Desorption behavior of a surfactant in a linear low‐density polyethylene blend at elevated temperatures

The desorption behavior of a surfactant in a linear low‐density polyethylene (LLDPE) blend at elevated temperatures of 50, 70, and 80 °C was studied with Fourier transform infrared spectroscopy. The composition of the LLDPE blend was 70:30 LLDPE/low‐density polyethylene. Three different specimens (II, III, and IV) were prepared with various compositions of a small molecular penetrant, sorbitan palmitate (SPAN‐40), and a migration controller, poly(ethylene acrylic acid) (EAA), in the LLDPE blend. The calculated diffusion coefficient (D) of SPAN‐40 in specimens II, III, and IV, between 50 and 80 °C, varied from 1.74 × 10^?11 to 6.79 × 10^?11 cm²/s, from 1.10 × 10^?11 to 5.75 × 10^?11 cm²/s, and from 0.58 × 10^?11 to 4.75 × 10^?11 cm²/s, respectively. In addition, the calculated activation energies (E_D) of specimens II, III, and IV, from the plotting of ln D versus 1/T between 50 and 80 °C, were 42.9, 52.7, and 65.6 kJ/mol, respectively. These values were different from those obtained between 25 and 50 °C and were believed to have been influenced by the interference of Tinuvin (a UV stabilizer) at elevated temperatures higher than 50 °C. Although the desorption rate of SPAN‐40 increased with the temperature and decreased with the EAA content, the observed spectral behavior did not depend on the temperature and time. For all specimens stored over 50 °C, the peak at 1739 cm^?1 decreased in a few days and subsequently increased with a peak shift toward 1730 cm^?1. This arose from the carbonyl stretching vibration of Tinuvin, possibly because of oxidation or degradation at elevated temperatures. In addition, the incorporation of EAA into the LLDPE blend suppressed the desorption rate of SPAN‐40 and retarded the appearance of the 1730 cm^?1 peak. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 1114–1126, 2004     

Effects of poly[styrene‐b‐(ethylene‐co‐butylene)‐b‐styrene] on the charge distributions of low‐density polyethylene/polystyrene blends

The effect of the triblock copolymer poly[styrene‐b‐(ethylene‐co‐butylene)‐b‐styrene] (SEBS) on the formation of the space charge of immiscible low‐density polyethylene (LDPE)/polystyrene (PS) blends was investigated. Blends of 70/30 (wt %) LDPE/PS were prepared through melt blending in an internal mixer at a blend temperature of 220 °C. The amount of charge that accumulated in the 70% LDPE/30% PS blends decreased when the SEBS content increased up to 10 wt %. For compatibilized and uncompatibilized blends, no significant change in the degree of crystallinity of LDPE in the blends was observed, and so the effect of crystallization on the space charge distribution could be excluded. Morphological observations showed that the addition of SEBS resulted in a domain size reduction of the dispersed PS phase and better interfacial adhesion between the LDPE and PS phases. The location of SEBS at a domain interface enabled charges to migrate from one phase to the other via the domain interface and, therefore, resulted in a significant decrease in the amount of space charge for the LDPE/PS blends with SEBS. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 2813–2820, 2004     

Carousels,Zindler curves and the floating body problem

A carousel is a dynamical system that describes the movement of an equilateral linkage in which the midpoint of each rod travels parallel to it. They are closely related to the floating body problem. We prove, using the work of Auerbach, that any figure that floats in equilibrium in every position is drawn by a carousel. Of special interest are such figures with rational perimetral density of the floating chords, which are then drawn by carousels. In particular, we prove that for some perimetral densities the only such figure is the circle, as the problem suggests.     

The evolution of a truncated gaussian probability density through time—modelling animal liveweights after selection

The form of the probability density derived from the evolution in time of a previously truncated frequency distribution of animal Liveweights is of interest in animal husbandry. Truncated frequency distributions arise when the heavier animals are sold for slaughter and the lighter animals retained. The demands of modern quality assurance schemes require that, given information on animal growth, the farmer is able to estimate the number of animals that would meet the specifications at some time in the future after truncation. Assuming that animal growth can be described by a linear stochastic differential equation, we derive an explicit expression for the probability density of animal Liveweights at any time after the truncation of an initial Gaussian density. It is shown that this probability density converges rapidly to a Gaussian density, so that after about 20 days of typical growth rates for lambs, the resulting density is practically indistinguishable from Gaussian.     

