Protection of immobilized sulfhydryl groups against autooxidation by alterations in their microenvironment

Immobilized sulfhydryl groups were prepared by partial thiolation of NH₂-glass beads. The microenvironment of the immobilized SH groups was varied by different chemical modifications of neighboring NH₂ groups. Introduction of a strong charge in the surroundings of immobilized sulfhydryls results in their dramatic stabilization against autooxidation. This effect is due to the salting of O₂ from the surface microlayer of the thiolated beads.     

高能Zn离子注入CaF2基质形成ZnO纳米粒子的机制、构型及电子结构

将高能Zn2+注入到CaF2介电基质中,在CaF2的表面下注入Zn2+浓度呈近似高斯分布,通过氧气氛后经热退火形成ZnO量子点.采用MaterialsStudio和Gaussian98W程序,结合实验结果计算分析了CaF2基质中ZnO纳米粒子的电子结构和光学性质.选取由4个ZnO原胞组成的超晶胞模型计算了ZnO纳米粒子的吸收光谱,理论结果与实验结果相符.对ZnO纳米粒子电子结构的研究结果表明,ZnO纳米粒子与CaF2基质的相互作用主要是ZnO表面的O与基质中Ca之间的作用,这种作用使ZnO纳米晶体的Fermi能级变窄,带隙相应减小;ZnO纳米粒子表面构型的变化对其本征吸收光谱没有影响,理论计算结果与实验值一致.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

ZnO纳米线的电化学制备研究

High-quality ZnO nanowires have been synthesized at relatively low temperature via one-step electrochemical anodization technique. In this method, Zn sheet acted as the anode and Pb sheet served as the counter electrode, and the complex solution of HF-C₂H₅OH-H₂O was used as electrolyte. ZnO nanowires were characterized by Field Emission Scanning Electron Microscopy (FE-SEM), Transmission Electron Microscopy (TEM) and Selected Area Electron Diffraction (SAED) and X-ray Diffraction (XRD). The results show that the nanowires were wurtzite crystalline ZnO, and the ZnO nanowires with the diameters of 70 nm and 30～40 nm were obtained by adjusting preparation conditions, respectively.     

氧化锌薄膜的电化学沉积和表征

以透明导电玻璃(TCO)为衬底，用硝酸锌水溶液作为电解液，研究了阴极还原沉积ZnO薄膜的反应机理和电化学行为. 通过改变工艺条件来控制ZnO的生长速率， 得到了粒径为10～15 nm的纳米ZnO薄膜. XRD分析显示纳米ZnO薄膜纯度高， 呈纤锌矿结构. 光学测试结果表明，在可见光区其透光度高达90%，禁带宽度为3.37 eV.     

Preparation of ZnO Nanoparticles: Structural Study of the Molecular Precursor

The structure of zinc acetate derived precursor currently used in the sol-gel synthesis of ZnO nanoparticles is described. The reaction products obtained before and after reflux of ethanolic zinc acetate solution have been studied by UV-Vis, photoluminescence, FTIR and EXAFS at the Zn K edge. EXAFS results evidence for both precursor solutions a change from the octahedral coordination sphere of oxygen atoms characteristic of the solid zinc acetate dihydrate compound into a four-fold environment. The EXAFS spectra of precursor solutions can be satisfactorily reproduced using the molecular structure reported for Zn₄O(Ac)₆ (Ac = COOCH₃). UV-Vis and FTIR measurements are also in agreement with the formation of this oligomeric precursor. The structural modification is more pronounced after reflux at 80°C, because the increase of the Zn₄O(Ac)₆ amount and the formation of nearly 3.0 nm sized ZnO nanoparticle.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

Rigid aromatic fractal polyamides

The preparation of rigid aromatic, highly branched polyamides is described. Owing to the method of preparation and the chosen ratio of difunctional to trifunctional monomers, these entities are highly porous and not dendrimeric in nature. They better conform with the fractal model and are therefore called fractal polyamides (FPs). The effects of variations in the polymerization procedure, in total monomer concentration, in the ratio of amine to carboxyl groups and in the duration of the polycondensation reaction are investigated. Some characterization was performed and the results are presented and briefly discussed.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

一种制备大量氧化锌纳米管的简单方法(英)

ZnO nanotubes were synthesized in large scale by thermal decomposition of the precursors obtained via chemical reaction between Zn(CH₃COO)₂·2H₂O and NaHCO₃ in the presence of surfactant sodium dodecyl sulfate (SDS). The inner diameters of the tubes were in the range of 80～100 nm, and outer diameters in the range of 160～260 nm with lengths up to a few micrometers. The products were characterized with XRD, TEM, and SEM.