电感耦合等离子体质谱法测定无尘产品中痕量氯

研究了利用电感耦合等离子体质谱仪测定无尘产品中的痕量杂质元素氯含量的方法,检测下限0.06 ng/mL,精密度RSD<5%(n=7),回收率93.7%~110.0%。     

Numerical study on soot removal in partial oxidation of methane to syngas reactors

The serious carbon deposition existing in catalytic partial oxidation of methane (CPOM) to syngas process is one of the key problems that impede its industrialization. In this study, 3-dimensional unsteady numerical simulations of the soot formation and oxidation in oxidation section in a heat coupling reactor were carried out by computational fluid dynamics (CFD) approach incorporating the Moss-Brookes model for soot formation. The model has been validated and proven to be in good agreement with experiment results. Effects of nozzle type, nozzle convergence angle, channel spacing, number of channels, radius/height ratio, oxygen/carbon ratio, preheat temperature and additional introduction of steam on the soot formation were simulated. Results show that the soot formation in oxidation section of the heat coupling reactor depends on both nozzle structures and operation conditions, and the soot concentration can be greatly reduced by optimization with the maximum mass fraction of soot inside the oxidation reactor from 2.28% to 0.0501%, and so that the soot mass fraction at the exit reduces from 0.74% to 0.03%.     

Production of carbon soot with a high content of C60 and C70 fullerenes by electric arc

The effect of the parameters of the electric arc (helium pressure, current and voltage, clearance between electrodes) and of the peculiarities of the setup design (arrangement of electrodes, distance between the arc and the cooling surface, temperature of the soot condensation surface) on the yield of fullerenes has been studied. Conditions for producing soot with a C₆₀ and C₇₀ content up to 43% (toluene extract) have been found.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 805–809, May, 1994.The authors are grateful to N. G. Spitsyna and A. V. Dubovitskii for the determination of the content of C₆₀ and C₇₀ fullerenes in the extract.The work was financially supported by the Russian Foundation for Basic Research (Project 93-03-18705).     

The study of electron beam flue gas treatment for coal-fired thermal plant in Japan

The fundamental research work with simulated coal-fired flue gas was performed in JAERI to get basic data for electron beam treatment of flue gas from thermal power plants in Japan. The standard condition of the experiments was set to be the same as that of next large scale pilot test in Nagoya. The concentrations of NO_x and SO_x were 225 ppm and 800 ppm, respectively. The temperature of the system was 65°C. The effect of multiple irradiation was observed for NO_x removal. The target SO_x and NO_x removals (94% and 80%, respectively) with low NH₃ leakage (less than 10 ppm) were achieved at 9 kGy irradiation with 0.9 NH₃ stoichiometry during 7 hours continuous operation. The facility for the pilot plant (12,000 Nm³/hr) has just built at the site of Shin-Nagoya power plant of Chubu Electric Power Company and will be started in full operation in November 1992.     

The superhydrophobicity of polymer surfaces: Recent developments

Superhydrophobicity is the extreme water repellence of highly textured surfaces. The field of superhydrophobicity research has reached a stage where huge numbers of candidate treatments have been proposed and jumps have been made in theoretically describing them. There now seems to be a move to more practical concerns and to considering the demands of individual applications instead of more general cases. With these developments, polymeric surfaces with their huge variety of properties have come to the fore and are fast becoming the material of choice for designing, developing, and producing superhydrophobic surfaces. © 2011 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 49: 1203–1217, 2011     

Direct monitoring of drug degradation by easy ambient sonic-spray ionization mass spectrometry: the case of enalapril

Using enalapril maleate as a test case, the ability of ambient mass spectrometry, namely, via easy ambient sonic‐spray ionization mass spectrometry (EASI‐MS), to perform direct monitoring of drug degradation has been tested. Two manufacturing processes were investigated (direct compression and wet granulation), and the formation of degradation products was measured via both EASI‐MS and high‐performance liquid chromatography with ultraviolet detection for a total period of 18 months. Both techniques provide comparable results, which indicate that direct analysis by ambient mass spectrometric techniques presents a viable alternative for drug degradation monitoring with superior simplicity, throughput, and reliability (no sample manipulation), and comparable quantitative results. In terms of qualitative monitoring, the full mass spectra with intact species provided by EASI‐MS allow for comprehensive monitoring of known and unknown (or unexpected) degradation products. Copyright © 2011 John Wiley & Sons, Ltd.     

MnO_x-CeO_2上表面氧性质及其催化碳烟燃烧性能

运用TPO,XRD,BET,O2-TPD,H2-TPR,XPS等技术,研究了在CeO2中引入不同Mn含量对催化剂表面氧性质的影响,并重点探讨了吸附于氧空位上的原子吸附氧O-与催化碳烟燃烧活性的关联。结果表明:将Mn中引入CeO2后,MnOx-CeO2晶格中可形成较CeO2更多的氧空位,并有利于氧的活化和迁移,生成了较多原子吸附氧O-;MnOx(0.4)-CeO2在碳烟起燃温度区间有最多的原子吸附氧O-,其碳烟起燃活性最高,对应的起燃温度是346℃,比无催化剂时降低了111℃,比CeO2降低了35℃。     

Characterization of the materials used in Chinese ink sticks by pyrolysis-gas chromatography–mass spectrometry

Chinese ink stick has a long history and a special importance in Chinese culture. Its main components are soot (normally pine wood soot and lamp soot) and animal glue; however, additives were added from time to time for different purposes. In order to see whether the two types of soot can be differentiated and the other constituents in Chinese ink sticks can be identified or not by Pyrolysis-Gas Chromatography-Mass Spectrometry (Py-GC-MS) and GC-MS techniques, an initial study has been carried out. The main polycyclic aromatic hydrocarbons (PAHs) in soot could be identified, which are anthracene, fluoranthene, triphenylene and benz[e]acephenanthrylene. The main difference between those two types of soot is that the detectable amount of PAHs in lamp soot is much lower than in pine wood soot. In addition to this, the relative concentration of the main polycyclic aromatic hydrocarbons including anthracene, fluoranthene, pyrene, triphenylene and its isomer, benzo[k]fluoranthene and its isomers are different in the two types of soot. The relative content of benzo[k]fluoranthene is higher in pine soot than in lamp soot, which could be used to as a criterion to differentiate the two types of soot. Py-GC-MS technique is a very effective method to identify the main components of Chinese ink sticks, including the PAHs of soot, binding media and the additives of camphor and borneol in one analysis.     

Desorption/ionization efficiencies of triacylglycerols and phospholipids via EASI‐MS

Knowledge of the major effects governing desorption/ionization efficiency is required for the development and application of ambient mass spectrometry. Although all triacylglycerols (TAG) have the same favorable protonation and cationization sites, their desorption/ionization efficiencies can vary dramatically during easy ambient sonic‐spray ionization because of structural differences in the carbon chain. To quantify this somewhat surprising and drastic effect, we have performed a systematic investigation of desorption/ionization efficiencies as a function of unsaturation and length for TAG as well as for diacylglycerols, monoacylglycerols and several phospholipids (PL). Affinities for Na⁺ as a function of unsaturation level have also been assayed via comprehensive metadynamics calculations to understand the influence of this phenomenon on the ionization efficiency. The results suggest that dipole–dipole interactions within a carbon chain tuned by unsaturation sites govern ionization efficiency of TAG and PL. Copyright © 2014 John Wiley & Sons, Ltd.