Chemical Solution Deposition of ZnO Thin Films by an Aqueous Solution Gel Precursor Route

An aqueous chemical solution deposition method was used to prepare thin films of ZnO on SiO₂/Si (1 1 1) substrates. Starting from an aqueous solution of Zn acetate, citric acid and ammonia, very thin films could be deposited by spin coating. Heating parameters, necessary for thin film annealing, were determined using FTIR experiments on dried gel precursors, heated up to different temperatures. The morphology and the thickness of the films were investigated by SEM. It is found that homogeneous thin films with grain sizes of about 20 nm are formed. XRD experiments show that there is an indication that the films, crystallized at 500°C, exhibit preferential grain growth along the c-axis.     

Rate Coefficient for Self-Association Reaction of CF2 Radicals Determined in the Afterglowof Low-Pressure C4F8 Plasmas

We have analyzed decay kinetics of CF₂ radicals in the afterglow of low-pressure, high-density C₄F₈ plasmas. The decay curve of CF₂ density has been approximated by the combination of first- and second-order kinetics. The surface loss probability evaluated from the frequency of the first-order decay process has been on the order of 10^–4. This small surface loss probability has enabled us to observe the second-order decay process. The mechanism of the second-order decay is self-association reaction between CF₂ radicals (CF₂+CF₂C₂F₄). The rate coefficient for this reaction has been evaluated as (2.6–5.3)×10^–14 cm³/s under gas pressures of 2 to 100 mTorr. The rate coefficient was found to be almost independent of the gas pressure and has been in close agreement with known values, which are determined in high gas pressures above 1 Torr.     

氢氧化铝/环氧树脂复合材料的电荷衰减特性

环氧树脂电气绝缘性能优良, 但是其在脉冲功率设备中充当绝缘子时, 表面容易带电且不易衰减, 当表面电荷集聚到一定的程度会造成局部放电甚至发展为沿面闪络。为了提高环氧树脂的沿面闪络性能, 用中心粒径为1 m的氢氧化铝(ATH)无机填料来改善环氧树脂复合材料的表面性能。分别制备了ATH填料质量分数为0%(纯环氧) , 20%, 40%, 60%, 80%和100%的ATH/环氧树脂复合材料试样。用电声脉冲法研究了ATH填料对环氧树脂复合材料电荷衰减性能的影响, 对比了试样直流极化场强为10 kV/mm和30 kV/mm的试验结果。结果表明：ATH/环氧树脂复合材料电荷的衰减常数不仅与填料的质量分数有关, 而且与试样的带电量有关。     

Kinetic Analysis of the Hydrolysis of Pentose-1-phosphates through Apparent Nucleoside Phosphorolysis Equilibrium Shifts**

Herein, we report an addition to the toolbox for the monitoring and quantification of the hydrolytic decay of pentose-1-phosphates, which are known to be elusive and difficult to quantify. This communication describes how apparent equilibrium shifts of a nucleoside phosphorolysis reaction can be employed to calculate hydrolytic loss of pentose-1-phosphates based on the measurement of post-hydrolysis equilibrium concentrations of a nucleoside and a nucleobase. To demonstrate this approach, we assessed the stability of the relatively stable ribose-1-phosphate at 98 °C and found half-lives of 1.8–11.7 h depending on the medium pH. This approach can be extended to other sugar phosphates and related reaction systems to quantify the stability of UV-inactive and hard-to-detect reaction products and intermediates.     

MODs vs. NPs: Vying for the Future of Printed Electronics

This Minireview compares two distinct ink types, namely metal-organic decomposition (MOD) and nanoparticle (NP) formulations, for use in the printing of some of the most conductive elements: silver, copper and aluminium. Printing of highly conductive features has found purpose across a broad array of electronics and as processing times and temperatures reduce, the avenues of application expand to low-cost flexible substrates, materials for wearable devices and beyond. Printing techniques such as screen, aerosol jet and inkjet printing are scalable, solution-based processes that historically have employed NP formulations to achieve low resistivity coatings printed at high resolution. Since the turn of the century, the rise in MOD inks has vastly extended the range of potentially applicable compounds that can be printed, whilst simultaneously addressing shelf life and sintering issues. A brief introduction to the field and requirements of an ink will be presented followed by a detailed discussion of a wide array of synthetic routes to both MOD and NP inks. Unindustrialized materials will be discussed, with the challenges and outlook considered for the market leaders: silver and copper, in comparison with the emerging field of aluminium inks.     

