Trace 1300气相色谱仪故障排查与期间核查

使用赛默飞Trace 1300气相色谱仪进行环境样品分析过程中,出现了FID信号变弱、点火困难的现象,严重影响检测数据的准确性,干扰正常分析工作。从样品性质、仪器方法的设置、气路系统以及检测系统进行故障排查,确定故障原因为FID喷嘴堵塞,点火线圈锈蚀严重。对维修好后的气相色谱仪进行期间核查,核查结果:基线噪声为0.066 pA,基线漂移(30 min)为0.321 pA,FID检测限为0.094 1 ng/s,定性重复性为0.062%,定量重复性为1.41%,均满足技术指标要求。     

火焰原子吸收光谱法测定粗锌中的铜

建立火焰原子吸收光谱法测定粗锌中的铜含量。采用硝酸–酒石酸溶解样品,并以其为测定溶液介质,检测波长为324.7 nm,以水为参比,采用空气–乙炔火焰以原子吸收光谱仪进行测定。在优化的实验条件下,铜的质量浓度在0.10~2.50μg/m L范围内与吸光度有良好线性关系,相关系数为0.999 7,方法检出限为0.01μg/m L。测定结果的相对标准偏差为1.0%~3.0%(n=11),样品加标回收率为97%~102%。该方法具有灵敏度高,干扰少,重现性好等优点,适用于铜含量在0.001%~0.50%之间的粗锌中铜的测定。     

Switchable solvent based liquid phase microextraction of palladium coupled with determination by flame atomic absorption spectrometry

A switchable solvent-based micro-extraction method for pre-concentration and separation of ultratrace palladium was developed prior to its flame atomic absorption spectrometric detection. Reverse change of hydrophilicity of N,N-dimethylcyclohexylamine (DMA) was achieved by reaction with carbonated water. The hydrophilic bicarbonate salt of the protonated DMA was used as extractant for palladium complexed with 2-(5-bromo-2-pyridylazo)-5-diethylaminophenol (5-Br-PADAP). Formation of the hydrophobic form of switchable solvent from hydrophilic form of switchable solvent phase was achieved by addition of sodium hydroxide into the extractant-sample solution. The effect of key parameters affected extraction recovery was studied and optimised by using Plackett–Burman design, central composite design and three dimension (3D) surfaces response. The calibration plot was linear in the range 0.015–1.6 mg L^?1 of palladium with a correlation coefficient of 0.999. The limit of detections values of palladium for liquid and solid samples were 4.28 μg L^?1 and 0.54 µg g^?1, respectively. The pre-concentration factor was 37.5. The accuracy was confirmed by determination of palladium in certified reference material. The procedure was also applied for determination of palladium content of real samples as automotive catalytic converter, roadside dust, sea water and river water.     

Three‐body expansion of the fragment molecular orbital method combined with density‐functional tight‐binding

The three‐body fragment molecular orbital (FMO3) method is formulated for density‐functional tight‐binding (DFTB). The energy, analytic gradient, and Hessian are derived in the gas phase, and the energy and analytic gradient are also derived for polarizable continuum model. The accuracy of FMO3‐DFTB is evaluated for five proteins, sodium cation in explicit solvent, and three isomers of polyalanine. It is shown that FMO3‐DFTB is considerably more accurate than FMO2‐DFTB. Molecular dynamics simulations for sodium cation in water are performed for 100 ps, yielding radial distribution functions and coordination numbers. © 2017 Wiley Periodicals, Inc.     

New algorithm for tensor contractions on multi‐core CPUs,GPUs, and accelerators enables CCSD and EOM‐CCSD calculations with over 1000 basis functions on a single compute node

A new hardware‐agnostic contraction algorithm for tensors of arbitrary symmetry and sparsity is presented. The algorithm is implemented as a stand‐alone open‐source code libxm . This code is also integrated with general tensor library libtensor and with the Q‐Chem quantum‐chemistry package. An overview of the algorithm, its implementation, and benchmarks are presented. Similarly to other tensor software, the algorithm exploits efficient matrix multiplication libraries and assumes that tensors are stored in a block‐tensor form. The distinguishing features of the algorithm are: (i) efficient repackaging of the individual blocks into large matrices and back, which affords efficient graphics processing unit (GPU)‐enabled calculations without modifications of higher‐level codes; (ii) fully asynchronous data transfer between disk storage and fast memory. The algorithm enables canonical all‐electron coupled‐cluster and equation‐of‐motion coupled‐cluster calculations with single and double substitutions (CCSD and EOM‐CCSD) with over 1000 basis functions on a single quad‐GPU machine. We show that the algorithm exhibits predicted theoretical scaling for canonical CCSD calculations, O (N ⁶), irrespective of the data size on disk. © 2017 Wiley Periodicals, Inc.     

