Crystal growth,structure and optical properties of Pr~(3+) -doped yttria-stabilized zirconia single crystals

The development of blue semiconductor light-emitting diodes(LEDs) has produced potential applications for Prdoped materials that can absorb blue light, especially crystals, and we now report structure and optical properties for high-quality Pr-doped single crystals of yttria-stabilized zirconia(YSZ) grown by the optical floating zone(FZ) method.X-ray diffraction(XRD) and Raman spectroscopy showed that all of the single crystal samples were in the cubic phase,whereas the corresponding ceramic samples contained a mixture of monoclinic and cubic phases. X-ray photoelectron spectroscopy(XPS) and electron paramagnetic resonance(EPR) spectroscopy showed that Pr was present as the Pr~(3+) ion in ceramic rods and single crystals after heating to high temperatures. The absorption and photoluminescence excitation(PLE) spectra of the Pr-doped YSZ crystals measured at room temperature showed strong absorption of blue light, while their photoluminescence(PL) spectra showed five emission peaks at 565 nm, 588 nm, 614 nm, 638 nm, and 716 nm under450 nm excitation. The optimum luminescence properties were obtained with the crystal prepared using 0.15 mol% Pr_6O_(11),and those with higher concentrations showed evidence of quenching of the luminescence properties. In addition, the color purity of Pr-doped YSZ single crystal reached 98.9% in the orange–red region.     

Antisolvent crystallization of aqueous ammonium dihydrogen phosphate solutions by addition of acetone at different rates

Results of an investigation of in situ measurements of laser‐beam intensity I_s and I_m transmitted through aqueous ammonium dihydrogen phosphate (ADP) solutions saturated at 30 °C and water, respectively, and temperature T_s of solution and T_m of water during feeding of antisolvent acetone at different rates R_A, using an indigenously designed experimental setup, are presented and discussed. It was found that: (1) for the measurement of MSZW, defined as the maximum volume fraction of acetone content Δx_max in the solution, obtained from temperature measurements are more reliable than transmitted laser‐beam intensity measurements for solutions, (2) two minima ΔT_min1 and ΔT_min2 associated with endothermic reactions, separated by a maximum ΔT_max due to exothermic reactions appear in the plots of temperature difference ΔT = T_s−T_m against acetone feeding time t, and (3) in the ΔT(t) plots there are time intervals Δt of constant rates R_T of increase in ΔT of aqueous ADP solutions, and these values of R_T increase linearly with acetone feeding time rate R_A. The experimental data on the observed dependence of MSZW on antisolvent feeding rate R_A, the appearance of minima ΔT_min1 and ΔT_min2 and maximum ΔT_max and their dependence on R_A, and the relationship between R_T and R_A are discussed from consideration of processes of nucleation and growth of crystallites.     

A simple method to study hemihydrate phosphoric acid crystals growth process

A simple method is introduced in this study to better understand the growth process of hemihydrate phosphoric acid crystals. Using the proposed approach, large particles (>2 mm) can be produced reflecting the true state of the phosphoric acid particulate system. In contrast to previous studies, the principles for the crystallization curves were divided into two regions, based on the consumption of the phosphoric acid in solution. To maintain a constant crystal growth rate, a programmed cooling requirement was needed. In this reported study, the influence of a complexing agent (EDTA) on the crystallization process of phosphoric acid was also investigated. The results of this study showed that the presence of EDTA affected the metastable zone widths, as well as the kinetics of crystal growth.     

Sensitive determination of sulfonamides in environmental water by capillary electrophoresis coupled with both silvering detection window and in‐capillary optical fiber light‐emitting diode‐induced fluorescence detector

A new detector, silvering detection window and in‐capillary optical fiber light‐emitting diode‐induced fluorescence detector (SDW‐ICOF‐LED‐IFD), is introduced for capillary electrophoresis (CE). The strategy of the work was that half surface of the detection window was coated with silver mirror, which could reflect the undetected fluorescence to the photomultiplier tube to be detected, consequently enhancing the detection sensitivity. Sulfonamides (SAs) are important antibiotics that achieved great applications in many fields. However, they pose a serious threat on the environment and human health when they enter into the environment. The SDW‐ICOF‐LED‐IFD‐CE system was used to determine fluorescein isothiocyanate (FITC)‐labeled sulfadoxine (SDM), sulfaguanidine (SGD) and sulfamonomethoxine sodium (SMM‐Na) in environmental water. The detection results obtained by the SDW‐ICOF‐LED‐IFD‐CE system were compared to those acquired by the CE with in‐capillary optical fiber light‐emitting diode‐induced fluorescence detection (ICOF‐LED‐IFD‐CE). The limits of detection (LODs) of SDW‐ICOF‐LED‐IFD‐CE and ICOF‐LED‐IFD‐CE were 1.0–2.0 nM and 2.5–7.7 nM (S/N = 3), respectively. The intraday (n = 6) and interday (n = 6) precision of migration time and corresponding peak area for both types of CE were all less than 0.86% and 3.68%, respectively. The accuracy of the proposed method was judged by employing standard addition method, and recoveries obtained were in the range of 92.5–102.9%. The results indicated that the sensitivity of the SDW‐ICOF‐LED‐IFD‐CE system was improved, and that its reproducibility and accuracy were satisfactory. It was successfully applied to analyze SAs in environmental water.     

