WIDE RANGE DETECTOR USING PARABOLIC CYLINDRICAL MIRROR FOR THz APPLICATIONS

A new, wide-band, high-speed and high-sensitivity THz detector has been developed. The prototype detector consists of a parabolic cylindrical mirror, a long wire antenna and a Schottky barrier diode. Direct detection measurements have shown a stable sensitivity of 150 ± 50 V/W for 1–2 THz without any adjustments. The long wire antenna was fixed at the focus of parabolic cylindrical mirror then it has been realized less operation steps, easy coupling to the external THz signals and a dramatic enhancement in the practicality of this system. The optically polished mirror and frosted surface one showed comparable sensitivities, thus easy polishing and less cost mirror fabrication can be applied for this system. The radiation pattern showed a maximum radiation angle of approximately 23° with its dominant main lobe, which was attributed to the wire antenna character and confirmed good agreements with classical antenna theory.     

利用KTP晶体实现1.08μmNd：YAP激光器锁模

本文描述了利用ＫＴＰ晶体和腔的基波输出镜构成非线性镜实现１．０８μｍＮｄ：ＹＡＰ激光器的被动锁模。实验表明，这种新的锁模技术比用染料作可饱和吸收体的被动锁模技术有很多突出的优点，具有很大的发展潜力。实验测得锁模时基波１．０８μｍ输出２．４ｍＪ，二次谐波０．５４μｍ输出０．５ｍＪ（同样条件下的静态输出为２．５ｍＪ），基波脉冲的平均脉宽为４０ｐｓ。     

Analytical Designing of Two-Aspherical-Mirror Anastigmats Permitting Practical Misalignments in a Soft-X-Ray Optics

A new analytical method of designing two-aspherical-mirror anastigmats was developed and applied to searching solution groups of soft X-ray microscopes of a large misalignment tolerance. The two-mirror anastigmat configurations were expressed by a practical variable related to pupil obstruction limiting the system throughput. Axial coma and other aberrations caused by a slight decenter of the system were then formulated to represent sensitivity to misalignment. These formulations enabled a global survey of solution groups as demonstrated by a designing example of soft X-ray microscopes with a magnification m = −1/50, which resulted in four solutions more insensitive to misalignment than a standard Schwarzschild optics in the soft X-ray region. Some solutions were also found to have much larger fields of view suitable for high resolution imaging as confirmed by computer ray tracing.     

陡前沿脉冲产生的受激布里渊散射稳定性研究

受激布里渊散射转换效率及相位共轭保真度的稳定性与泵浦脉冲的前沿上升时间有关，对前沿上升时间与介质声学声子寿命接近的泵浦脉冲，在泵浦能量超过受激布里渊散射阈值较多时，会造成严重的相位共轭保真度不稳定。本文针对上升前沿时间为２ｎｓ的泵浦脉冲及声学声子寿命的１ｎｓ和ＣＣｌ４介质，在泵浦脉冲前沿根部引入缓慢上升的小信号后，采用振放双池受激布里渊散射相位共轭镜，在泵浦激光能量达到５００倍受激布里渊散射阈值时     

超高真空中银表面垂直谐波电流的实验测量

在超高真空的条件下,测量了清洁、自由银表面产生的光学二次谐波随基波电矢量与入射面之间夹角(?)的变化,从而通过理论公式,求得由Rudnick和Stern引入的,用于衡量垂直面电流密度的唯象参数a的值,在入射基频光波长为1.064μm时,被测定为-4.0±0.8.     

不同沉淀剂制备的Ag／TS－1催化丙烯直接气相氧化合成环氧丙烷

 在423K、常压固定床石英反应器中，以丙烯直接气相氧化为探针反应，考察了催化剂制备方法、沉淀剂的种类和浓度对制备的Ag／TS－1催化剂催化性能的影响，采用TEM，XRD和UV－Vis等表征手段对Ag／TS－1催化剂进行了分析．结果表明，沉积－沉淀法是最佳的催化剂制备方法，但浸渍法也可制得具有环氧丙烷选择性的催化剂．K2CO3是一种良好的沉淀剂．以K2CO3为沉淀剂，硅钛比为64的TS－1为载体制备的Ag／TS－1催化剂上的丙烯转化率为1．72％，环氧丙烷选择性为98．2％．少量单质银的存在有利于环氧丙烷的生成，除银粒子的分散状态外，银粒子与载体TS－1间的相互作用对提高催化剂的选择性具有决定性作用．     

Preparation of Nanoelectrode Ensembles by Assembly of Nano—Silver Colloid on Gold Surface

A novel method for preparing silver nanoelectrode ensembles(SNEEs) and gold nanoelectrode ensembles (GNEEs) has been developed. Silver colloid particles were first absorbed to the gold electrode surface to form a monolayer silver colloid. N-hexadecyl nercaptan was then assembled on the electrode to form a thoil monolayer on which hydrophilic ions cannot be transfered. The SNEEs was prepared by removing thiol from silver colloid surface through applying and AC voltage with increasing frequency at 0.20V(vs.SCE). Finally,GNEEs was obtained by immersing a SNEEs into 6 mol/L HNO3 to remove the silver colloid particles. By comparison with other methods such as template method ect., this method enjoys some advantages of lower resistance, same diameter,easy preparation,controllable size and density.     

Influence of Temperature and Time on the Stability of Silver in Silica Sol-Gel Glasses

The darkening of silica sol-gel glasses doped with 0.05 mol% silver was studied. Six sols were prepared from TEOS and silver nitrate. Different additives were used, to influence the chemical and physical states of silver: oxidizing or reducing agents (H₂O₂, As₂O₅), colloid stabilizer (sodium citrate) and network modifiers (Li₂O, CaO). Sols were gelified at 60°C and densified at 600°C. The samples without additives and those prepared with H₂O₂ at room temperature even if they were protected from light. With increased temperature, the darkening became samples were heated above, 400°C, reversible bleaching took place. This darkening-bleaching is of thermal nature (“thermochromic effect”) and seems to be determined by a reversible aggregation-disaggregation of tiny silver particles. The presence of sodium citrate, as an additive delayed the darkening effect and the presence of CaO delayed it even further. Lithium oxide inhibited it totally.