3C-SiC纳米颗粒量子限制效应的实验证据

报道了关于3C—SiC纳米颗粒量子限制效应的实验证据．将电化学腐蚀3C—SiC多晶靶材得到的多孔材料在水溶液中进行超声处理，制备出发光的3C—SiC纳米颗粒溶液．透射电镜实验表明，所得颗粒直径分布在1-6nm范围，光致发光谱实验给出了存在量子限制效应的实验证据．发光范围在440-460nm．SiC纳米颗粒量子限制效应的发现，为该材料在光电子发光器件中的应用提供了重要的实验基础．     

双轴晶体电光调制器的最优设计

运用新的线性电光效应的耦合波理论，对双轴晶体KTP电光调制器的温度特性进行了理论研究.找到了一个入射光波矢的方向，在该方向上，出射光光强不随温度的变化而变化，而且此方向在一定的角度范围内变动，温度的稳定性是可以保持的.还进一步对晶体的通光长度和外加电场的方向进行了筛选，实现了双轴晶体KTP电光调制器的最优设计. 关键词： 电光效应 耦合波理论 电光调制器 最优设计     

Three-dimensional Monte Carlo simulation of bulk fin field effect transistor

In this paper,we investigate the performance of the bulk fin field effect transistor(FinFET) through a threedimensional(3D) full band Monte Carlo simulator with quantum correction.Several scattering mechanisms,such as the acoustic and optical phonon scattering,the ionized impurity scattering,the impact ionization scattering and the surface roughness scattering are considered in our simulator.The effects of the substrate bias and the surface roughness scattering near the Si/SiO2 interface on the performance of bulk FinFET are mainly discussed in our work.Our results show that the on-current of bulk FinFET is sensitive to the surface roughness and that we can reduce the substrate leakage current by modulating the substrate bias voltage.     

Bottomonium Spectrum with Screened Potential

As a sister work of [Phys. Rev. D 79 (2009) 094004], we incorporate thecolor-screening effect due to light quark pair creation into theheavy quark-antiquark potential, and investigate the effects ofscreened potential on the spectrum of bottomonium. We calculate themasses, electromagnetic decays, and E1 transitions of bottomoniumstates. We find that the fine splittings between χ_bJ (J=0,1,2) states are in good agreement with experimental data, and the E1 transition rates of \Upsilon(2S) → γχ _bJ (1P) and \Upsilon(3S) → γχ _bJ(2P) (J=0,1,2) all agree with data within experimental errors. In particular, the mass of \Upsilon(6S) is lowered down to match that of the \Upsilon(11020), which issmaller than the predictions of the linear potential models by morethan 100~MeV. Comparison between charmonium and bottomonium in somerelated problems is also discussed.     

基于Marangoni界面效应的数控化学抛光去除函数的研究

 利用基于Marangoni界面效应对化学抛光去除函数的理论及实验进行研究,提出采用湿法化学抛光（刻蚀）方法为大口径高精度光学元件的加工提供新的解决途径。介绍了Marangoni界面效应及其验证实验,运用WYKO轮廓仪对熔石英基片局域刻蚀前后的粗糙度进行检测,结果表明,粗糙度基本无变化,刻蚀前后粗糙度分别为0.72 nm和0.71 nm。基于Preston假设, 建立了数控化学抛光理论模型,运用WYKO干涉仪观察实验现象可知,化学抛光刻蚀曲线基本上成平底陡峭的去除函数曲线,小磨头抛光是倒置的仿高斯函数曲线。     

