Diagnostics of an RF Plasma Flash Evaporation Process Using the Monochromatic Imaging Technique

The high densities and high gas temperature of rf plasmas at pressures near 1 atm are favorable for the development of plasma sources capable of evaporating solid precursors in the plasma zone. In the cooler region downstream of the plasma, the evaporated material condenses to nanoparticles and/or coatings. The complete evaporation of precursors injected into a thermal plasma depends on plasma and precursor parameters and is studied in this paper. Since many parameters contribute to the evaporation, fast experimental techniques are necessary to carry out a systematic study of the evaporation process. The monochromatic imaging technique applied in this work uses an intensified CCD camera with optical filters for the detection of characteristic plasma emission lines. The high spatial and temporal resolution of this technique results in a detailed picture of plasma emission and particle evaporation for different process parameters. These results are compared to model calculations for particle evaporation.     

Increase in temperature of a ferromagnetic substance in rf magnetic field

If one applies an rf magnetic field parallel to a strong static field, temperature of a ferromagnetic substance rises due to ferromagnetic resonance. This phenomenon finds immediate application in the field of hyperthermic oncology. In this work, we have found expression for the increase in temperature when a ferromagnetic material is placed under a static and a varying magnetic field of high frequency through spin wave approach. The numerical value of this increment of local temperature has been estimated for yttrium iron garnet (YIG). We also have examined the possibility of enhancing the temperature of a ferromagnetic material only by applying a strong static field.     

The fabrication and characterization of ZnO UV detector

ZnO films were deposited on GaAs substrates by radio frequency (rf) magnetron sputtering followed by an ambient-controlled heat treatment process for arsenic doping. In Hall measurements, the As-doped ZnO films showed the characteristics of p-type semiconductor. The ZnO thin film p–n homojuctions were then fabricated to investigate the electrical properties of the films. The p–n homojunctions exhibited the distinct rectifying current–voltage (I–V) characteristics. The turn-on voltage was measured to be 3.0 V under the forward bias. When ultraviolet (UV) light (λ = 325 nm) was irradiated on the p–n homojunction, photocurrent of 2 mA was detected. Based on these results, it is proposed that the p–n homojunction herein is a potential candidate for UV photodetector and optical devices.     

含有两个约瑟夫森结的射频SQUID的本征磁通噪声

我们研究了双结射频超导量子干涉器件（rf SQUID）的含时特性，给出了总磁通的动力学方程，并分析了在回滞模式和非回滞模式下的本征磁通噪声。结果显示：两个结的临界电流差别越大则越有助于获得小的本征噪声，在这种情况下，双结rf SQUID的本征磁通噪声会比单结rf SQUID的噪声稍大，但不超过一个数量级。     

用于NPA标定系统的高频离子源研制

研制了一台用于Neutral Particle Analyzer(NPA)标定系统的高频离子源,对其性能参数进行了实验测量,得到引出束流与高频振荡器板压、引出电压及放电气压之间的特性曲线,对影响引出束流稳定性的原因进行了分析.结果表明:当工作气体为氢气,在板压580 V、引出电压1600 V、聚焦电压1550 V和气压9.5×10~(-4) Pa时,能引出66μA的离子流;在41μA束流条件下,4小时内的束流稳定性优于2.6%,影响束流稳定性的主要因素是放电管内工作气体气压的波动和等离子体温度的升高.此结果可以满足HL-2A/M上NPA系统的标定对离子源的要求.     

Gamma Ray Generation Through a 1.064 μM Laser Beam

We are exploring to process nuclear waste through nuclear transmutation method with ray irradiation. The ray employed for transmutation is generated in the way of Compton backscattering. Preliminary experiment is being developed on the NewSUBARU storage ring providing an electron beam with energy of 1 GeV, and 17.6 MeV ray will be generated through a head-on collision of the electron beam and a 1.064 m laser light. ray flux about the present experiment is predicted theoretically. A planned scheme for promoting the flux is also introduced, As well as the maximum laser power available for the storage ring is discussed.     

调整PFN提高BFEL微波相位稳定度

为实现北京自由电子激光(BFEL)的受激辐射和饱和振荡,加速器的微波功率相位稳定度要小于1°。对微波相位的变化与速调管高压调制器人工线之间的关系做了仔细的实验研究。对高压调制器的48节人工线做了全面的优化调整。调整结果令人满意,在6 μs高压调制器最大脉宽里,速调管输出功率的微波相位纹波由调整前的2.6° 降到了± 1.5° ;在BFEL加速器实际使用的4 μs宽里,相位纹波仅为± 1°。     

HIRFL 新B1聚束器的腔体设计

根据HIRFL加速器的束流纵向匹配要求及实际情况,给出了新B1聚束器腔体的具体设计方案。采用短路片和两个移动电容板双调谐方式以满足该聚束器的宽工作频率范围要求。利用MAFIA程序对腔体的频率范围、品质因素Q值、损耗功率、微调电容及表面电流分布进行了计算,并就计算中可能引起的误差及方案的可行性进行了讨论。     

间苯二酚-甲醛凝胶自发成膜技术研究

以间苯二酚和甲醛为原料,对水相溶胶-凝胶聚合自发成膜技术获得间苯二酚-甲醛(RF)凝胶薄膜进行了研究。主要研究了溶胶-凝胶过程中冰醋酸（HAC）含量和反应温度对凝胶过程的影响,分析了RF有机凝胶自发成膜的形成机理。IR和SEM分析表明,所得到的凝胶膜具有典型的RF有机气凝胶结构,薄膜厚度大约为50 μm,膜由直径10 μm左右的粒子组成,没有观察到明显的孔洞结构。分析认为,在间苯二酚和甲醛占总溶液的质量分数为67％左右及控制pH值在一定的酸性范围,RF凝胶自发成膜过程和机理可以用RF凝胶的收缩机理加以解释,RF自发膜的表面形貌及形成机理与均匀泡沫的连续相分离机理类似。     

利用场耦合理论研究微波谐振腔

根据Maxwell方程,微波腔中的实际微波场可以按微波腔的模式展开,从而确定微波腔的工作特性（如：工作频率、场分布等）,但是实际微波腔的模式很难求解。从Maxwell方程出发,根据微波腔的具体边界,将微波腔分成：规则形状微波腔和非规则部分,建立实际微波腔模式同规则形状微波腔模式之间的场耦合方程,从而确定微波腔模式的频率和场分布。