探索性物理实验的双重教育功能

利用现代教育理论，结合物理实验的教学实际，探讨和研究了探索性物理实验的双重教育功能．通过具体的探索性物理实验案例，验证了探索性物理实验具有激发学生的兴趣、发展学生的探索精神和唤起教师创造性的双重教育功能．     

Temperature factor effect on the structure of the separated flow within a supersonic gas stream

The effect of the temperature factor, that is, the ratio of the body temperature to the freestream stagnation temperature, on the structure of the separated flow formed in the presence of a concave corner in a supersonic stream is studied. The strong influence of the temperature factor on the separation zone length and the flow-generated aerodynamic characteristics is established. It is shown that for fairly large deflection angles this flow cannot be described by free interaction, or triple deck, theory.     

Physics in Melbourne

I survey highlights of the practice of physics and allied sciences in Melbourne,Australia, from the 1850s, soon after Europeans first settled in the area, to the present. I note recognizable sites of past and current physical-science activity that may be visited, as well as exhibits of historic items of physics apparatus. I trace the role of physics, in the course of a century and a half, in the evolution of a pioneering settlement into a large city embedded in a modern industrial economy.     

Solc型双折射滤波器离轴消光比的研究

提出了一种Solc型双折射滤波器的离轴消光比的一般性计算方法，利用所得结果模拟出了Solc型双折射滤波器的锥光干涉图以及发散光积分消光比与波长和发散角的关系曲线，实验结果证实了理论推算的合理性，此外本方法也适用于计算各种类型双折射滤波器的离轴消光比。     

均匀分层介质中标准矢量波函数的构成

研究了在均匀分层介质中构成标准矢量波函数的必要条件。研究结果表明在均匀分层介质中构成标准矢量波函数一般需遵循Morse-Feshbach判据外，领示矢量只能选取与折射率变化方向一致的那根坐标轴单位矢量。但在某些特定的条件下，对领示矢量的选取条件可以放宽为只需遵循Morse-Feshbach判据即可。     

基于积分方法的二维平行剪切层声远场预测

本文采用二维Ffowcs Williams＆Hawkings(FW-H)方程对平行剪切层远声场辐射特性进行了研究。近流场时间精确数据通过计算气动声学(Computational Aeroacoustics,CAA)技术数值模拟获得,声远场信息则通过FW-H方程对近流场内的可穿透积分面进行积分获得。该方法首先采用具有解析解的涡/尾缘干涉问题进行了校核,进一步采用CAA/FW-H匹配技术对二维平行剪切层声辐射问题进行了预测,计算结果表明,积分解与计算域内的CAA数值解吻合较好。     

胶束薄层色谱法测定食品及药用胶囊中的合成食用色素

在聚酰胶片上以13%SDBS(十二烷基苯磺酸钠)+7%Triton X-100〔聚乙二醇-对-(1.1,3,3-四甲基)丁基苯基醚〕+(2+3)氨水(1+5+1)为展开剂,用胶束薄层色谱法分离和测定了柠檬黄、亮蓝、苋菜红、胭脂红和赤藓红。测定波长分别为440、632、535、525和528 nm,线性范围分别为0.1～2、0.05～1、0.05～1、0.05～1和0.05～1μg/斑点。方法用于测定软饮料糖果及药用胶囊中的合成色素,获得了满意的结果。此外,还对展开剂的最佳组成进行了单纯形法优化。     

Asymptotic analysis and estimates of blow‐up time for the radial symmetric semilinear heat equation in the open‐spectrum case

We estimate the blow‐up time for the reaction diffusion equation u_t=Δu+ λf(u), for the radial symmetric case, where f is a positive, increasing and convex function growing fast enough at infinity. Here λ>λ^*, where λ^* is the ‘extremal’ (critical) value for λ, such that there exists an ‘extremal’ weak but not a classical steady‐state solution at λ=λ^* with ∥w(?, λ)∥_∞→∞ as 0<λ→λ^*?. Estimates of the blow‐up time are obtained by using comparison methods. Also an asymptotic analysis is applied when f(s)=e^s, for λ?λ^*?1, regarding the form of the solution during blow‐up and an asymptotic estimate of blow‐up time is obtained. Finally, some numerical results are also presented. Copyright © 2007 John Wiley & Sons, Ltd.     

Number albedo measurements from stratified layers of iron,concrete and aluminium

A layer of stratified combination composed of selected radiation shielding materials acquires better shielding property. Albedo is used in such measurements as an integral measure ofγ-ray scattering. The stratified slabs of alternating heterogeneous layers have been found to have a virtual homogeneous property with a definite effective atomic number. The angular distribution of back-scattered photons as well as the total number albedo values for iron, aluminium and concrete in stratified combination for 662 keV and 1250 keV photons are reported.     

An efficient algorithm for elasto-viscoplastic vibrations of multi-layered composite beams using second-order theory

An efficient time-domain algorithm for plane non-linear flexural vibrations of multi-layered composite beams, which are driven into the inelastic range by severe transverse loadings, is presented. The influence of an axial static preload is considered in the sense of the quasi-linear second-order theory of structures. The inelastic parts of strain are treated as additional sources of selfstress in the linear elastic background-structure, driving the elastic response into the inelastic one. The efficiency of this exact formulation lies in the fact that linear solution techniques can be used in their most powerful form: Rubin's useful formulation for the quasi-static second-order transfer-matrix of linear elastic structures is applied in combination with modal analysis. Having in mind multi-metal beams, the classical lamination theory is assumed to be valid. Beams with overhang composed of ideal elastic-plastic and viscoplastic layers are studied as example structures. The fictitious sources of selfstress are calculated from the different material laws of the layers in a numerical time-stepping procedure, where a generalized midpoint-rule in combination with Crisfield's secant-Newton procedure is used.