纵横载荷作用下功能梯度梁的弯曲和过屈曲

基于一阶非线性梁理论和物理中面概念,导出了纵横向载荷作用下功能梯度材料(FGM)梁非线性弯曲和过屈曲问题的控制方程,并获得了该问题的精确解;据此解研究了梯度材料性质、外载荷、横向剪切变形以及边界条件等因素对功能梯度材料梁非线性力学行为的影响,分析中假设功能梯度材料性质只沿梁厚度方向,并按成分含量的幂指数函数形式变化。结果表明:纵横载荷共同作用下,功能梯度梁的弯曲构形将有无限多个;随着梯度指数的增大,梁的变形减小,临界载荷升高;随着长高比的增大,横向剪切变形的影响减小。     

基于内聚力模型的快速荷载下CFRP-混凝土界面剪切剥离模拟

鉴于纤维增强复合材料(Fiber Reinforced Polymer, FRP)已在混凝土结构加固中普遍应用, 能有效提高结构的承载和变形能力. 为揭示动载作用下FRP-混凝土界面的剥离机理, 本文基于ABAQUS平台, 采用内聚力模型模拟CFRP-混凝土界面层, 实现了快速荷载下CFRP-混凝土界面剥离的高效模拟. 结果表明: CFRP表面应变在加载过程中由加载端向自由端方向传递, 随着加载速率的提高, 界面承载能力也随之提高; 界面峰值剪应力也存在显著的应变率效应; 模拟结果与试验结果基本吻合, 说明了新方法的有效性.     

Hydrodynamic and Thermodynamic Nonequilibrium Effects around Shock Waves: Based on a Discrete Boltzmann Method

A shock wave that is characterized by sharp physical gradients always draws the medium out of equilibrium. In this work, both hydrodynamic and thermodynamic nonequilibrium effects around the shock wave are investigated using a discrete Boltzmann model. Via Chapman–Enskog analysis, the local equilibrium and nonequilibrium velocity distribution functions in one-, two-, and three-dimensional velocity space are recovered across the shock wave. Besides, the absolute and relative deviation degrees are defined in order to describe the departure of the fluid system from the equilibrium state. The local and global nonequilibrium effects, nonorganized energy, and nonorganized energy flux are also investigated. Moreover, the impacts of the relaxation frequency, Mach number, thermal conductivity, viscosity, and the specific heat ratio on the nonequilibrium behaviours around shock waves are studied. This work is helpful for a deeper understanding of the fine structures of shock wave and nonequilibrium statistical mechanics.     

An experimental investigation into non-linear wave loading on horizontal axis tidal turbines

Tidal turbines are subject to large hydrodynamic loads from combinations of currents and waves, which contribute significantly to fatigue, extreme loading and power flow requirements. Physical model testing enables these loads and power fluctuations to be assessed and understood in a controlled and repeatable environment. In this work, a 1:15 scale tidal turbine model is utilised to further the fundamental understanding of the influence of waves on tidal turbines. A wide range of regular waves are generated in both following-current and opposing-current conditions. Wave frequencies range from 0.31 Hz to 0.55 Hz & wave heights from 0.025 m to 0.37 m in a fixed 0.81 m/s current velocity. Waves are selected and programmed specifically to facilitate frequency domain analysis, and techniques are employed to isolate the effect of non-linear waves on turbine power and thrust.Results demonstrate that wave action induces large variations in turbine power and thrust compared to current only conditions. For the range of conditions tested, peak values of thrust and power exceed current-only values by between 7%–65% and 13%–160% respectively. These wave-induced fluctuations are shown to increase with wave amplitude and decrease with wave frequency. Following wave conditions exhibit greater variations than opposing for waves with the same wave height and frequency due to the lower associated wavenumbers.A model is developed and presented to aid the understanding of the high-order harmonic response of the turbine to waves, which is further demonstrated using steady state coefficients under assumptions of pseudo-stationarity. This approach is proven to be effective at estimating wave-induced power and thrust fluctuations for the combinations of waves, currents and turbine state tested. The outcome of which shows promise as a rapid design tool that can evaluate the effect of site-specific wave–current conditions on turbine performance.     

改进的五阶WENO-Z+格式

WENO-ZWENO-Z$+\!$格式的性能提升依赖于新增项的作用,该项的作用是在WENO-Z格式的基础上进一步增大欠光滑子模板上的权重. 系数$\lambda$被设置用来调控该项的作用, 以避免负耗散. 本文指出了WENO-Z$+\!$格式的缺陷,其所采用$\lambda $的取值方式既不能充分发挥格式的潜力, 也未完全消除负耗散;提出$\lambda $的值应随当地流场数据变化,方能充分发挥新增项在降低数值耗散、提高分辨率上的潜力. 基于此,本文重新设计了$\lambda $的计算公式,该公式能自适应地调控新增项的作用: 只在欠光滑子模板上的权重容易过度增大的地方削弱该项的作用,以避免负耗散; 在其他地方则充分发挥新增项的作用,最大限度增大欠光滑子模板上的权重, 提高格式的分辨率.将使用该系数公式的新格式命名为WENO-Z++, 并对其数值性能进行了系统的研究.理论分析表明, 新格式在间断处具有基本无振荡(essentially non-oscillatory,ENO)特性和更低的数值耗散. 对近似色散关系(approximate dispersion relation,ADR)的研究表明,新格式有效地避免了因过度增大欠光滑子模板上的权重而带来的负耗散,其频谱特性也得到了显著提升.本文还推导了使新格式在极值点处也能保持最优阶的精度的参数设置.一系列求解Euler方程的数值试验表明,新格式的激波捕捉能力和对复杂流场结构的分辨率都显著优于原WENO-Z$+\!$格式.}     

