Manipulating the surface properties of polyacrylamide with nitrogen plasma

Polyacrylamide (PAL) was physically adsorbed onto a hydroxylated silicon surface to form a uniform PAL film and the up-top PAL thin film was treated by nitrogen (N₂) plasma for surface modification. The atomic composition of the modified surface of the PAL film adsorbed on silicon substrate was analyzed with Fourier Transform Infrared Spectroscopy (FTIR) and X-ray photoelectron spectroscopy (XPS). The surface energy of PAL film was calculated from the data of contact angle of three-probe liquid. The FTIR results show an increase of peak intensity at 1214 cm⁻¹ (NH₂ stretch vibration) after the nitrogen plasma treatment, which confirms that the nitrogen was grafted to the PAL surface in the process of N₂-plasma treatment. The XPS results show that the ratio of relative intensity of N1s to O1s increases with increasing the plasma treatment time, which further affirms the formation of the amine groups on the PAL surface after the nitrogen plasma treatment. The surface tension increases with increasing the plasma grafting time. However, the surface energy decreases rapidly at the early stage when stored in air and approaches to an equilibrium value. It suggests that some physically-adsorbed ions and alkyl radicals on PAL surface can rapidly lose their activities. The increase of the surface tension of the plasma treated PLA films is due to the amine groups covalently grafted to PAL surface.     

The Mutual Conversion of CO2 and CO in Dielectric Barrier Discharge (DBD)

Non-equilibrium plasma, which was engendered by dielectric barrier discharge (DBD) was used to analyze the mutual conversion between CO₂ and CO. The results showed that the conversion ratio of CO increased monotonously with the increasing voltage. But CO₂ was not so. Its conversion ratio reached maximum when the voltage was 3600 V in Ar system. It also showed that the existence of water molecules was more advanageous for the conversion of CO to CO₂ in Air system than in oxygen system, and the conversion ratio could reach 75.8% when the relative humidity was 100%. We also discussed the energy yield and energy efficiency, and the result was that high voltage and high concentration of reactant was disadvantageous for energy utilization.     

Chemical maps of patterned samples by microline‐imaging laser‐induced plasma spectrometry

The potential of a microline‐imaging laser‐induced plasma spectrometry (LIPS) system for surface and depth analysis of heterogeneous solid samples in air at atmospheric pressure has been demonstrated. A pulsed Nd : YAG laser beam operating at 532 nm, with a homogeneous energy distribution (flat top laser), was used to generate a microline plasma on the sample surface. Subsequent light from the microline plasma was resolved spectrally and spatially and detected with an imaging spectrograph and an intensified charged‐coupled device detector. A patterned metal sample was chosen as the most appropriate for this study. Three‐dimensional chemical maps of Ni and Cu from the edge connectors of a printed circuit board have been obtained. With this experimental configuration, the lateral resolution (limited by crater width) was 42 µm and the spatial resolution along the spectrometer slit was 17.4 µm. The results illustrate the capability of microline imaging for fast mapping of large‐area samples and for depth profiling purposes. Copyright © 2003 John Wiley & Sons, Ltd.     

The effect of low concentrations of a polyatomic gas in argon on erosion on copper cathodes in a magnetically rotated arc

Experimental results are presented for electrode erosion on copper cathodes in magnetically rotated arcs in argon, dry air, nitrogen, ammonia, and carbon monoxide as well mixtures of the above with argon. Water-saturated argon was also used. Erosion rates were determined by weight loss after chemical cleaning, and the runs were sufficiently long (between 5 to 60 min) to represent steady-state operation. Arc currents of 100 A and gas pressures of 1.1 atm. were used. Pure argon gave the highest erosion rates and the lowest arc velocities. Small concentrations of any of the diatomic gases in argon greatly increased the arc velocity and decreased the erosion rates. The results suggest that erosion is primarily a thermal phenomenon but that the surface chemistry can greatly influence erosion rates by modifying arc behavior.     

Simultaneous determination of chlorpheniramine and pseudoephedrine in human plasma by liquid chromatography-tandem mass spectrometry

A sensitive and specific procedure for simultaneous quantitation of chlorpheniramine and pseudoephedrine in human plasma has been developed and validated. Analytes were extracted from plasma samples by liquid-liquid extraction, separated on a Diamonsil C18 column (250 x 4.6 mm i.d.) and detected by tandem mass spectrometry with an atmospheric pressure chemical ionization interface. Diphenhydramine was used as the internal standard. The method has a lower limit of quantitation of 0.2 and 2.0 ng/mL for chlorpheniramine and pseudoephedrine, respectively. The intra- and inter-day relative standard deviation, calculated from quality control (QC) samples were below 4.3% for chlorpheniramine and below 9.5% for pseudoephedrine. The inter-day relative error as determined from QC samples was within 4.7% for each analyte. The overall extraction recoveries of chlorpheniramine and pseudoephedrine were 77 and 61% on average, respectively. The method was successfully applied to pharmaockinetic study of chlorpheniramine and pseudoephedrine in volunteers receiving formulations containing 4 mg of chlorpheniramine maleate and 60 mg of pseudoephedrine hydrochloride.     

