Absorption Complex between Porphyrin and Phenothiazine in Reverse Micelles

Porphyrin derivatives attract much more interest in photodynamic therapy (PDT). Their importance as therapeutic drugs and targeting agents has been widely recognized1, and many of the efforts have been put towards crafting new porphyrin-based molecular entities to achieve enhanced tumor localization, better tissue penetration and increased singlet oxygen quantum yield2. The states of porphyrins in tissue models such as micelles, lipid bilayers are extensively investigated focusing more or l…     

Probing the surface polarity of native celluloses using genuine solvatochromic dyes

The surface polarity of native celluloses has been investigated by the following solvatochromic dyes: dicyano-bis (1,10)-phenanthroline iron (II) Fe(phen)2 (CN)2 (1), bis(4-N,N-dimethylamino)-benzophenone (2), and cou-marine 153 (3). Linear Solvation Energy (LSE) relationships and the UV/Vis data have been used to characterize the surface polarity of different native cellulose batches in terms of the empirical Kamlet–Taft polarity parameters (hydrogen bond acidity), (hydrogen bond basicity), and * (dipolarity/polarizability). , , *and calculated Reichardt's E T (30) values are reported for various native and regenerated cellulose samples with different degrees of crystallinity. The degree of crystallinity of the cellulose samples has been determined by X-ray. The microcrystalline environment of cellulose can be exactly parameterized in terms of the , and *values. It shows a fairly strong acidity and a low dipolarity/polarizability. For the amorphous sections smaller and larger * values are observed. The correspondence of the empirical polarity parameters determined has been discussed in relation to results from pyrene fluorescence and zetapotential measurements.     

Determination of Nabumetone and Its Major Metabolite in Plasma and Tablet Formulations by Reverse-Phase HPLC

Abstract

A high performance liquid chromatographic procedure is presented for the determination of nabumetone in pharmaceutical tablets and in plasma. An aliquot of the sample is dissolved in 50% acetonitrile (ACN) containing 4-methoxyacetophenone as an internal standard and chromatographed on a Supelcosil LC-8 (5μ) (150 mm × 4.6 mm i.d.) column. The mobile phase was a mixture of acetonitrile (500 mL), triethylamine (1.5 mL) and glacial acetic acid (8 mL) diluted to 1000 mL, with distilled deionized water. The detection was carried at 270 nm. The method was tested for linearity, recovery and specificity.     

Analytical Separations of Schiff Base Chelates by Reverse Phase Hplc on a 10 Micron C-18 Bonded Silica Subtrate

Abstract

Reverse phase partition chromatography on a 10 micron silica-bonded octadecyl hydrocarbon substrate is applied to the separation of neutral tetradentate chelates of copper (II), nickel (II) and palladium (II) with a range of non-fluorinated and fluorinated beta-ketoamine and salicylaldimine ligands. Variation of retention and resolution with respect to changes in ligand structure and metal chelated is investigated using acetonitrile, methanol and water solvent systems. Detection limits (254 nm) and linearity ranges of response are indicated.     

Determination of Benzo(a)Pyrene and other Polynuclear Aromatic Hydrocarbons in Airborne Particulate Material by Ultrasonic Extraction and Reverse Phase High Pressure Liquid Chromatography

Abstract

Ultrasonic extraction of airborne particulate material on Hi-Vol filters is described. Almost all of the polar compounds are removed during the extraction by adsorption on the surface of the shredded glass fibers and controlled pore glass powder (CPG). The non-polar polynuclear aromatic hydrocarbons (PAH) in the extract are separated at room temperature by high pressure liquid chromatography (HPLC) on reverse phase Vydac using acetonitrile:water (70:30 v/v) as the chromatographic solvent. There is baseline separation of benzo(a)pyrene (BaP), benzo(k)fluoranthene (BkFt) and of benzo(e)pyrene (BeP), benzo(b)fluoranthene and perylene, the latter three present in one band. Extracts of airborne particulates show the same peaks. BaP elutes in approximately 14 minutes. Precision and accuracy measurements indicate full recovery of PAH and good extraction reproducibility. The detection limit of BaP at F 290/389 is less than 10 pg. Total analysis time is approximately 1 1/2 hr, most of which is waiting time.     

Investigation into factors affecting precision in ion trap mass spectrometry using different scan directions and axial modulation potential amplitudes

Electrospray ionization mass spectra obtained from different scan directions are observed to be dependent on the axial modulation potential amplitudes used for resonant ejection and on the positive deviation caused by higher even-multipole fields present in most commercial ion traps. The axial modulation voltage influences the dissociation of ions during resonant ejection and the observed mass shifts. The higher even-multipole fields in commercial ion traps are known to influence resonant ejection from the ion trap and can cause a loss in mass resolution for peaks in reverse scan mass spectra compared with that obtained by the forward scan. However, along with the dissociation of ions during resonant ejection causing a loss in resolution, the possibility of resolving an isotopic distribution is also shown to be influenced by the mass shifts caused by the space charge. These mass shifts differ depending on the scan direction employed. A significant loss in resolution can also result from resonant ejection using non-optimal axial modulation voltages. We also present results showing the ejection of ions at betaz = 1/2 using the reverse scan mode without the axial modulation voltage. Ion ejection at betaz = 1/2 is uncommon in commercial (stretched ion traps) with the conventional analytical scan without the use of a frequency of the axial modulation voltage corresponding to this non-linear resonance.     

Facile Iron‐Mediated Dispersant‐Free Suspension Polymerization of Methyl Methacrylate via Reverse ATRP in Water

An iron‐mediated reverse ATRP of methyl methacrylate (MMA) is successfully carried out in water in the absence of any dispersants, using a water‐soluble 2,2′‐azobis(2‐methylpropionamidine) dihydrochloride (V‐50) as the initiator and the stabilizer, and using an oil‐soluble N,N‐butyldithiocarbamate ferrum (Fe(S₂CN(C₄H₉)₂)₃) as the catalyst without adding any additional ligands. Micron‐sized PMMA particles with UV light‐sensitive ‐S₂CN(C₄H₉)₂ end group are obtained, and monomer droplet nucleation and suspension polymerization mechanism are proposed. Polymerization results demonstrated typical “living”/controlled characteristics of ATRP: first‐order polymerization kinetics, linear increase of molecular weights with monomer conversion and narrow molecular weight distributions for the resultant PMMA particles. NMR spectroscopy and chain‐extension experiments under UV light irradiation confirm the attachment and livingness of UV light‐sensitive ‐S₂CN(C₄H₉)₂ group in the chain end.

     

Syntheses and photochromic studies of dithienylethene-containing imidazolium derivatives and their reactivity towards nucleophiles

A series of dithienylethene-containing imidazolium salts with various substituents on the 2-position of the imidazolium ring has been synthesized. The photochromic properties of these compounds have been studied, and the closed forms are found to be solvatochromic due to the donor-acceptor interaction with the solvent molecules. The closed form of the imidazolium salt shows a much higher affinity towards nucleophiles over the open form of the salt. A reaction pathway has been proposed to account for this reactivity difference based on the structure-property relationship, and the possible structure of the reaction product is discussed.