Gas Storage in Single-Walled Carbon Nanotubes

Abstract

X-ray diffraction (XRD) and electrical resistance measurement on single-walled carbon nan-otube (SWNT) samples prepared by the arc-discharge method are reported. The XRD profile of heat-treated sample indicated that air (oxygen, and/or nitrogen and/or water) can be condensed inside the SWNTs. We also found that the electrical resistance of SWNT soot is significantly affected by exposing to the oxygen gas and humid air.     

One-step measurements of powder resistivity as a function of relative humidity and its effect on charging

A new one-step technique to measure the effect of ambient humidity on powder resistivity has been previously presented. In this article, we provide more experimental data obtained with five different powders. One-step measurements and traditional multi-step measurements were performed. Also, additional measurements were performed using standard resistivity cell. Results were compared and it could be concluded that the new technique provided meaningful results although significant hysteresis was observed during humidification and drying cycles. Finally, charging of the powder was also measured and it was noticed that it decreases with decreasing resistivity and increasing humidity.     

Investigation on ion movement in the fringe-field switching mode depending on resistivity of alignment layer and dielectric anisotropic sign of liquid crystal

Adsorption and desorption of ions at interface between liquid crystal and alignment layer in liquid crystal displays play a crucial role in residual direct current voltage associated with image sticking. In this article, the dependency of such adsorption and desorption of ions on resistivity of alignment layer and sign of liquid crystal dielectric anisotropy in the fringe-field liquid crystal cell has been investigated. Our studies show that the time constant of ions during adsorption and desorption depends upon resistivity and dielectric constant of liquid crystal and alignment layer, and most strongly influenced by the resistivity of alignment layer such that the one with lower resistivity in two orders shows much faster adsorption and desorption at the interface than that of the one with higher resistivity.     

Dependences of structural and electrical properties on thickness of polycrystalline Ga-doped ZnO thin films prepared by reactive plasma deposition

Polycrystalline Ga-doped (Ga content: 4 wt%) ZnO (GZO) thin films were deposited on glass substrates at 200 C by a reactive plasma deposition with DC arc discharge technique. The dependences of structural and electrical properties of GZO films on thickness, ranging from 30 to 560 nm, were investigated. Carrier concentration, n, and Hall mobility, μ, increases with increasing film thickness below 100 nm, and then the n remains nearly constant and the μ gradually increases until the thickness reaches 560 nm. The resistivity obtained of the order of 10⁻⁴ Ω cm for these films decreases with increasing film thickness: The highest resistivity achieved is 4.4×10⁻⁴ Ω cm with n of 7.6×10²⁰ cm⁻³ and μ of 18.5 cm²/V s for GZO films with a thickness of 30 nm and the lowest one is 1.8×10⁻⁴ Ω cm with n of 1.1×10²¹ cm⁻³ and μ of 31.7 cm²/V s for the GZO film with a thickness of 560 nm. X-ray diffraction pattern for all the films shows a hexagonal wurtzite structure with its strongly preferred orientation along the c-axis. Full width at half maximum of the (002) preferred orientation diffraction peak of the films decreases with increasing film thickness below 100 nm.     

高压下锐钛矿TiO2的电阻率及能带结构的研究

应用在位电阻率测量方法研究高压下锐钛矿TiO2的电学性质. 通过研究电阻率随压力变化的异常变化点, 观察到了TiO2从锐钛矿-柯铁矿-斜锆石的相变. 卸压后,电阻率和初始值相差2个数量级, 说明该相变为不可逆相变. 结合第一性原理计算结果表明, 柯铁矿结构更小的带隙是导致TiO2电阻率减小的根本原因.     

Determining the micro-optical element surfaces profiles using transmission deflectometry with liquids

We propose a method for simultaneously measuring the front and back surface profiles of transparent optical components. The proposed method combines dual wavelength transmission deflectometry with liquids to record distorted phases at different wavelengths, and then numerically reconstructs the three-dimensional phase information to image the front and back surfaces of the lens. We propose a theoretical model to determine the surface information, and the imaging of achromatic lenses is experimentally demonstrated. Unlike conventional transmission deflectometry, our proposed method supports direct observation of the front and back surface profiles of the optical elements. Compared with other techniques such as interferometry, the proposed setup is simpler to align, has lower cost, and does not require coherent illumination. The proposed method can be applied to normal transmission deflectometry for determining the three-dimensional surface profiles of optical components.     

Resistivity and Thermal Expansion (4.2–820 K) of Skutterudites after Severe Plastic Deformation via HPT

Thermoelectric materials with a high figure of merit, ZT, are the essential basis to build thermoelectric generators, which can directly convert heat into electricity. Severe plastic deformation (SPD) via high-pressure torsion (HPT) was successfully applied to enhance ZT of ball-milled and hot-pressed skutterudites as well as to produce bulk nanostructured skutterudites directly from powders. SPD introduces many defects into the sample and in parallel the crystallite size is significantly reduced. During measurement-induced heating these defects anneal partially out, and the grains grow. In this work for the first time systematically the changes of the temperature-dependent electrical resistivity and of thermal expansion were compared. It could be shown that for p- and n-type skutterudites, being hot-pressed and HPT-processed as well as directly HPT-processed from compacted powder, these changes occur more or less simultaneously within the same temperature ranges. This evaluation gives a much deeper insight into the thermoelectric behavior of HPT samples under the influence of changing temperature.     

Cr掺杂对Nd0.7Sr0.3MnO3电磁性质的影响

我们对多晶样品Nd0.7Sr0.3Mn1-xCrxO3(x≤0.30)进行了X射线衍射谱、电阻温度关系和磁化强度测量.实验发现:随Cr掺杂量的增加,样品的电阻率变大,电阻峰温度和居里温度降低,这是由Cr的介入弱化了双交换作用所致;在x=0.10附近,电阻出现了双峰现象,在其M~T上没有发现与低温峰对应的磁性异常;在锰位磁矩与Cr含量的关系中发现,Cr掺杂对样品的磁性几乎无贡献;通过分析,我们用相分离的图象解释了有关的现象.     

光催化材料反应系数测量新方法

本文提出光催化材料反应系数测量新方法-Mass transfer based(MTB)方法,该方法不同于传统方法中忽略传质影响,而是通过CFD计算考虑传质影响,这种改进无需传统方法所需反应控制过程也可准确测量光催化材料反应系数。利用该方法测量了光催化材料降解甲醛的反应系数,实验验证了其可行性。     

飞行器角速度测量的三轴加速度计法

飞行器角速度的测量在航空航天领域是极为重要的问题,然而现在主流的利用陀螺仪测量角速度的方法有造价较高这一问题。本文提出了一种通过测量刚体上非共线三点的加速度得到刚体角速度的方法,可以利用极为廉价的高精度加速度计较为准确地测量高速稳态飞行器的角速度。本文应用刚体运动学中的基点法,得到由刚体上非共线三点的加速度和其距离表示的刚体角速度,并对其进行了误差分析。最终采用数值模拟的方法,分析了此方法在具有较高角速度的飞行器和具有较低角速度的稳态卫星上得到的角速度的适用性。模拟结果表明,此种方法适用于稳态高角速度的飞行器。