Optical and static dielectric study of a terminally fluorinated liquid crystalline compound

Optical and static dielectric studies on a terminally fluorinated liquid crystalline compound have been carried out. Measurements of temperature variation of refractive indices of the compound are done by using thin prism method. A four-parameter model is validated by fitting the experimentally measured values of refractive indices, birefringence and average refractive indices of the compound with the theoretical ones. Refractive index and density data are utilized for determination of orientational order parameter. The temperature variation of dielectric permittivities of the compound are measured by a LCR meter.     

基于多重子域代理模型的结构可靠性分析

基于合理子域概念,构建多重代理模型。多重代理模型在合理子域内采用经典响应面模型,在合理子域外采用经典Kriging模型,能够充分利用两种经典模型各自的优势。多重代理模型能够合理规避经典响应面模型中响应函数采取事先假定形式带来的可靠度评估风险,同时能够有效避免经典Kriging模型中试验点组合爆炸的问题。相比经典响应面模型,多重代理模型所需试验点数量并未增加,计算效率与经典响应面模型大体相同。算例表明,本文方法的计算结果与MCS的计算结果几乎一致,具有较好的计算精度。     

An experimental investigation into non-linear wave loading on horizontal axis tidal turbines

Tidal turbines are subject to large hydrodynamic loads from combinations of currents and waves, which contribute significantly to fatigue, extreme loading and power flow requirements. Physical model testing enables these loads and power fluctuations to be assessed and understood in a controlled and repeatable environment. In this work, a 1:15 scale tidal turbine model is utilised to further the fundamental understanding of the influence of waves on tidal turbines. A wide range of regular waves are generated in both following-current and opposing-current conditions. Wave frequencies range from 0.31 Hz to 0.55 Hz & wave heights from 0.025 m to 0.37 m in a fixed 0.81 m/s current velocity. Waves are selected and programmed specifically to facilitate frequency domain analysis, and techniques are employed to isolate the effect of non-linear waves on turbine power and thrust.Results demonstrate that wave action induces large variations in turbine power and thrust compared to current only conditions. For the range of conditions tested, peak values of thrust and power exceed current-only values by between 7%–65% and 13%–160% respectively. These wave-induced fluctuations are shown to increase with wave amplitude and decrease with wave frequency. Following wave conditions exhibit greater variations than opposing for waves with the same wave height and frequency due to the lower associated wavenumbers.A model is developed and presented to aid the understanding of the high-order harmonic response of the turbine to waves, which is further demonstrated using steady state coefficients under assumptions of pseudo-stationarity. This approach is proven to be effective at estimating wave-induced power and thrust fluctuations for the combinations of waves, currents and turbine state tested. The outcome of which shows promise as a rapid design tool that can evaluate the effect of site-specific wave–current conditions on turbine performance.     

A STUDY OF LOW CYCLE FATIGUE PROPERTIES OF MATERIALS BASED ON THE FUNNEL-SHEET SPECIMENS1)

根据能量等效方法,针对漏斗薄片试样,提出了关联Ramberg-Osgood 幂律参数、试样几何参数的载荷-位移半解析统一模型。采用有限元数值模拟,正、反向验证了该模型的有效性。在此基础上,提出了通过漏斗薄片试样低循环试验实现材料低周疲劳性能的预测方法。基于薄片试样低循环试验数据,完成了SS316L, N18及SAPH440 三种材料的低周疲劳性能预测,预测结果与标准试样试验结果具有良好的一致性。并利用该方法完成了N18与SAPH在不同温度条件下的低周疲劳性能预测。     

基于PVDF薄膜传感器的猪肝动态压缩力学性能测试

瞬态冲击载荷作用下肝脏的力学响应是损伤生物力学的重要研究内容.本文提出了一种可用于软组织动态压缩力学特性测试的改进SHPB(分离式霍普金森压杆,Split Hopkinson Pressure Bar)方法.该方法采用PVDF(聚偏氟乙烯,Polyvinylidene Fluor)压电薄膜传感器测量实验过程中试件两端面...     

关于人膝关节生物力学模型的研究现状

建立人膝关节模型是生物力学研究领域中最具挑战性的课题之一．本文对人膝关节生物力学模型的研究现状予以简单的评估和综述．结果显示:目前用于研究人膝关节的大部分模型,均属静力或准静力模型;仅建立了极少的人膝关节解剖基生物动力模型,且均属二维动力模型．因此,建立一个三维真实人膝关节生物动力模型是目前迫在眉睫的工作      

平面应力条件下闭合断续节理岩体力学特性试验研究

通过平面应力条件下闭合断续节理岩体的破坏试验,采用自行研制的高压柔性加载装置施加垂向和侧向荷载,用千分表和激光散斑照相技术量测试体位移场,用应变花量测试体平面应力场． 结果表明,激光散斑法用于测定闭合断续节理岩体的位移场效果良好,其测值比对应点千分表测值偏小１４％ 左右．据所测得的位移场和应力场,研究了裂纹尖端应力场的演变及裂纹扩展的路径,分析了试体的变形和破坏特征,测定了翼裂纹初裂角,探讨了试体的破坏机理．     

广义双剪应力准则角隅模型

本文将广义双剪应力准则变换为π平面和静水应力轴的柱坐标方程,然后将其角隅光滑化,得到了新的光滑、外凸的广义双剪应力准则角隅模型,研究结果表明,近年来作为光滑化Mohr-Coulomb理论提出的各种角隅模型,实际上并不是光滑化的Mohr-Coulomb理论,而是光滑化的广义双剪应力理论。     

汽轮发电机定子结构的动力分析和模型试验研究

本文用有限元方法分析了两种常见汽轮发电机定子结构模型的动力特性,建立了固有特性对集中质量、连接刚度及基础刚度的灵敏度分析方法,对这两种结构模型进行了振动实验研究,实验结果与有限元分析结果吻合较好.从避开共振的角度出发,对两种结构作了评价.本文的研究方法及实验结果对汽轮发电机结构设计、减振、隔振和降噪等方面的工作具有一定的参考价值和实际工程意义.