用数值方法分析微孔激光器出射光的近场特性

微孔激光器作为应用于近场光信息存储系统中的一种新型光源，它的出射光斑的近场特性对于近场光存储是十分重要的。针对纳米孔径运用角谱进行Fox-Li数值迭代，得到不同孔径微孔激光器的基模光强分布，然后运用二维非线性时域有限差分法分析微孔激光器出射端即微孔金属膜的近场光学性质，模拟计算了不同孔径和厚度的微孔金属膜的光强近场分布，从应用于近场光存储的角度，给出反映其近场光学特性的相关数据。发现由于TM模式下金属存在局域表面等离子增强效应，使得其出射强度比TE模式高一个数量级，从而更适于作为实际中近场光存储系统和原理试验的光学头。     

Submicrometric Displacement and Vibration Measurement Using Optical Feedback in a Fiber Laser

A very simple and efficient technique for the remote sensing of a noncooperative target is presented. This technique is based on the frequency-shifted reinjection of light in a class B laser. Ytterbium- and erbium-doped fiber lasers have both been used to measure displacements with a submicrometric resolution and the vibration power spectrum of an object.     

蓝光相变光盘的多层膜结构设计

为了使光盘获得优良的记录／读出性能并能够长期稳定地使用，必须优化设计相变光盘的多层膜结构。采用自行设计的模拟分析相变光盘读出过程设计软件，从光学角度出发模拟计算了蓝光(405nm)相变光盘的膜层结构，研究了多层膜系的反射率和反射率对比度等光学参量与各层膜厚度和槽深的关系。研究得出的最佳多层膜结构为：下介电层／记录层／上介电层／反射层的厚度对于台记录为100nm／10nm／25nm，／60nm，而对于槽记录则为140nm／15nm／30nm，／60nm，槽深为50nm。模拟计算结果对于将来高密度蓝光相变光盘的制备具有一定的指导意义。     

双预脉冲驱动X射线激光实验研究

 在“星光-Ⅱ”激光装置上进行了双预脉冲驱动类氖铬X射线激光实验，介绍了实验方法和实验结果，并对结果进行了简短讨论。由于目前“星光”装置输出能量较低，所进行的双预脉冲驱动未能显著提高X射线激光强度，改变预脉冲幅度时X射线激光强度也未有显著变化。利用MED103程序进行了模拟计算，其结果与实验结果一致。     

毛细管放电X光激光装置中的预脉冲电源

 针对目前毛细管放电X 光激光装置产生的预脉冲电流幅值过大、持续时间较短的问题，提出了增加预脉冲开关抑制原有预脉冲，再外加由脉冲成形网络组成的预脉冲发生器，产生所需预脉冲的改造方案。可在主脉冲来临之前产生幅度10~50A，持续时间约17μs的方波预脉冲电流，来满足毛细管放电泵浦类氖氩X光激光实验的需要。     

Rotation of a Fine Particle with Circularly Polarized Anti-Parallel Collinear Laser Beams

We have succeeded in the operation of rotating a fine particle which was held without mechanical contact by circularly polarized laser beams with opposite propagation directions. A polystyrene latex particle 11.9 μm in diameter deformed in a disk-like shape was dispersed in water, and was trapped using the anti-parallel collinear laser beams which were set up so that they had the circular polarization rotating in the same direction. It was observed that the trapped particle rotated in the same direction as the rotation of the circular polarization of light. Inversion of the rotational direction of the circular polarization of light reversed the direction of the rotation of the particle. Although the rotational speed of a particle varied significantly from particle to particle, it was found to be proportional to the laser beam intensity. A typical value for the rotational speed per beam intensity was 2.1 Hz/W.     

一种控制掺铒光纤激光器超混沌的方法——非线性延时反馈参数调制法

提出一种非线性延时反馈参数调制法来控制混沌/超混沌，给出了利用这种方法控制处于超混沌状态的双环掺铒光纤激光器的方案.数值模拟表明，只要延时时间和反馈强度合适就可以把双环掺铒光纤激光器从超混沌状态成功地控制到不同的周期状态. 关键词： 掺铒光纤激光器 超混沌 非线性延时反馈参数调制 混沌控制     

几种常见光源特性的研究

本通过大学物理实验中常用光源特性的分析，说明了实验中光源使用的合理性。     

Study of the pulsed laser vapor doping of Si(1 0 0) with KrF excimer laser and BCl3 gas

The properties of pulsed laser vapor doping on p-Si(1 0 0) with a KrF (248 nm) excimer pulsed laser (248 nm) and BCl₃ gas are reported in this paper. The doped samples are characterized by the resistance measured using a four-probe method, since the sheet resistance changes with the carrier concentration of the sample. The doping effects with the variation of laser energy density, pulse number, and the pressure of BCl₃ were investigated in terms of the sheet resistance. In this way, the optimized parameters were obtained and used for the positive heavy doping on p-Si(1 0 0) and p-Si(1 1 1). Then, using a square mesh under the above conditions, an image doping was completed. Finally, the metal–semiconductor Ohmic contacts were realized by plating Ag and Cu films on the doped surface.     

同轴双无衍射光的理论与实验

提出同轴双无衍射光的概念。如果两束汇聚角略有不同的同轴无衍射光同时存在，则它们相互之间叠加干涉后产生一种纵向呈周期变化的光场结构，这是一种新的光束空间分布，这种光束在横向仍是一种同心环光斑，可用于精密对准。而在不同纵向位置，这些同心环的强度分布是不同的，且是周期性变化的。同轴双无衍射光的轴向周期性可用于沿光束传播方向的定位。文中提出了双环缝法、分段圆锥透镜法、正弦相位环光栅法等实现同轴双无衍射光的理论与实验方法，分析了同轴双无衍射光的横向与纵向传播的衍射光斑特性，理论计算与实验测量的结果基本相符合。