逆向环形分布射流迴流特性的数值计算

数值计算表明,逆向多环形分布射流可造成颗粒能直接进入,并能进行强烈的动量、能量交換的理想的迴流区结构。多环形结构可在大范围內造成所需尺寸的迴流区。逆向射流和主流速度比、环直径、射流直径和孔数、环的结构形式及离燃烧室进口的距离是影响迴流特性的主要参数。     

Analysis of microcystins by capillary zone electrophoresis coupling with electrospray ionization mass spectrometry

In this paper, a rapid and effective method based on capillary zone electrophoresis (CZE) coupled with electrospray ionization mass spectrometry (ESI-MS) was established for the trace analysis of microcystin (MC) isomers in crude algae sample. The experimental conditions including the composition, acidity and concentration of buffer, separation voltage, injection time, and MS detection parameters were investigated in detail. A capillary separation system was as follows: a uncoated fused-silica capillary tube (50 μm i.d. × 90 cm), 40 mmol L⁻¹ ammonium acetate solution (pH 9.86) as running buffer, 25 kV as separation voltage, 20 kV × 3 s water first and 20 kV × 20 s for sample injection. Mass analysis was performed in ESI source, with sheath gas temperature 150 °C, sheath gas pressure 10 psi, and sheath gas flow 6 L min⁻¹. And sheath liquid was 7.5 mmol L⁻¹ acetic acid in 50% isopropanol-water (3 μL min⁻¹). Protonation and ammonium adduct molecular ions m/z 506.9 (MC-LR) and 532.0 (MC-YR) were used for the quantification of MCs. Under these conditions, two MCs were baseline separated within 9 min, the calibration curves were obtained in the range of 0.11-10.0 μg mL⁻¹ and 0.16-10.5 μg mL⁻¹ for MC-LR and MC-YR, respectively. Meanwhile, limits of detection were 0.05 and 0.08 μg mL⁻¹ for MC-LR and MC-YR, respectively. The recoveries for the two MCs were in the range of 95.8-108%. The developed approach had been successfully applied to the analysis of MCs in crude algae samples.     

Simultaneous determination of angiotensins II and 1-7 by capillary zone electrophoresis in plasma and urine from hypertensive rats

We describe the procedure developed for the simultaneous detection and quantification of angiotensin II and angiotensin-(1-7), by capillary zone electrophoresis with UV detection by photodiode-array, at a wavelength of 200 nm, in the plasma and urine from hypertensive rats. Optimal separation was achieved with a 100 mM boric acid + 3 mM tartaric acid + 10 fM gold (III) chloride electrolyte solution at pH 9.80. The applied voltage was 30 kV and the capillary temperature was kept constant at 20 °C. The method was over the concentration range of 0.01-500 pmol/mL. All determination coefficients were higher or equal to 0.9985. Limits of detection and quantification for angiotensin II were 0.0110 pmol/mL (S/N = 3) and 0.0195 pmol/mL (S/N = 5), respectively. While for angiotensin-(1-7), the limits were 0.0112 pmol/mL (S/N = 3) and 0.0193 pmol/mL (S/N = 5), respectively. The present method offers a time-saving way to simultaneous determination of angiotensin II and angiotensin-(1-7), since it can be completed in 10 min, compared to other methodologies reported in the literature for capillary electrophoresis and liquid chromatography, which require more than 1 h for analysis of complex matrices, such as plasma and urine. The procedure is illustrated by experiments that quantify simultaneously angiotensin II and angiotensin-(1-7) in plasma and urine from hypertensive and normotensive rats, with and without antihypertensive treatment. The levels of angiotensin II and angiotensin-(1-7) detected in the experimental model, resulted in a recovery of 99.00-106.01% and a reproducibility of less than 10%. The proposed analytical method is a use full tool for the simultaneous detection of angiotensin II and angiotensin-(1-7) implicated in vascular remodeling in pathologies such as hypertension.     

Fast determination of chlorogenic acid in tobacco residues using microwave-assisted extraction and capillary zone electrophoresis technique

In this work, for the first time, capillary zone electrophoresis (CZE) technique combined with microwave-assisted extraction (MAE) was developed for the fast quantification of chlorogenic acid (CA) in tobacco residues. CA in tobacco residue samples were extracted by MAE technique, and then analyzed by CZE. As a new sample preparation method for tobacco residues, the MAE procedure is optimized, validated and compared with conventional methods including ultrasonic extraction (USE) and reflux extraction (RE). It is found that MAE gives the best result due to the highest extraction efficiency within shortest extraction time (only 4.0 min). Here, CA is determined by CZE based on the calibration curve of its authentic standard. The method linearity, detection limit, precision and recovery are studied. The results show that the combined MAE and CZE method has a linearity (R² 0.991, 0.003-0.5 mg ml⁻¹), a limit of detection (0.003 mg ml⁻¹), a limit of quantification (0.01 mg ml⁻¹), good precision (R.S.D. = 4.28%) and a finer recovery (89.0%). The proposed method was successfully applied to the analysis of CA in tobacco residue samples. The experiment results have demonstrated that the CZE combined with MAE is a convenient, fast, economical and reliable method for the determination of CA in tobacco residues.     

Observations of the atmospheric boundary layer across the land-sea transition zone using a scanning Mie lidar

Optical properties of the atmospheric boundary layer (ABL) above the land-sea transition interface were measured using a scanning Mie lidar located 30 km away from the Adriatic coast. Based on the two-dimensional range-height-indicator scans, detailed information on the ABL was obtained, including parameters such as atmospheric optical depth, aerosol extinction coefficient and the height of the ABL. The presented case study indicates that the height of the ABL in the land-sea transition zone and the adjacent mountainous region was changing rapidly due to highly variable atmospheric conditions.