355 nm脉冲激光在甲烷中的高效多波长拉曼转换

 研究了脉冲Nd:YAG激光（355 nm）泵浦的甲烷中多级Stokes光的产生和惰性气体对其转换效率的影响,其中一级和二级Stokes光的最大能量转换效率分别可达71%和38%（对应量子效率为79%和48%）,大大高于已往文献报道的20%。在0.5 MPa下,可同时获得322 nm（3.6%）,355 nm（24.5%）,396 nm（24.3%）,448 nm（22.3%）和515 nm（9.3%）的多波长输出。甲烷压力对多级Stokes转换有显著影响：高气压利于产生高效的一级Stokes光,而低气压则适合于高级Stokes光的产生。根据级联受激拉曼散射(SRS)和四波混频(FWM)理论对实验结果进行了分析,结果表明甲烷中高级Stokes光的产生是SRS和FWM协同作用的结果。加入的氦气增强了甲烷中Stokes光的转换效率,而氩气的作用恰恰相反,利用热透镜效应可以很好地解释这些现象。     

基于可调谐光纤激光器的C2H2气体光声光谱检测

研制了基于可调谐掺Er光纤激光器的共振式光声光谱乙炔气体检测系统,结合波长调制和锁相放大器的二次谐波信号检测技术,有效地消除了光声池窗片和池壁吸收入射光而引起的背景噪声,通过对该系统的光学、声学和电子检测系统的优化,实现了低浓度乙炔气体的流动式检测.实验结果证明,当气体浓度较低时,二次谐波振幅与气体浓度成正比,其线性响应相关度达到0.999 53.在常温常压和3.5 mW平均光功率以及100 ms锁相积分时间条件下,乙炔气体的极限检测灵敏度达到了0.3 ppm(1 ppm=1μg·mL-1)(SNR=1时),系统用可调谐掺Er光纤激光器代替半导体激光器作光源,降低了成本,为发展低成本、实用、便携式微量气体光谱榆测仪器奠定了基础.若采用多光程光声池,或者采用EDFA提高激光功率,可大幅度提高信噪比,将极限检测灵敏度提高至ppb(1 ppb=1 ng·mL-1)量级.     

Superfluidity and Anderson localisation for a weakly interacting Bose gas in a quasiperiodic potential

Using exact diagonalisation and Density Matrix Renormalisation group (DMRG) approach we analyse the transition to a localised state of a weakly interacting quasi-1D Bose gas subjected to a quasiperiodic potential. The analysis is performed by calculating the superfluid fraction, density profile, momentum distribution and visibility for different periodicities of the second lattice and in the presence (or not) of a weak repulsive interaction. It is shown that the transition is sharper towards the maximally incommensurate ratio between the two lattice periodicities, and shifted to higher values of the second lattice strength by weak repulsive interactions. We also relate our results to recent experiments.     

光纤热极化过程的实时测试研究

通过热极化可以使中心对称的熔石英光纤中产生二阶非线性效应和线性电光效应。为了解各热极化过程参量对热极化产生的线性电光效应的影响,利用全保偏光纤马赫一曾德尔干涉仪构造了一套光纤热极化的实时线性电光效应测试系统,并利用其进行了光纤热极化全过程的监控测试。在线测试了热极化过程的一些参量,例如极化电压、极化时间、以及极化温度等对热极化光纤中产生的线性电光效应的影响。实时测试研究表明,在光纤中施加尽可能高的极化电场将可能在光纤中产生较高的线性电光效应。对侧边抛磨光纤结构的热极化器件,考虑到器件的抗强电场击穿能力,可选用3．o～4．0kV左右的极化直流电压。当施加3．0kV左右的极化电压时,热极化优化时间约为16min,最佳热极化加热温度约为190℃。     

PbSe量子点液芯光纤的温度效应

采用三能级系统的速率方程和功率传输方程并考虑温度对各项参数的影响,求解在不同的光纤长度和量子点掺杂浓度时,3.3nm PbSe量子点液芯光纤的发射光谱随温度的变化。发现当光纤长度不同时,随着温度的升高,光谱的峰值位置以相近的速率发生红移,光谱的峰值强度下降。对于较长的光纤,其光强随温度升高的衰减速率较大。当掺杂浓度不同时,随着温度的升高,光谱的峰值位置以相近的速率发生红移,峰值强度以相近的速率衰减。