F／Cl比与Eu~（2＋）：BaFCl中F色心的浓度和光激励截面的关系

研究了Ｅｕ（２＋）：ＢａＦｘＣｌ２在紫外线辐照下的光激励发光。通过改变激励方式及激励光的扫描方向，给出了Ｅｕ（２＋）：ＢａＦｘＣｌ２－ｘ光激励发光过程中，两种Ｆ色心的浓度比值与光激励截面比值的测定方法。利用这种测定方法，进一步研究了两种Ｆ色心的浓度比值和光激励截面比值与Ｆ／ＣＩ比值的关系。     

聚类分析在髁突骨密度分析中的应用

本研究应用聚类分析的方法，对人离休髁突×片进行数字图像技术处理所获得的影像密度数值做了详细分析，取得人髁突不同区的骨密度分布及不同年龄阶段髁突密度变化的情况。该方法避免了人为因素的影响，其结果较客观地反映了髁突的骨质密度；为研究病理状态时髁突骨密度的改变提供参考。     

Normalization and Fermi–Coulomb and Coulomb hole sum rules for approximate wave functions

For approximate wave functions, we prove the theorem that there is a one‐to‐one correspondence between the constraints of normalization and of the Fermi–Coulomb and Coulomb hole charge sum rules at each electron position. This correspondence is surprising in light of the fact that normalization depends on the probability of finding an electron at some position. In contrast, the Fermi–Coulomb hole sum rule depends on the probability of two electrons staying apart because of correlations due to the Pauli exclusion principle and Coulomb repulsion, while the Coulomb hole sum rule depends on Coulomb repulsion. We demonstrate the theorem for the ground state of the He atom by the use of two different approximate wave functions that are functionals rather than functions. The first of these wave function functionals is constructed to satisfy the constraint of normalization, and the second that of the Coulomb hole sum rule for each electron position. Each is then shown to satisfy the other corresponding sum rule. The significance of the theorem for the construction of approximate “exchange‐correlation” and “correlation” energy functionals of density functional theory is also discussed. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

Estimating Invariant Probability Densities for Dynamical Systems

Knowing a probability density (ideally, an invariant density) for the trajectories of a dynamical system allows many significant estimates to be made, from the well-known dynamical invariants such as Lyapunov exponents and mutual information to conditional probabilities which are potentially more suitable for prediction than the single number produced by most predictors. Densities on typical attractors have properties, such as singularity with respect to Lebesgue measure, which make standard density estimators less useful than one would hope. In this paper we present a new method of estimating densities which can smooth in a way that tends to preserve fractal structure down to some level, and that also maintains invariance. We demonstrate with applications to real and artificial data.     

Molecular dynamics simulations on the structures and properties of ε-CL-20-based PBXs ——Primary theoretical studies on HEDM formulation design

Five polymer bonded explosives (PBXs) with the base explosive ε-CL-20 (hexanitrohexaazaisowurtzi- tane), the most important high energy density compound (HEDC), and five polymer binders (Estane 5703, GAP, HTPB, PEG, and F2314) were constructed. Molecular dynamics (MD) method was employed to investigate their binding energies (Ebind), compatibility, safety, mechanical properties, and energetic properties. The information and rules were reported for choosing better binders and guiding formula- tion design of high energy density material (HEDM). According to the calculated binding energies, the ordering of compatibility and stability of the five PBXs was predicted as ε-CL-20/PEG > ε-CL-20/ Estane5703 ≈ε-CL-20/GAP > ε-CL-20/HTPB > ε-CL-20/F2314. By pair correlation function g(r) analyses, hydrogen bonds and vdw are found to be the main interactions between the two components. The elasticity and isotropy of PBXs based ε-CL-20 can be obviously improved more than pure ε-CL-20 crystal. It is not by changing the molecular structures of ε-CL-20 for each binder to affect the sensitivity. The safety and energetic properties of these PBXs are mainly influenced by the thermal capability (C°p) and density (ρ) of binders, respectively.