磷酸盐激光玻璃聚(CH3)2SiO/SiO2防潮膜改性研究

采用溶胶-凝胶方法制备的(CH3)2Si(OC2H5)2预聚体涂膜液中,掺入碱催化的SiO2悬胶体涂膜液,采用旋涂法在掺钕磷酸盐激光玻璃棒端面涂制了改性的防潮膜。当涂膜液中(CH3)2Si(OC2H5)2和SiO2物质的量之比为1∶1时,热处理后的膜层耐摩擦性能明显改善;表面粗糙度的均方根值为1.245 nm;膜层激光破坏阈值大于15 J/cm2(1 053 nm,1 ns);在80 ℃和95%RH的封闭环境中静置336 h,膜层的透过率、接触角基本不变。结果证明膜层具有稳定的疏水结构和很好的防潮性能,膜层强度增加,耐磨擦能力提高,膜层使用期延长。     

某工程地基基坑支护探讨

软土地基中的支护是基础工程的关键,在节约成本的前提下,选择合理的支护结构至关重要．通过对某公司将要开发的2个基坑支护方案的项目进行的相关分析、计算和探讨,总结出了软土地基中的基坑支护方案的选择原则及其相对应的施工措施等．     

Synthesis,Characterization and Application of Amine-Functionalized Hierarchically Micro-Mesoporous Silicon Composites for CO2 Capture in Flue Gas

An efficient CO₂ adsorbent with a hierarchically micro-mesoporous structure and a large number of amine groups was fabricated by a two-step synthesis technique. Its structural properties, surface groups, thermal stability and CO₂ adsorption performance were fully investigated. The analysis results show that the prepared CO₂ adsorbent has a specific hierarchically micro-mesoporous structure and highly uniformly dispersed amine groups that are favorable for the adsorption of CO₂. At the same time, the CO₂ adsorption capacity of the prepared adsorbent can reach a maximum of 3.32 mmol-CO₂/g-adsorbent in the actual flue gas temperature range of 303–343 K. In addition, the kinetic analysis results indicate that both the adsorption process and the desorption process have rapid adsorption/desorption rates. Finally, the fitting of the CO₂ adsorption/desorption experimental data by Avrami’s fractional kinetic model shows that the CO₂ adsorption rate is mainly controlled by the intra-particle diffusion rate, and the temperature has little effect on the adsorption rate.     

Nevanlinna and Carleson functions of analytic self‐maps on multiply‐connected domains

In the paper we prove that the Nevanlinna counting function and the Carleson function of analytic self‐maps of finitely connected domains with smooth boundary are equivalent. Using this result we obtain the characterization of compact composition operators on Hardy–Orlicz spaces.     

用电磁打点计时器进行受迫振动实验--介绍我校的一个自学物理实验

介绍一种用简单的方法进行的受迫振动实验。     

硅探测器的数字化脉冲形状甄别

介绍了利用硅探测器的脉冲形状甄别进行粒子鉴别的原理。详细叙述了基于数字化方法的脉冲形状甄别的实现。采样频率和位数是数字化方法的两个重要参数。对于硅探测器信号,采用100 MS/s,12 bit的Digitizer可以满足脉冲形状甄别法对时间分辨的要求。同时对该方法粒子鉴别的特征和能量阈值做了简要的分析和对比。粒子背面入射硅探测器的所得的阈值低于正面入射的情况。例如对于氖周围的同位素,背面入射情况的阈值约为100 MeV,为正面入射情况下鉴别阈值的二分之一,相当与ΔE-E方法中ΔE探测器厚度约为60 μm情况下的阈值。最后定性讨论了硅探测器的电阻率不均匀性和沟道效应对粒子鉴别性能的影响。In this paper Pulse Shape Discrimination(PSD) for silicon detector has been briefly introduced. The emerging digital method successfully applied to detector signal processing makes digital PSD method one of the most promising particle identification methods. Sampling frequency and the number of bits are two key parameters of digital method. For silicon detector signal, adopting 100 Ms/s, 12 bit Digitizer can satisfy the time resolution requirement of PSD method. The identification characteristic and energy threshold of this method have been discussed and compared with both front injection and rear injection cases. Energy threshold with rear injection usually is much lower than that with front injection. For example, around for Neon isotope energy threshold with rear injection is about 100 MeV which is only half of the threshold with front injection, also equivalent to thickness of about 60 μm silicon detector threshold in ΔE-E method. At the end the impact of silicon detector's resistivity nonuniformity and channel effect on the identification capacity of PSD method has been discussed in detail.     