Simultaneous determination of sulfamethoxazole and trimethoprim in human plasma by capillary zone electrophoresis

A capillary electrophoretic method for the simultaneous determination of sulfamethoxazole and trimethoprim in plasma was developed. Sulfamethoxazole and trimethoprim extracted from human plasma with ethyl acetate were analyzed at 20 kV and 25 degrees C using 15 mm phosphate buffer (pH 6.2) as the electrolyte. The detection was by UV at 220 nm. The run time was 8.0 min and the limit of quantification was 10.00 microg/mL for sulfamethoxazole and 2.00 microg/mL for trimethoprim. The recovery was >99% for both compounds. This method enabled the detection of sulfamethoxazole and trimethoprim in plasma of patients after oral ingestion of their combined formulation. The present simple and rapid method is applicable to drug monitoring in immunocompromised patients who are taking the combined formulation of these compounds for the treatment or prophylaxis of Pneumocystis carinii pneumonia.     

Direct targeting of human plasma for matrix-assisted laser desorption/ionization and analysis of plasma proteins by time of flight-mass spectrometry

A method to analyze human plasma proteins without fractionation, directly applying a plasma-matrix mixture on the target plate of a matrix-assisted laser desorption/ionization-time of flight-mass spectrometer (MALDI-TOF-MS), has been described. Peaks of ionized plasma proteins could not be detected applying a mixture of an undiluted plasma sample and a matrix solution, but they appeared when the plasma was diluted before mixing with the matrix. Tenfold diluted plasma provided well-resolved protein peaks in the m/z range from 4000 to 30,000. The addition of a simple post-crystallization washing procedure performed on the target plate further improved the quality of mass spectra. We numbered 58 peaks in the range of 4-160 kDa and 32 out of which were assigned to the plasma protein species which have been reported. Especially high sensitivity and resolution were obtained in the region < 30 kDa, where multiple isoforms of apolipoprotein A-I, apolipoprotein A-II, apolipoprotein C-I, apolipoprotein C-II, apolipoprotein C-III, and transthyretin could be assigned. Various post-translational modifications are involved in the isoforms, e.g., proteolytic cleavage, glycosylation and chemical modifications. This method will become complementary with the present electrophoretic techniques, especially for the analysis of low-molecular-mass proteins.     

Mass spectrometric diagnosis of the surface nitriding mechanism in a d.c. glow discharge

Reactive constituents have been investigated in a molecular beam generated in the cathode surface glow area and surface boundary layer. Mixtures of nitrogen and hydrogen form NH_x(x=0–4) compounds, which are of relevance in heterogeneous, plasma vs. metal nitriding reactions. Ammonia decomposition leads to NH_x(x=2–4). Strong cataphoretic enrichment of hydrogen has been observed in the cathode glow area. Heterogeneous reactions of NH_x with iron lead to the formation of iron nitrides via intermediates such as FeNH_2–3. In a pulsed d.c. glow discharge, increased sputtering and decreased hydrogen enrichment have been observed.     

LC Determination of Propylene Glycol in Human Plasma After Pre-Column Derivatization with Benzoyl Chloride

A simple high-performance liquid chromatographic method, using photodiode array detection was developed for the determination of propylene glycol in human plasma and in the fluid retreived after continuous veno-venous hemofiltration. The method entailed alkaline derivatization with benzoyl chloride and ethylene glycol as internal standard. The separation of the compounds, after extraction with pentane, was carried out on a Pursuit C8 column with UV-detection at 230 nm. Validation samples were analyzed with an accuracy between 95 and 105%, and intra- and inter-day coefficients of variation of less than 8%. The calibration curve was linear over a concentration range of 5–100 mg L⁻¹ with a detection limit of 1 mg L⁻¹. Blood plasma samples of several patients were analysed by using the prescribed method with propylene glycol concentrations varying from 5 to 98 mg L⁻¹. Compared to previously described LC methods, this method is ten times more sensitive and thus suitable for use in pharmacokinetic studies of propylene glycol.     

LC–MS Determination and Pharmacokinetic Study of a Novel Sulfonylurea: Potential Hypoglycemic Agent in Rat Plasma

To support preclinical pharmacokinetic investigation of 1-[4-[2-(4-bromobenzene-sulfonaminoethyl)phenylsufonyl]-3-(trans-4-methylcyclohexyl)urea (G004), a rapid, sensitive and specific high-performance liquid chromatography–electrospray ionization mass spectrometry (LC–ESI-MS) method was developed and validated. Glibenclamide was employed as internal standard. After liquid–liquid extraction the analyte was analyzed on a Kromasil C₁₈ column (150 × 2.0 mm i.d.) with a mobile phase consisted of acetonitrile–water (0.05% acetic acid), 30:70 (v/v). The flow rate was 0.2 mL min⁻¹. Detection was performed on a quadrupole mass spectrometer using an electrospray ionization interface and the selected-ion monitoring (SIM) mode. The retention time was about 3.5 and 4.2 min for Glibenclamide and G004, respectively. The assay was linear over the concentration range of 2.0–500.0 ng mL⁻¹. Extraction Recovery of G004 in rat plasma was more than 87%. The intra- and inter-assay precision was lower than 11.5% (CV). This validated method was successfully applied to the pharmacokinetics of G004 in rats.