大功率高温超导滤波器的设计与功率测试

本文在双面YBCO高温超导薄膜上设计并制备了两节大功率超导滤波器,根据滤波器功率承载能力与最大电流密度之间的关系,减小电流密度和分散电流密度的分布是提高功率承载能力的关键.本文采用增加超导谐振器尺寸、优化几何结构及改进馈线耦合方式的方法,设计了两节2 GHz频段梭型谐振器结构的滤波器.设计及测量结果显示了馈线结构及谐振器几何尺寸优化程度对超导滤波器功率承载能力有不同程度的影响,说明了在大功率超导滤波器设计中应选用无结点间隙耦合式馈线以抑制电流密度的聚集.采用优化后的谐振器结构制备的梭型两节超导滤波器经测试功率承载能力为2 W.超导滤波器的尺寸为25×12 mm LaAlO3基片,中心频率2.022 GHz,相对带宽为2.4%.同时给出了超导滤波器功率测试的结构和方法.     

SQUID用于铍材残余应力检测的计算机模拟

依据SMM-601型超导量子干涉显微镜检测部分构建计算模型,采用电磁场有限元方法分析了残余应力引起的非磁性金属材料铍电导率变化对超导量子干涉仪(SQUID)检测信号的影响,并讨论了该方法实际应用于非磁性金属材料残余应力检测的条件和可能性。     

超导故障限流器的研究现状及其应用

超导故障限流器(Superconducting Fault Current Limiter,SFCL)是利用超导体的基本特性,有效限制电力系统故障短路电流,提高电网安全性和稳定性的一种新型电力设备。文中在综合大量文献的基础上,对超导故障限流器进行了一种较为系统的分类。基于该种分类,结合目前国内外的研究现状,就电阻型、磁屏蔽型、饱和铁芯电抗器型、桥路型SFCL的工作原理作了详细的分析介绍,还给出了它们在电力系统中的安装位置。最后,对超导故障限流器的研究中存在的问题及其发展趋势做了说明。     

导出圆电流的磁感应强度的简便方法

避开繁琐的椭圆积分推导,用微积分导出了圆电流在空间各点的磁感应强度的定积分公式,再变换成用椭圆积分表示的精确解.     

一个关于勒让德多项式的积分公式及其简单应用——圆形带电环和电流环的静态电磁势

给出了一个关于勒让德多项式的积分公式及其证明,用该公式和叠加法方便快捷地导出了圆形带电环和电流环的静态电磁势.     

GaN发光二极管表观电容极值分析

利用正向交流(ac)小信号方法对GaN发光二极管的电容-电压特性进行测量,可以观察到GaN发光二极管中的负电容现象。正向偏压越大,测试频率越低,负电容现象越明显。测量到的负电容现象是表象,不存在负电容;提出GaN发光二极管p-n结的结电容在特定的正向电压范围内等效于可变电容。分析可变电容对正向交流小信号响应得到:特定参数的可变电容使结电容电流相位落后于交流小信号电压相位π/2,使得在测量中表现为负电容。发现表观电容-正向电压曲线的极值点与理论模型相吻合,证明了该理论模型的正确性。     

胆酸钠与支撑磷脂双层膜作用的电化学研究

采用电化学方法研究胆酸钠(NaC)与s-BLM的相互作用, 并结合实验结果对NaC与s-BLM的作用机理进行了讨论.     

Product Inhibited Enzymatic Reactions on the Rotating Disk Electrodes

A model of cyclic staircase voltammetry of enzymatic reactions on the rotating disk electrode is developed and the inhibition by the product is investigated. The responses are mostly time – dependent current – potential curves with maxima in the forward but not in the backward branch. If the maxima appear in both branches, the inhibition is potential – dependent either directly or indirectly. The source of the second maximum is explained.     

伏安特性实验中电压表的改进应用

改进了传统电压表的面板设计,使电压表不仅能测两端的电压,还能测量自身的电流.于是在测量元件的伏安特性实验中,使用该电压表可以不考虑被测器件电阻的大小,均采用电流表外接的接线方式,即让电压表分流.再利用电压表的电流测量功能,测出自身分流电流的大小,从而可以准确得出被测器件的电流与两端的电压.     

The atomization current and droplet size of ethanol in two different small-scale electro-spraying systems

An experimental study on electro-spraying from small-scale combustors is carried out using liquid ethanol as fuel. Two systems of electro-spraying are employed in the present study; one is a nozzle system (without a ring electrode) and the other is a nozzle-ring system (with a ring electrode). The photos of electro-spraying at the cone-jet mode are taken by a digital camera. The voltage drop across the resistance in the loop is measured by a data acquisition instrument, and the atomization current is calculated according to Ohm's Law. The size and velocity of electro-spraying droplets are measured by a Phase Doppler Anemometer. A non-dimensional analysis on atomization current is completed to explain the electro-spraying phenomena of liquid at the stable cone-jet mode. The results show that, the lower atomization current and droplet velocity corresponds to smaller size of droplet. Based on the results of non-dimensional analysis, it is found that the dimensionless atomization current in both the nozzle system and nozzle-ring system obeys the scaling law as square root of the dimensionless flow rate. The charge density is of a −1.5 power dependence on droplet diameter. Both of the nozzle and the nozzle-ring systems show a good agreement with Rayleigh instability.