不同加载速率下砂岩弯曲破坏的细观机理

岩石细观破裂形貌是岩石破坏机制的重要反映,为研究不同加载速率对砂岩弯曲破坏的影响,通过三点弯曲实验和扫描电镜方法,对某煤矿关键层砂岩弯曲破断裂纹细观形态以及裂纹的自相似性进行了研究。选取6个不同加载速率对岩样进行三点弯曲实验,观察其宏观断裂情况,并利用扫描电镜对弯曲断裂面表面裂纹细观结构进行观察,并拍摄不同倍数下的扫描电镜图片。对图片进行图像处理后得到砂岩弯曲断裂破坏细观裂纹信息,并计算得到微裂纹的分形盒维数值。结果显示:随着加载速率的提高,砂岩穿晶断裂的比例也随之升高,裂纹分形维数亦随着加载速率的增大而增加,同时,分形维数还与弯曲断裂破坏荷载和抗弯强度成正比。可见,加载速率对断裂方式有一定的影响,且加载速率越大断裂所需的破坏能越大,裂纹分布越广,表明开采速度与岩爆等岩体动力灾变有密切关系。     

连续碳纤维增强的聚芳醚酮在Ⅰ型循环载荷下的层间破坏

用双悬臂梁(DCB)试件研究了连续碳纤维增强的聚芳醚酮复合材料(CF/PEK-C),在Ⅰ型循环载荷作用下的层间裂纹扩展行为.循环载荷采用载荷控制模式,最小载荷与最大载荷之比为0.5.在疲劳试验中,仍然发现有“阻力曲线”现象存在.层间裂纹扩展速率用指数定律与相应的应变能释放速率联系起来,并对结果进行了讨论.     

Analysis of alkaloids in Macleaya cordata (Willd.) R. Br. using high-performance liquid chromatography with diode array detection and electrospray ionization mass spectrometry

A method for the analysis of alkaloids in Macleaya cordata (Willd.) R. Br. using high-performance liquid chromatography with diode array detection and electrospray ionization mass spectrometry (HPLC-DAD-ESI/MS) was developed. Using protopine (PRO), allocryptopine (ALL), sanguinarine (SA), and chelerythrine (CHE) as the model components, different columns for the separation and different mobile phases for the signal intensities of alkaloids in ESI/MS were investigated, respectively. The results showed that good separation and high signal intensities can be obtained on a high carbon loading (17%) reversed-phase C(18) column with 30 mM formic acid in mobile phase for the analysis of alkaloids. Under the optimal separation condition and UV detection (284 nm), linearity of the six alkaloids was obtained over concentration range from 0.05 to 100.00 microg/ml. The limit of detection (LOD) was 1.62, 1.87, 1.79, 1.76, 1.10, and 0.94 ng/ml for SA, CHE, PRO, ALL, dihydrosanguinarine (DHSA), and dihydrochelerythrine (DHCHE), respectively. The LODs with ESI/MS detection were lower three orders of magnitude than those obtained with UV detection. The proposed method could be used to control quality of the raw materials of the herb more comprehensively.     

PEG接枝氧化石墨烯的制备与细胞成像

通过酯化反应将不同分子量的聚乙二醇(PEG)接枝到氧化石墨烯(GO)表面,得到系列GO-PEG。利用傅里叶变换红外光谱(FTIR)、拉曼光谱(Raman)、扫描电子显微镜(SEM)对GO-PEG的结构和形貌进行了表征,用热重分析(TGA)测定了GO-PEG中PEG的接枝量。SEM结果表明GO-PEG的剥离程度高于GO。GO-PEG在磷酸盐缓冲溶液中具有良好的分散稳定性,稳定性与接枝量呈正相关。GO-PEG通过非共价键合作用对荧光素(Flu)的负载量可达1.75 mg·mg-1,且负载量受接枝量影响;另外,GO-PEG对Flu的释放行为具有pH值触发药物释放性能。将接枝PEG的端羟基与Flu共价键合,所得GO-PEG6000-Flu荧光探针实现了对HepG2细胞的成像。     

负载型CuO/TiO2催化剂催化CO2加氢制甲醇

采用浸渍法制备了CuO/TiO₂负载型催化剂,并将其用于CO₂加氢制甲醇反应。重点考察了铜的负载量对催化剂性能的影响,并对其物化性能和催化性能之间的关系进行了讨论。结果发现,随着铜负载量的增加,催化剂中金属铜的比表面先增加后减小,当铜的负载量为10%（质量百分数）时达到最大值。催化剂的表面碱性位数量随铜含量的增加持续减小,中等碱位和强碱位的强度下降。当铜的负载量不高于10%时,CO₂的转化率与铜的比表面积呈线性关系。甲醇选择性与催化剂的表面碱位性质有关,过强的碱性位会降低甲醇选择性。