Strained Structure in Ho0.5Sr0.5MnO3

The Ho_0.5Sr_0.5MnO₃ perovskite, synthesized in air, has been studied by combining neutron powder and electron diffraction techniques. The Pnma-type structure exhibits a strong tilting of the MnO₆ octahedra. This octahedra tilting and microtwinning involve a complex strained structure. No structural transition is observed down to 1.4 K, but short-range A-type antiferromagnetism running over only a few perovskite subcells is evidenced below ≈90 K. The different behavior of this perovskite compared to other Ln_0.5Sr_0.5MnO₃ perovskites is discussed in terms of A-site cationic mismatch.     

Chemiluminescence Determination of Benzoic Acid Using A Solid-Phase Verdigris Reactor

Benzoicacidisacommonadditiveusedwidelyasfoodpreservativeandplasticizer.Itcouldpromoteseverereactiontoallergicpopulationevenatlowconcentrationlevel1.Routinemethodsfortheassayofbenzoicacidincludeschromatographic2-6,spectrophotometry7,8,capillaryelectrophoresis9-13andelectrochemicaltitration14.Stokes15etal.monitoredairbornebenzoicacidbasedonsurface-enhancedRamanscatteringtechniques.Thereisalsoreportonamicrobialsensorusingpseudomonasforbenzoicacidandtheirderivativesinaqua16.Interestofusinglumines…     

用微芯片化学反应器实现酶催化化学发光测定葡萄糖的研究

葡萄糖是临床化学诊断以及食品分析中重要的检测项目 ,最常用的测定方法是采用葡萄糖氧化酶(GOD)催化葡萄糖与氧分子间反应 ,生成葡萄糖酸和过氧化氢 [1] ,而对过氧化氢的检测则可采用过氧化酶 (POD)催化鲁米诺的化学发光反应进行 [2 ] .FIA对整个过程的实现是十分有效的方式 ,但由于多采用固定化酶反应器 [3～ 5] 使其在制备及分析上较复杂且费用高 .由 Manz等[6] 提出的微型全分析系统(μ- TAS)在针对不同体系的微量分析及在线监测上均具有突出的优越性 .本文使用的含微混合器的微芯片化学反应器采用μ- TAS设计思想 ,建立了化学发…     

Effects of petroleum resins on asphaltene aggregation and water-in-oil emulsion formation

Asphaltenes from four crude oils were fractionated by precipitation in mixtures of heptane and toluene. Solubility profiles generated in the presence of resins (1:1 mass ratio) indicated the onset of asphaltene precipitation occurred at lower toluene volume fractions (0.1–0.2) than without resins. Small-angle neutron scattering (SANS) was performed on solutions of asphaltene fractions in mixtures of heptane and toluene with added resins to determine aggregate sizes. Water-in-oil emulsions of asphaltene–resin solutions were prepared and separated by a centrifuge method to determine the vol.% water resolved. In general, the addition of resins to asphaltenes reduced the aggregate size by disrupting the π–π and polar bonding interactions between asphaltene monomers. Interaction of resins with asphaltenic aggregates rendered the aggregates less interfacially active and thus reduced emulsion stability. The smallest aggregate sizes observed and the weakest emulsion stability at high resin to asphaltene (R/A) ratios presumably corresponded to asphaltenic monomers or small oligomers strongly interacting with resin molecules. It was often observed that, in the absence of resins, the more polar or higher molecular weight asphaltenes were insoluble in solutions of heptane and toluene. The addition of resins dissolved these insolubles and aggregate size by SANS increased until the solubility limit was reached. This corresponded approximately to the point of maximum emulsion stability. Asphaltene chemistry plays a vital role in dictating emulsion stability. The most polar species typically required significantly higher resin concentrations to disrupt asphaltene interactions and completely destabilize emulsions. Aggregation and film formation are likely driven by polar heteroatom interactions, such as hydrogen bonding, which allow asphaltenes to absorb, consolidate, and form cohesive films at the oil–water interface.     

The chemistry of the azanonaborane cluster RNH2---B8H11NHR

The preparation and properties of the R¹R²NH---B₈H₁₁NHR cluster are described. The cluster is stable to aqueous solutions and can be made water-soluble by the introduction of a few hydrophilic groups. This makes the cluster a good candidate as the boron moiety in compounds for boron neutron capture therapy. The chemistry of the cluster preparation, the stability of the cluster, and conditions for reactions of the organic moieties are reviewed. Pyridine derivatives of the cluster show electronic interaction between the cluster and the pyridine.     