高温氧化-化学发光检测法测定水中总氮

采用高温氧化-化学发光检测法（high temperature oxidation ＆ chemiluminescence, HTO-CL）进行水质总氮（TN）的在线测定。总氮浓度（CN）与化学发光的强度（IN）呈良好的线性关系,线性区间为0．05～100mg／L。对真实水样采用本方法进行测定,其结果与国标方法相符,回收率在90％～110％之间。以本方法为工作原理的TN-2000型总氮测定仪可用于地表水质及污水的在线监测。     

1，2—二氯丙烷裂解反应光窗结焦机理的研究

有机化合物在光窗上的结焦严重地影响激光引发化学反应及光学原位实时探测。本文报道在1，2－二氯丙烷反应系统中，光窗结焦现象同时存在于激光引发反应及热反应过程中，对光窗在300℃条件 下的结焦机理研究表明，少量氧气在光窗结焦过程中起关键作用。结焦前驱体的红外光谱研究表明，前驱体的可能结构为1－丙炔－1，3－二醇的缩聚体。该化合物极易通过缩聚反应形成更大的分子，最终导致光 窗结焦。对系统及反应物进行彻底除氧，光窗结焦现象大为改善。     

Complex Surface Chemistry of an Otherwise Inert Solvent Molecule: Tetrahydrofuran on Si(001)

The reaction of tetrahydrofuran (THF), an otherwise inert solvent molecule, on Si(001) was experimentally studied in ultra‐high vacuum. Using scanning tunneling microscopy (STM) and photoelectron spectroscopy at variable temperature, we could both isolate a datively bound intermediate state of THF on Si(001), as well as the final configuration that bridges two dimer rows of the Si(001) surface after ether cleavage. The latter configuration implies splitting of the O?C bond, which is typically kinetically suppressed. THF thus exhibits a hitherto unknown reactivity on Si(001).     

Sb2S3纳米粒子修饰ZnO纳米片微纳分级结构的光电化学性能

采用恒电位方法,选择氯化钾和乙二胺(EDA)为添加剂,在氧化铟锡(ITO)导电玻璃上制备了高度有序的ZnO纳米片阵列,通过二次电沉积得到了ZnO纳米片上生长纳米棒的微纳分级结构.利用化学浴沉积法在ZnO基底上沉积Sb₂S₃纳米粒子制备出了Sb₂S₃/ZnO纳米片壳核结构和Sb₂S₃/ZnO微纳分级壳核结构.利用扫描电子显微镜(SEM)、X射线衍射(XRD)、紫外-可见(UV-Vis)吸收光谱、瞬态光电流等对其形貌、结构组成和光电化学性能进行了表征和分析.结果表明, Sb₂S₃/ZnO纳米片上生长纳米棒分级壳核结构的光电流明显高于Sb₂S₃/ZnO纳米片壳核结构.在Sb₂S₃/ZnO纳米片壳核结构和Sb₂S₃/ZnO微纳分级壳核结构的基础上旋涂一层P3HT薄膜形成P3HT/Sb₂S₃/ZnO复合结构,以上述复合结构薄膜为光活性层组装成杂化太阳电池,其中, P3HT/Sb₂S₃/ZnO分级壳核结构杂化太阳电池的能量转换效率最高,达到了0.81%.