高功率光子晶体光纤放大器实验研究

利用掺Yb³⁺的光子晶体光纤作为光纤放大器的增益介质,采用反向抽运方式,分别从理论和实验方面研究了不同信号的增益特性,在信号光功率为6W,抽运光功率为160W时,获得了104W的输出功率.实验发现,当抽运功率大于一定值时,放大器输出会有一定的不稳定性,并影响输出功率的进一步提高. 关键词： 光子晶体光纤 光纤放大器 反向抽运 高功率     

Electrical characterization of high-k gate dielectrics on semiconductors

This paper reviews the following electrical characterization techniques for measuring the microscopic bonding structures, impurities, and electrically active defects in advanced CMOS gate stacks: (1) inelastic electron tunneling spectroscopy (IETS), (2) lateral profiling of threshold voltages, interface-trap density, and oxide charge density distributions along the channel of a MOSFET, and (3) pulse agitated substrate hot electron injection (PASHEI) technique for measuring trapping effects in the gate dielectric at low and modest gate voltages.     

清洁、大流量真空差分系统的研制

本研究是为了设计一套大流量、清洁的真空差分系统. 计算了超重反冲核实验装置终端真空差分系统各级的真空度; 介绍了差分系统的设计和真空泵、测量设备选择; 选择能在高压强下连续运行的新型分子/增压泵作为过渡流范围内的主排气泵, 对分子增压泵进行了性能测试并对差分系统进行了模拟靶室实验, 最后对实验结果进行了分析.     

烟火泵浦钕玻璃激光器出光实验研究

 烟火泵浦是激光器小型化、便携化的一种解决方法。研制了一种用于钕玻璃激光器泵浦源的化学试剂,其主要成分为金属粉和碱金属含氧酸盐。设计了烟火泵浦钕玻璃激光器实验装置,激光器采用平-凹腔结构、紧包型侧面泵浦,输出镜反射率98％,钕玻璃棒尺寸f8 mm×100 mm。采用A,B两种配方的泵浦源进行出光实验,A配方得到了波长为1 053 nm能量为29 mJ的激光,B配方没有出光。分别计算了两种泵浦源的阈值辐射强度,并与测量得到的药剂辐射强度平均值比较。A配方所提供的辐射强度2.68×104 W·sr^-1,大于阈值2.37×104 W·sr^-1;B配方小于阈值,未能出光。这与实验结果吻合,证明烟火泵浦方法可行。     

微腔中单量子点的激光输出特性研究

研究一个四能级量子点耦合到单模光学腔中的量子系统,利用系统的主方程作数值模拟计算微腔中单量子点的激光输出强度随非相干泵浦的变化关系.结果显示量子点在泵浦作用下激光的输出有一个阈值;且量子点和腔模耦合强度增强时,产生激光的阈值明显减小,输出激光的峰值却增大.当泵浦作用继续增强到一定程度,因激光能级间的相干性被过强的非相干泵浦所破坏,单量子点激光输出变为零----出现了淬灭现象.     

分区域主动冷却薄片激光介质的理论和实验研究

针对薄片激光介质抽运和温度分布不均匀的问题, 设计了分区域主动冷却控制薄片激光器. 根据热传导方程, 对端面抽运方形薄片激光介质在均匀冷却和分区域主动冷却两种冷却方式下的温度和应力分布进行了模拟计算. 结果显示: 分区域主动冷却能使薄片介质横向温度分布趋于均匀, 相对于均匀冷却时最大温差的改善率达到了约86%, 介质边缘的张应力转变为低值压应力,有效地抑制了热应力炸裂. 搭建了分区域主动冷却控制实验装置, 并进行了验证实验, 实验结果与模拟结果相符. 为薄片激光器的热管理方式提供了新的思路. 关键词： 薄片激光器 端面抽运 分区域主动冷却 数值模拟     

LD泵浦Nd∶YAG微片激光器异常强度噪声研究

针对实验中发现LD泵浦Nd∶YAG微片激光器的三类异常强度噪声,其强度波动幅度达20%~30%,严重影响了系统的稳定性,从理论和实验上对这三类强度噪声的特性进行了研究,包括外部光回馈引入的功率波动,LD异常噪声向固体激光器的传递,端泵浦偏离引起的模式耦合等。就各类噪声来源分别提出了相应的消除方法,抑制了微片Nd∶YAG激光器输出功率噪声,改善了激光输出特性,满足了频差精密测量的需要。     

Crossed Molecular Beam Study of the F+D2(v=1, j=0) Reaction

The reaction dynamics of the fluorine atom with vibrationally excited D₂(v=1, v=0) was investigated using the crossed beam method. The scheme of stimulated Raman pumping was employed for preparation of vibrationally excited D₂ molecules. Contribution from the reaction of spin-orbit excited F^?(²P_1/2) with vibrationally excited D₂ was not found. Reaction of spin-orbit ground F(²P_3/2) with vibrationally excited D2 was measured and DF products populated in v‘=2, 3, 4, 5 were observed. Compared with the vibrationally ground reaction, DF products from the vibrationally excited reaction of F(²P_3/2)+D₂(v=1, j=0) are rotationally “hotter”. Differential cross sections at four collision energies, ranging from 0.32 kcal/mol to 2.62 kcal/mol, were obtained. Backward scattering dominates for DF products in all vibrational levels at the lowest collision energy of 0.32 kcal/mol. As the collision energy increases, angular distribution of DF products gradually shifts from backward to sideway. The collision-energy dependence of differential cross section of DF(v’=5) at forward direction was also measured. Forward-scattered signal of DF(v'=5) appears at thecollision energy of 1.0 kcal/mol, and becomes dominated at 2.62 kcal/mol.     

掺铒光纤激光器自脉冲行为的研究

对掺饵光激光器的自脉冲行为进行了研究。采用半导体激光器连续光泵浦，在较低的泵浦功率下，在掺饵光纤激光器中得到了稳定的１倍周期和２倍周期自脉冲输出，观察到周期性的不等幅脉冲序列输出，在理论上动用光子寿命可变的正交偏振激光场耦合模型对实验进行了分析。结果表明，掺饵光纤激光器中两正交偏振模光子寿命的调节对获得稳定的自脉冲有着十分重要的作用。     

A 20 W Cr, Tm, Ho: YAG laser

A 2.1 μm Cr³⁺, Tm³⁺, Ho³⁺ : YAG laser is operated with an output power of 20 W at 12 Hz. The laser output is successfully transmitted through a silica fibre. The laser system was designed based on the technology of an alexandrite laser oscillator.