性Cu/Zn-Al水滑石衍生催化剂对甲醇水蒸气重整制氢性能的影响

采用原位合成法在γ-Al2O3表面合成了锌铝水滑石,再采用顺次浸渍法制备了Ce/Cu/Zn-Al催化材料;将其应用于甲醇水蒸气重整制氢,探讨了Ce含量对Cu/Zn-Al催化剂催化性能的影响.催化剂表征结果表明,CeO_2的引入改善了活性组分铜的分散度、铜的比表面积以及催化剂的氧化还原性质,进而提高了催化剂的催化活性和产氢率.当Ce含量为4%时,催化剂活性最佳,在250℃时,甲醇转化率达到100%,CO摩尔分数为0.39%,与Cu/Zn-Al催化剂相比,甲醇转化率提高了近40%.     

水平井蒸汽辅助重力驱油藏模拟方法

研究了油藏与水平井段耦合的蒸汽辅助重力驱整体模拟的数学模型及其求解方法.将研制的沿水平井井筒方向有质量、能量损失的一维多相管流模块与油藏模拟主体软件集成,能预测水平井蒸汽辅助重力驱蒸汽腔室的大小及形状的动态变化.通过模拟计算分析了毛管力、蒸汽干度、地层深度等对蒸汽腔室发育程度的影响,并取得了结果.     

汽轮机调节阀内流动特性的试验研究

介绍了最常用的G-I型调节阀内的动态压力测量方法及其各关键部位的流动特性,尤其是引起不稳定流动的主要因素即气流的压力脉动特性。测试结果表明,调节阀处于不稳定工作状态即阀杆振动工况取决于脉动压力与阀杆固频率是否同频,并非其脉动压力值大小;调整阀杆固有频率是消除调节阀振动最简便和有效的方法。     

The Fate of [15N]Ammonium and [15N]Nitrate in the Soil of a 140-Year-Old Spruce Stand (Picea Abies) in the Fichtelgebirge (NE-Bavaria)

Abstract

A ¹⁵N tracer-experiment was carried out in a 140-year-old spruce stand (Picea abies (L.) Karst.) in the Fichtelgebirge (NE-Bavaria, Germany). Highly enriched (98 at%) [¹⁵N]ammonium and [¹⁵N]nitrate were applied as tracers by simulation of a deposition of 41.3 mol N ha^?1 with 11 water m^?2. To examine seasonal variations of uptake by spruce and understorey vegetation, different plots were labelled in spring, summer and autumn 1994.

One aim of the present study was to perfect a method of preparation of soil extracts for isotope ratio mass spectrometry (IRMS) measurements. Ammonium and nitrate from soil extracts were prepared for IRMS measurements by steam distillation and subsequent freeze drying. Additionally, tracer distribution and transformations in the soil nitrogen pools were examined. Ammonium, nitrate and total nitrogen were examined in the organic layer and the upper 10 cm of the mineral soil during 3 months after the first tracer application in spring 1994.

In July 1994, three months after tracer application, 40% of the [¹⁵N]ammonium label and 29% of the [¹⁵N]nitrate label, respectively, were recovered in the total N pool of the investigated soil horizons. In the organic layer the L/Of horizon retained most of the recovered tracers. Nitrification, immobilisation and mineralisation occurred even under the conditions of high soil acidity at the study site.