APCI as an innovative ionization mode compared with EI and CI for the analysis of a large range of organophosphate esters using GC‐MS/MS

Organophosphate esters (OPEs) are chemical compounds incorporated into materials as flame‐proof and/or plasticizing agents. In this work, 13 non‐halogenated and 5 halogenated OPEs were studied. Their mass spectra were interpreted and compared in terms of fragmentation patterns and dominant ions via various ionization techniques [electron ionization (EI) and chemical ionization (CI) under vacuum and corona discharge atmospheric pressure chemical ionization (APCI)] on gas chromatography coupled to mass spectrometry (GC‐MS). The novelty of this paper relies on the investigation of APCI technique for the analysis of OPEs via favored protonation mechanism, where the mass spectra were mostly dominated by the quasi‐molecular ion [M + H]⁺. The EI mass spectra were dominated by ions such as [H₄PO₄]⁺, [M–R]⁺, [M–Cl]⁺, and [M–Br]⁺, and for some non‐halogenated aryl OPEs, [M]^+● was also observed. The CI mass spectra in positive mode were dominated by [M + H]⁺ and sometimes by [M–R]⁺, while in negative mode, [M–R]⁻ and more particularly [X]^‐ and [X₂]^‐● were mainly observed for the halogenated OPEs. Both EI and APCI techniques showed promising results for further development of instrumental method operating in selective reaction monitoring mode. Instrumental detection limits by using APCI mode were 2.5 to 25 times lower than using EI mode for the non‐brominated OPEs, while they were determined at 50‐100 times lower by the APCI mode than by the EI mode, for the two brominated OPEs. The method was applied to fish samples, and monitored transitions by using APCI mode showed higher specificity but lower stability compared with EI mode. The sensitivity in terms of signal‐to‐noise ratio varying from one compound to another. Copyright © 2016 John Wiley & Sons, Ltd.     

Novel flame retardant paint based on Co(II) and Ni(II) metal complexes as new additives for surface coating applications

The study is focused on the synthesis of a new Co(II) and Ni(II) metal complexes, which is synthesized by the reaction of the isatin 4‐aminoantipyrine Schiff base ligand with selected divalent Co(II) and Ni(II) ions and their possible applications as flame retardant additives in paint formulations for surface coating application. The prepared metal complexes were characterized using a combination of Fourier transform infrared, elemental analysis, proton nuclear magnetic resonance, ¹³C‐NMR spectra, and mass spectroscopy. The prepared Schiff base ligand metal complexes were physically added to alkyd paint formulation to give coating formulations at a laboratory scale and then applied onto plywood and steel panels using a brush. The ignitability and oxygen index values obtained indicated that the paint which contained the prepared Co(II) and Ni(II) metal complexes as additives exhibited very good flame retardant. The physical and mechanical characteristics of the coatings were studied in order to estimate any disadvantages due to the incorporation of the additives. It was discovered that the added substances did not impact the hardness, flexibility, and adhesion of the prepared coating films. The gloss of the paint formulation film was improved due to the incorporation of the aromatic ring into the formulation and the level of the oil percent.     

碱消解-火焰原子吸收光谱法测定土壤中六价铬

建立了碱消解-火焰原子吸收光谱法测定土壤中六价铬的方法.讨论了pH值对六价铬测定的影响.干扰实验的结果表明同等含量的三价铬对六价铬测定无干扰.实验对比了无背景校正、氘灯背景校正、塞曼背景校正三种工作方式,分别对低、中、高三个水平土壤六价铬标准物质进行了测定,结果表明,低含量的土壤样品用塞曼背景校正方式测定的结果更准确,...     

Analysis of DNA methylation markers for tissue identification in individuals with different clinical phenotypes

Deoxyribonucleic acid (DNA) methylation patterns can be used to identify the type of tissue or body fluid found at a crime scene. However, tissue-related methylation levels have not been analyzed in individuals with different illnesses and medical conditions in forensic-specific studies. The primary goal of this study was to investigate if certain clinical phenotypes can alter the methylation levels of CpG sites in genes involved in tissue typing. Four studies with focus on DNA methylation analysis on individuals with different clinical conditions were selected from the Gene Expression Omnibus database. Then, a list of 137 CpG sites was compiled for further investigation. Statistical tests were performed to compare the beta-values results obtained for the control groups and the individuals affected by medical conditions. For each study, CpG sites that presented significant statistical differences between patients and control group were identified and it was possible to notice that DNA methylation levels can be affected in sites with potential forensic use. Although the observed DNA methylation variation (less than 10% difference) in this study would likely not cause any issues in body fluid identification, the results are important to show that this type of analysis should be taken into consideration when investigating and further validating body fluid markers. The CpG sites identified in this study should be further investigated by future studies on body fluids identification, and due to the significant difference in methylation levels in samples from affected individuals, caution must be taken before including these sites in tissue identification investigations.     

四溴双酚A锑铝双金属化合物的合成及其阻燃性能

以四溴双酚Ａ（ＴＢＡ）合成了在水和空气中稳定的四溴双酚Ａ合锑铝双金属化合物（ＴＢＡＳＡ）．通过ＩＲ、１ＨＮＭＲ和元素分析予以表征，并研究了其对聚乙烯（ＰＥ）和聚环氧乙烷（ＰＥＯ）的阻燃性能．结果表明，这种分子中含有溴、锑和铝的化合物，对聚乙烯和聚环氧乙烷等高聚物材料有高的阻燃性能与消烟效果．