Simulation of a Combined Isomerization Reactor & Pressure Swing Adsorption Unit

The Total Isomerization Process developed by Union Carbide in 1970 (Gary, 1987) for the conversion of normal paraffin's to their isomers consists of a reactor followed by a PSA unit each operating at similar pressures and temperatures. The combination of these two operations in one unit in a Pressure Swing Adsorption Reactor (PSAR) process may provide an increased throughput and a significant cost saving in ancillary equipment.The simulation of a mathematical model linking the catalyst packed-bed and the adsorbent packed-bed is reported. The catalyst is a Pd/Y-zeolite and the adsorbent is 5A zeolite. The simulated feed consists of 17% each of n- and isopentane with the remainder being hydrogen. The mathematical model assumes dispersed plug-flow in both sections, constant velocity in the reactor section but varying in the adsorber, with mass transfer in the adsorber section due to external fluid film resistance and macropore diffusion in series. The fraction of the total column length occupied by the catalyst (denoted by ) is accounted for in the model by solving numerically using orthogonal collocation on finite elements. Parameters varied are the ratio of catalyst/column length (), temperature range (506–533 K), high pressure (15–20 bars), with the low pressure held constant at 2 bars. The catalyst/column ratio has a strong effect at low temperatures. The optimum catalyst/column length ratio appears to be controlled by the low pressure step and occurs at = 0.7 for the assumptions used in this work.     

Synthese und Charakterisierung von Quecksilbercyanamid

Synthesis and Characterisation of Mercury Cyanamide HgCN₂ was prepared by double conversion of HgCl₂ with sodium cyanamide in aqueous solution. Its crystal structure has been determined using X‐ray powder data and refined by combined profile fits using X‐ray and neutron diffraction data (Pbca, Z = 8, a = 10.4851(1), b = 6.5138(1), c = 6.8929(1) Å; R_p (X‐ray) = 6.15%; R_p (neutrons) = 2.33; 2.43%). The cyanamide‐anion is bent (172.4(7)°), which has been confirmed by vibrational spectroscopy. Mercury and carbon form zigzag chains. Not including nitrogen, the structure is related to the MnP‐structure type.     

High-productivity continuous biofilm reactor for butanol production

Corn steep liquor (CSL), a byproduct of the corn wet-milling process, was used in an immobilized cell continuous biofilm reactor to replace the expensive P2 medium ingredients. The use of CSL resulted in the production of 6.29 g/L of total acetone-butanol-ethanol (ABE) as compared with 6.86 g/L in a control experiment. These studies were performed at a dilution rate of 0.32 h⁻¹. The productivities in the control and CSL experiment were 2.19 and 2.01 g/(L·h), respectively. Although the use of CSL resulted in a 10% decrease in productivity, it is viewed that its application would be economical compared to P2 medium. Hence, CSL may be used to replace the P2 medium. It was also demonstrated that inclusion of butyrate into the feed was beneficial to the butanol fermentation. A control experiment produced 4.77 g/L of total ABE, and the experiment with supplemented sodium butyrate produced 5.70 g/L of total ABE. The butanol concentration increased from 3.14 to 4.04 g/L. Inclusion of acetate in the feed medium of the immobilized cell biofilm reactor was not found to be beneficial for the ABE fermentation, as reported for the batch ABE fermentation. Names are necessary to report factually on available data. However, the USDA neither guarantees nor warrants the standard of the product, and the use of the names by USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Iodine concentration in different human brain parts

Iodine is one of the most important essential elements as demonstrated by the fact that its deficiency can cause goitre. Nevertheless, quantitative data on its concentration in biological materials, especially in the human brain, are scarce. There is therefore a demand for accurate and reliable information on iodine in these types of samples. The purpose of the present work was to determine the concentration of total iodine in some control human brain parts by rapid radiochemical neutron activation analysis. Our second goal was to determine I distribution between lipid fraction and in brain tissue without lipid by applying two types of solvent extraction methods. The results were checked by the analysis of biological standard reference materials with certified or literature values for iodine and good agreement was found.     

Continuous Reversible Addition‐Fragmentation Chain Transfer Polymerization in Miniemulsion Utilizing a Multi‐Tube Reaction System

Summary: A unique, multi‐tube, continuous reactor has been successfully designed and implemented for the study of reversible addition‐fragmentation chain transfer (RAFT) in miniemulsions. Data collection is greatly enhanced by the ability to simultaneously collect samples at five different residence times. The results of a styrene homopolymerization show that kinetically, the reactor exhibits similar behavior to a batch reaction. Number‐average molecular weights increased linearly with conversion, typical of living polymerizations.

The number‐average molecular weight of the polymers produced in the tubular reactor increased linearly with conversion, indicative of a controlled polymerization.