Cathodoluminescence from deformed doped MgO crystals

The cathodoluminescence (CL) from indented Fe doped MgO single crystals has been studied with the scanning electron microscope and the results have been compared with the CL from undoped crystals. As in the undoped crystals, the iron doped crystals show in the deformed regions an enhanced luminescence emission but it has been found that iron acts as a quencher of luminescence. The results indicate that in the blue emission of the deformed crystals there is not a noticeable contribution of iron. From the evolution of CL with the irradiation time in the electron microscope it is concluded that the total Fe content influences the CL emission more than the Fe³⁺ content.     

Organophosphine/phosphite‐stabilized silver(I) complexes bearing N‐acetylbenzamide ligand: synthesis,characterization and potential application in metal organic chemical vapor deposition

New N‐silver(I) acetylbenzamide complexes of type L_n?AgNC₉H₈O₂ (L = PPh₃; n = 1, 2a; n = 2, 2b; n = 3, 2c; L = P(OEt)₃; n = 1, 2d; n = 2, 2e; n = 3, 2f) were prepared. These complexes were obtained in high yields and characterized by elemental analysis, ¹H NMR, ¹³C{H} NMR, ³¹P{H} NMR and IR spectroscopy, respectively. The molecular structure of 2b has been determined by X‐ray single‐crystal analysis in which the silver atom is in a distorted tetrahedral geometry and crystallizes as cis–trans. New N‐silver(I) acetylbenzamide complexes have a four‐membered ring, which could influence their chemical and physical properties and modulate volatility. Metal organic chemical vapor deposition experiments were carried out successfully at 400°C and 450°C using 2e as precursor for the deposition of silver films, respectively. The high‐purity silver film obtained at 400°C is dense and homogeneous. Copyright © 2012 John Wiley & Sons, Ltd.     

Acoustic phonon impact on the inter-Coulombic decay process in charged quantum dot pairs

ABSTRACT

Recently, highly accurate multi-configuration time-dependent Hartree electron dynamics calculations demonstrated the efficient long-range energy transfer inter-Coulombic decay (ICD) process to happen in charged semiconductor quantum dot (QD) pairs. ICD is initiated by intraband photoexcitation of one of the QDs and leads to electron emission from the other within a duration of about 150 ps. On the same time scale electronically excited states are reported to relax due to the coupling of electrons to acoustic phonons. Likewise, phonons promote ionisation. Here, the QDs' acoustic breathing mode is implemented in a frozen-phonon approach. A detailed comparison of the phonon effects on electron relaxation and emission as well as on the full ICD process is presented, which supports the previous empirical finding of ICD being the dominant decay channel in paired QDs. In addition the relative importance of phonon–phonon, phonon–electron and electron–electron interaction is analysed.     

Preparation of Zn(Cd)O:Ga–SiO2 composite scintillating materials

Composite material consisting of highly luminescent Zn(Cd)O:Ga powder embedded in the silica matrix was prepared. It was found out that ZnO:Ga with less developed crystals (i.e. annealed at lower temperatures) is more prone to interact with the SiO₂ matrix and form zinc silicates, which in turn resulted in the decrease in the excitonic emission. Pre-annealing of the powders at temperatures above 600 °C prevented the interaction with the SiO₂ matrix. ZnO:Ga with well-developed crystals at such a high temperatures was not affected by the matrix and retained its properties, i.e. high radioluminescence intensity and ultrafast sub nanosecond photoluminescence decay. Introducing Cd into the ZnO lattice caused observable red shift in the excitonic luminescence, without negatively affecting the total intensity or the decay.     

Global existence and time decay estimate of solutions to the Keller–Segel system

We consider the chemotaxis‐Navier–Stokes system 1.1-1.4 (Keller–Segel system) in the whole space, which describes the motion of oxygen‐driven bacteria, eukaryotes, in a fluid. We proved the global existence and time decay estimate of solutions to the Cauchy problem 1.1-1.2 in with the small initial data. Moreover, when the fluid motion is described by the Stokes equations, we established the global weak solutions to 1.3-1.4 in with the potential function ? is small and the initial density n₀(x) has finite mass.