Cluster and periodic DFT calculations of adsorption and activation of CO2 on the Cu(hkl) surfaces

The adsorption behavior and thermal activation of carbon dioxide on the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces have been investigated by means of density functional theory calculations and cluster models and periodic slabs. According to the cluster models, the optimized results indicate that the basis set of C and O atoms has a distinct effect on the adsorption energy, but an indistinct one on the equilibrium geometry. For the CO₂/Cu(hkl) adsorption systems studied here, the final structure of adsorbed CO₂ is near linear and the preferred modes for the adsorption of CO₂ onto the Cu(1 1 1), Cu(1 0 0), and Cu(1 1 0) surfaces are the side-on adsorption at the cross bridge site with an adsorption energy of 13.06 kJ/mol, the side-on adsorption at the short bridge site (13.54 kJ/mol), and the end-on adsorption on the on-top site with C–O bonds located along the short bridge site (26.01 kJ/mol), respectively. However, the calculated adsorption energies from periodic slabs are lower as compared to the experimental data as well as the cluster model data, indicating that the periodic slab approach of generalized gradient approximation in the density function theory may be not suitable to obtain quantitative information on the interaction of CO₂ with Cu(hkl) surfaces.     

布拉格方程在高聚物结构研究中的应用

本文将布拉格方程推广应用到高聚物的结构研究中，得到了经不同剂量辐照的聚乙烯单晶的长周期，并辅以示差扫描量热法研究了γ－射线辐照对聚乙烯单晶结构的影响．     

二乙胺合三(5-甲基-2-苯并噻唑基)硼烷的晶体结构

标题化合物二乙胺合三（５－甲基－２－苯并噻唑基）硼烷（Ｃ２８Ｈ２９ＢＮ４Ｓ３（Ｍｒ＝５２７．５７）的晶体属于三斜晶系，空间群为Ｐ１，晶胞参数ａ＝０．３９７（８）ｎｍ，ｂ＝１．１７４２（６）ｎｍ，ｃ＝１．３１００（２）ｎｍ，α＝１０４．２９（２）°，β＝９２．９９（３）°，γ＝９８．５８（５）°，Ｖ＝１．３７９０ｎｍ３，Ｚ＝２，Ｄｃ＝１．２７０ｇ／ｃｍ３，μ（ＭｏＫα）＝２．８０４ｃｍ－１．结构的偏离因子Ｒ＝０．０６４８，Ｒｗ＝０．０７３７．结构测定表明，甲基取代基的电子效应导致硼碳键键长的平均化，预示杂环对硼原子的π－电子反馈与胺基氮原子对硼原子的反馈有彼消此长的关系．     

Thermally stimulated current and DSC studies of the broadened glass transition in liquid crystalline polymers

The high sensitivity of the thermally stimulated current, thermal sampling (TS) method is emphasized in a study of the breadth of the glass transition in several liquid-crystalline polymers (LCPs). Differential scanning calorimetry (DSC) was performed on all samples to further quantify the glass transition regions. For “random” copolyester LCPs with widely varying degrees of crystallinity, including highly amorphous samples, very broad glass tran-sition regions were observed. One semicrystalline alternating copolyester and a series of semicrystalline azomethine LCPs were studied as examples of structurally regular polymers. These exhibited relatively sharp glass transitions more comparable to ordinary isotropic amorphous or semicrystalline polymers. The broad glass transitions in the random copolyesters are attributed to structural heterogeneity of the chains. In one example of a moderate-crystallinity random copolyester LCP (Vectra), glass transitions ranging up to ca. 150°C in breadth were determined by the thermal sampling (TS) method and DSC. In other lower crystallinity copolyester LCPs, the main glass transition temperature as determined by DSC was comparable to that determined by TSC although cooperative relaxations of a minor fraction of the overall relaxing species were detected well below the main T_g, by the TS method and not by DSC. Rapid quenches from the isotropic melt to an isotropic glass were possible with one LCP. The anisotropic and isotropic glassy states for this LCP were found to have the same breadth of the glass transition as was determined by the TS method, although TSC and DSC show that T_g is shifted downward by ca. 15°C in the anisotropic glass as compared to the isotropic glass. © 1993 John Wiley & Sons, Inc.     

