电感耦合等离子体发射光谱法测定钇铝石榴石中掺杂Yb(Ⅲ)离子

采用碳酸钠-硼砂(质量比1：1)做熔剂分解钇铝石榴石,并确定了熔剂的最优化条件．以电感耦合等离子体光谱法对样品中掺杂Yb(Ⅲ)离子作了定量检测考察了样品和熔剂中单个基体和混合基体对分析结果的影响．发现单个基体Y对Yb的测定有增强效应．基体A1对Yb的测定有一定的抑制作用;基体对Yb测定的干扰可通过基体匹配进行消除元素的俭出限为2μg／L,标准加入回收率为88％～100％实际样品7次检测的RSD为2．1％。本方法可以较好地满足实际样品分析的需要。     

Comparative Study of Natural Terpenoid Precursors in Reactive Plasmas for Thin Film Deposition

If plasma polymer thin films are to be synthesised from sustainable and natural precursors of chemically heterogeneous composition, it is important to understand the extent to which this composition influences the mechanism of polymerisation. To this end, a well-studied monoterpene alcohol, terpinen-4-ol, has been targeted for a comparative study with the naturally occurring mix of terpenes (viz. Melaleuca alternifolia oil) from which it is commonly distilled. Positive ion mode mass spectra of both terpinen-4-ol and M. alternifolia oil showed a decrease in disparities between the type and abundance of cationic species formed in their respective plasma environments as applied plasma power was increased. Supplementary biological assay revealed the antibacterial action of both terpinen-4-ol and M. alternifolia derived coatings with respect to S. aureus bacteria, whilst cytocompatibility was demonstrated by comparable eukaryotic cell adhesion to both coatings. Elucidating the processes occurring within the reactive plasmas can enhance the economics of plasma polymer deposition by permitting use of the minimum power, time and precursor pre-processing required to control the extent of monomer fragmentation and fabricate a film of the desired thickness and functionality.     

Multibubble Sonoluminescence from a Theoretical Perspective

In the present review, complexity in multibubble sonoluminescence (MBSL) is discussed. At relatively low ultrasonic frequency, a cavitation bubble is filled mostly with water vapor at relatively high acoustic amplitude which results in OH-line emission by chemiluminescence as well as emissions from weakly ionized plasma formed inside a bubble at the end of the violent bubble collapse. At relatively high ultrasonic frequency or at relatively low acoustic amplitude at relatively low ultrasonic frequency, a cavitation bubble is mostly filled with noncondensable gases such as air or argon at the end of the bubble collapse, which results in relatively high bubble temperature and light emissions from plasma formed inside a bubble. Ionization potential lowering for atoms and molecules occurs due to the extremely high density inside a bubble at the end of the violent bubble collapse, which is one of the main reasons for the plasma formation inside a bubble in addition to the high bubble temperature due to quasi-adiabatic compression of a bubble, where “quasi” means that appreciable thermal conduction takes place between the heated interior of a bubble and the surrounding liquid. Due to bubble–bubble interaction, liquid droplets enter bubbles at the bubble collapse, which results in sodium-line emission.     

Electron kinetics of collision dominated r.f. bulk plasma in CO: The role of second-kind collisions

Electron energy distribution functions (EEDF) and related properties in the bulk region of the rf CO plasma at the reduced rf field frequency /p₀=×10⁷ sec^–1 torr^–1 have been calculated by solving the time-dependent spatially homogeneous Boltzmann equation in the presence of second-kind collisions and have been interpreted on a microphysical basis. The results show that second-kind collisions (vibrational and electronic) strongly affect the temporal evolution of EEDF, of the mean energy, and of the mean collision frequencies for vibrational and electronic excitation processes, as well as for ionization. In particular, second-kind collisions in the CO rf bulk plasma strongly decrease the modulation of the mean ionization frequency during its periodical alteration in the rf field. Furthermore, the effect of second-kind collisions on an approximate determination of the time-averaged EEDF in the rf bulk plasma using the so-called effective-field appriximation has been estimated.     

Laser Doppler anemometry under plasma conditions. Part II. Measurements in an inductively coupled r.f. plasma

Laser Doppler anemometry is used for the measurements of the plasma and particle velocity profiles in the coil region of an inductively coupled r.f. plasma. Results are reported for a 50 mm i.d. induction plasma torch operated at atmospheric pressure with argon as the plasma gas. The oscillator frequency is 3 MHz and the plate power is varied between 4.6 and 10.5 kW. Plasma velocity measurements are obtained using a fine carbon powder as a tracer. Measurements are also given for larger silicon particles ( ) centrally injected into the discharge under different operating conditions.Nomenclature d _p particle diameter - P ₀ plasma power - Q ₁ powder carrier gas flow rate - Q ₂ plasma gas flow rate - Q ₃ sheath gas flow rate - r distance in the radial direction - V axial plasma velocity - V _p axial particle velocity - Z distance in the axial direction - standard deviation     

氨基羧酸纤维分离富集-电感耦合等离子体原子发射光谱法测定多种痕量稀土元素

本文制备了氨基羧酸纤维滤纸片作为柱填充物，成功地分离和富集了地化样品中的多种稀土元素。富集后的稀土元素采用电感耦合等离子体原子发射光谱法测定，回收率为90％～109％。本文还对基体干扰及其消除进行了研究。     

滑动弧电极放电等离子体作用甲烷制C2烃的工艺

采用刀片式不锈钢电极放电反应器,以Ar气为稀释气,研究了等离子体作用下甲烷转化制C2烃的工艺条件。考察了CH4流量、高频电源输入电压和电极间距等参数对甲烷转化率、C2烃选择性、收率和反应表观能耗的影响。结果表明,增加CH4流量,表观能耗随之降低;当输入电压和电极间距较小时,甲烷转化率随输入电压和电极间距的增大而增大,但输入电压和电极间距过大时,C2烃收率明显下降,积碳严重。在CH4流量14 mL/min、Ar气流量60 mL/min、高频电源输入电压22 V、电流0.44 A、电极间距4 mm的优化条件下,甲烷最高转化率为43.1%,C2烃收率、选择性和表观能耗分别为40.1%、93.2%和2.41 MJ/mol。C2烃中不饱和烃的体积分数可达95%以上。     

Effect of Plasma Treatment on the Structures and Properties of Konjac Glucomannan Film

To understand the effect of plasma treatment on the Konjac glucomannan film, the nitrogen plasma was injected into the film by ion beam injection machine in this study. The structures and properties of Konjac glucomannan film after plasma treatment were analyzed by Infrared spectroscopy, Raman spectrum, X-ray, ect. The result showed that nitrogen groups appeared in the KGM molecular chain and part of this chain fractured, and the number of hydrogen bonds increased after the treatment of plasma. The form of KGM molecule remained amorphous non-crystalline state, but the crystalline region was increased and became more ordered. The mechanical property of tensile strength and breaking elongation was improved, while the WVP was decreased. The nitrogen groups were grafted on the KGM molecular chain after plasma treatment, which led to the improvement of the properties of KGM film.     

The effect of cooking and washing rice on the bio-accessibility of As,Cu, Fe,V and Zn using an on-line continuous leaching method

A previously developed method based on continuous on-line leaching with artificial gastro-intestinal fluids was used to determine the bio-accessible fraction of As, Cu, Fe, V and Zn in brown and white rice from California by inductively coupled mass spectrometry (ICP-MS). Saliva generally accounted for the largest percentage of total element leached in comparison to gastric and intestinal juices. Arsenic speciation analysis was performed on the saliva and gastric juice leachates using ion exchange chromatography coupled to ICP-MS. The four most toxic species of As (As(III), monomethylarsonic acid (MMA), dimethylarsinic acid (DMA) and As(V)), as well as Cl⁻ in the gastric juice leachate, were successfully separated within 5.5 min using a simple nitric acid gradient. While cooking rice had relatively little effect on total bio-accessibility, a change in species from As(V) and DMA to As(III) was observed for both types of rice. On the other hand, washing the rice with doubly deionized water prior to cooking removed a large percentage of the total bio-accessible fraction of As, Cu, Fe, V and Zn.     

Ion exchange chromatography coupled to inductively coupled plasma mass spectrometry for the study of Pt electro-dissolution

There is an ongoing debate regarding the mechanism of Pt electrochemical dissolution. However, only off-line methods have so far been used, where separation of Pt species is performed separately from their detection. In this study, ion exchange chromatography coupled to inductively coupled plasma mass spectrometry was used for the first time to separate and detect Pt species generated by the electro-dissolution of a Pt electrode in 0.5 M aqueous H₂SO₄ solution. Because these species are either neutral or cationic, they were converted to chloro-complexes using 0.1 M KCl to enable their separation by anion exchange chromatography. Chloro-aqua complexes were observed in addition to the two predominant species, namely PtCl₄²⁻ and PtCl₆²⁻. A good linear relationship was observed between the sum of peak areas for all complexes of a given Pt oxidation state and the Pt concentration, with a detection limit of 0.1 μg L⁻¹ being reached for Pt(II) and Pt(IV). Application of this speciation analysis method to real samples generated by potential cycling using cyclic voltammetry (CV) revealed that, in general, at least 80% of Pt was present as Pt(II), irrespectively of the cyclic potential range or of temperature (up to 60 °C). Still, quantitative spike recovery was achieved after adding known amounts of Pt(II) or Pt(IV) to a sample prepared by CV, which demonstrated that no significant species inter-conversion took place.