Density functional theory investigation of CN on Cu(1 1 1), Ni(1 1 1) and Ni(1 0 0)

The adsorption of CN on Cu(1 1 1), Ni(1 1 1) and Ni(1 0 0) has been investigated using density functional theory (DFT). While experimental studies of CN on Cu(1 1 1) show the molecular axis to be essentially parallel to the surface, the normally-preferred DFT approach using the generalised gradient approximation (GGA) yields a lowest energy configuration with the C-N axis perpendicular to the surface, although calculations using the local density approximation (LDA) do indicate that the experimental geometry is energetically favoured. The same conclusions are found for CN on Ni(1 1 1); on both surfaces bonding through the N atom is always unfavourable, in contrast to some earlier published results of ab initio calculations for Ni(1 1 1)/CN and Ni(1 0 0)/CN. The different predictions of the GGA and LDA approaches may lie in subtly different relative energies of the CN 5σ and 1π orbitals, a situation somewhat similar to that for CO adsorbed on Pt(1 1 1) which has proved challenging for DFT calculations. On Ni(1 0 0) GGA calculations favour a lying-down species in a hollow site in a geometry rather similar to that found experimentally and in GGA calculations for CN on Ni(1 1 0).     

Electro-optical performance of polymer stabilized cholesteric texture cell: The influence of chiral dopant and monomer concentration

Reverse-mode polymer stabilized cholesteric texture (PSCT) cells with various chiral dopant and monomer concentrations were fabricated. Experimental results indicate that the chiral dopant concentration and the monomer concentration significantly influence the threshold voltage and hysteresis of the cells. The chiral dopant and monomer deform the hysteresis loop. Increasing the monomer concentration reduces the width of the hysteresis loop of the reverse-mode PSCT cell.     

In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

Crystal structure and morphology of phenyl‐capped tetraaniline in the leucoemeraldine oxidation state

A series of crystals of phenyl‐capped tetraaniline in the leucoemeraldine oxidation state were obtained at different isothermal temperatures and were observed directly under transmission electron microscope. The crystals obtained at higher temperatures exhibit more perfect structures than those obtained at lower temperatures. Both the lamella thickness and the crystal size increase with crystallization temperature. The tetraaniline is apt to form larger scale crystals under lower degree of supercooling. However, their crystal structures keep steady with the crystallization temperature. The tetramer was found to adopt a monoclinic lattice with unit cell parameter of a = 13.93 Å, b = 8.82 Å, c = 23.20 Å, and β = 95.03°, as determined using electron diffraction tilting method combined with wide‐angle X‐ray diffraction experiment. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 764–769, 2006     

Synthesis and Structural Characterization of Adduct [La(NO_3)_3·4H_2O]·2(BQEB)

Differentkindsofopenchaincrownethershavebeensynthesizedasthemodelcompoundsofionophoresandtheirinteractionswithsodium,potassiumandrareearthionshavealsobeenstudiedl'z.PanshowedCe(III)yieldedalf1complexwithl,8-bis(8'-quinolyloxy)-3,6-dioxaandtheCe(IIl)ioncoordinatedbothtoetheroxygenandquinolinenitrogenatoms3.TUmInleridentifiedtwolanthanidenitratecomplexeshavingastoichiometryof3:2(3RE:2L)'.InordertostUdythefunctionsofbothquinolineandbenzenering,introducedintothepolyetherchain,a1inearpolyether…     

Thermal Analysis of the Conformational Disorder in SCLC Polymers with Rigid Backbone Glass transition studies

Bis [(ω-(4′-cyanobiphenyl)-4-yl)oxy-n-alkyl]norborn-5-ene-2,3-dicarboxylate was polymerised via ring opening metathesis polymerisation (ROMP). Two disubstituted polynorbornene derivatives both of cis configuration with different length of the side-chain were studied. Differential scanning calorimetry (DSC) was used to study the effect of thermal history on the assignment of the glass transition event associated with the biaxial orientation of a smectic phase. Glass transition temperatures, the change of isobaric specific heats at T_g and the enthalpies of isotropisation were calculated. The DSC traces only show the classic step-wise change in T_g in some cases, giving the evidence that the amorphous domains are constrained and highly restricted in movement due to the morphology developed as a result of the biaxial stretching. Based on the literature data of mono- and disubstituted polynorbornene derivatives and our calorimetric experiments, the shape of T_g dependence on number of (CH₂) units is interpreted. The origin of this shape is discussed. This revised version was published online in August 2006 with corrections to the Cover Date.