Characterization of phase transition of Ba2-xSrxIn2O5 by thermal analysis and high temperature X-ray diffraction

The phase transitions of Ba_2-xSr_xIn₂O₅ were investigated with various thermal analyses and high-temperature X-ray diffraction. It was clarified that crystal structure of Ba_2-xSr_xIn₂O₅ with x=0.0~0.4 varies from brownmillerite through distorted perovskite to another distorted perovskite with increase of temperature. The phase transition from brownmillerite to distorted perovskite was revealed to be first order, whereas transition from distorted perovskite to another one was second order. The specimen with x≥0.5 showed only one first order phase transition from brownmillerite to distorted perovskite. The phase diagram of Ba_2-xSr_xIn₂O₅ was established and existence of tricritical point at ~1100°C with x=0.4~0.5 was suggested. This revised version was published online in August 2006 with corrections to the Cover Date.     

Closed tube sample introduction for gas chromatography-ion mobility spectrometry analysis of water contaminated with a chemical warfare agent surrogate compound

Ion mobility spectrometry (IMS) is a proven technology for detection of vapor phase chemical warfare agents. The technology is suitable for field portable instrumentation due to its small size, high sensitivity, speed of analysis, and low power consumption. However, it suffers from a limited dynamic range and potential difficulties in identifying compounds in complex matrices. The use of gas chromatography (GC) coupled to IMS can overcome the difficulty of chemical identification in mixtures by separating the sample into individual components before detection. Using this approach, IMS technology has previously been adapted to detect biological aerosols using an open tube pyrolyzer and a short GC column (Py-GC-IMS). The open sample introduction tube of a Py-GC-IMS instrument would be a convenient configuration to accept aerosol particulates, and while viewed as needed for aerosol trapping, is not optimal for liquid chemical analyses. To examine the usefulness of an existing Py-GC-IMS system for analysis of chemicals in water, an existing open-port sample interface was replaced with a septum-equipped closed tube injector to contain analyte vapors resulting from liquid injection. Tributylphosphate (TBP) was used as a surrogate chemical warfare agent, and aqueous injections into both closed and open tube assemblies were performed. Sample introduction into the closed tube inlet was also accomplished using solid phase microextraction (SPME) preconcentration. The limit of detection for TBP using an open tube, closed tube, and closed tube configuration with SPME sample introduction was 0.980, 0.196, and 0.0098 mg/L, respectively.     

Screen-printed electrochemical hybridization biosensor for the detection of DNA sequences from the Escherichia coli pathogen

An electrochemical biosensor for the specific detection of short DNA sequences from the E. coli pathogen is described. This hybridization device relies on the immobilization of a 25-mer oligonucleotide probe, from the E. coli lacZ gene, onto a screen-printed carbon electrode. Chronopotentiometric detection of the Co(bpy)₃⁺³ indicator is used for monitoring the hybridization event. Numerous variables of the assay protocol, including those of the probe immobilization step, the hybridization event, and the indicator association/detection, are characterized and optimized. Hybridization times of 2- and 30-min are sufficient for detecting 300- and 50 ng/mL, respectively, of the E. coli DNA target. Applicability to analysis of untreated environmental water samples is illustrated. Such single-use electrochemical sensors hold great promise for decentralized environmental and food testing for the E. coli pathogen.     

外加盐作用形成的正负离子表面活性剂双水相

癸基三乙基溴化铵-癸基磺酸钠（C10NE-C10SO3）等摩尔混合均相体系（即使在表面活性剂总浓度高达0.2 mol•L－1时仍然可形成稳定的均相溶液）在外加盐NaF、Na2SO4和Na3PO4的作用下可自发分离成两个水相（双水相）.研究了该类双水相体系的形成、相行为及其对牛血清蛋白（BSA）的分配，并与普通的正负离子表面活性剂混合双水相体系进行了比较.结果表明，该类双水相体系克服了普通的正负离子表面活性剂混合双水相体系的一些不足，具有一些独特的优点.该类双水相体系的相行为可以通过外加盐进行调控,通过外加盐的种类来调控和优化BSA的分配行为.图1表2参8     

酰胺型手性固定相直接拆分克仑特罗对映体

 将酰胺型手性固定相用于正相高效液相直接拆分 β2 受体兴奋剂克仑特罗。讨论了三元流动相中正己烷、1,2 二氯乙烷和甲醇含量的变化以及柱温和流速对分离的影响 ;优化了实验条件 :流动相为V(正己烷 )∶V(二氯乙烷 )∶V(甲醇 ) =5 4∶38∶8,柱温为 17℃ ,流速为 1 0mL/min ;并对拆分的机理加以探讨。方法简单、快速。     

溶致液晶中金属纳米粒子的掺杂及其作用机制研究

在用琥珀酸二异辛酯磺酸钠(AOT)构建的具有长程有序结构的层状溶致液晶内, 用不同方式导入预制的亲油或亲水贵金属纳米粒子, 可得到纳米粒子分布在不同介观空间内的无机/有机杂合体. 依据小角X射线散射和偏光显微镜结果, 通过分析掺杂纳米粒子与液晶模板的相互作用, 对掺杂前后体系结构的变化及制得杂合体的稳定性进行了表征. 结果表明, 除考虑掺杂粒子与层状模板空间的匹配外, 体系中静电斥力、范德华引力和Helfrich涨落力之间的平衡是维持液晶结构稳定的基本条件.     

Ag-MoO3催化丙烯直接气相环氧化反应的原位红外研究

制备了对丙烯直接气相环氧化具有较好催化性能的Ag-MoO3催化剂, 采用原位FT-IR技术研究了丙烯、环氧丙烷及丙烯+氧气的混合气在Ag和Ag-MoO3催化剂表面上的吸附及反应行为. 研究表明, 丙烯在Ag和Ag-MoO3催化剂表面上吸附后, 均不发生化学反应, 而环氧丙烷吸附后在较高温度下则发生开环和聚合反应直至产生积炭. 与Ag催化剂相比, 在Ag-MoO3催化剂上, MoO3的加入在降低催化剂活性的同时, 在一定程度上抑制了产物环氧丙烷的开环及深度反应, 使环氧丙烷的选择性提高. 另外, 在较低的反应温度和较短的滞留时间下, 环氧丙烷发生深度反应的程度明显降低.     

Immunological detection of glycoproteins on blots based on labeling with digoxigenin

In the following, we describe the application of the DIG/antiDIG system for the (structural) analysis of glycoproteins on blots. Special emphasis is being placed on the variety of the different DIG applications in order to obtain structural information concerning the glycoprotein carbohydrate chains. Prominent among them is the use of lectins with well-known specificities for carbohydrate structures. This article first appeared in: Hounsell, E. F., ed. (1993),Methods in Molecular Biollogy, vol. 14: Glycoprotein Analysis in Biomedicine, Humana Press Inc., Totowa, NJ.     

Some selected problems of nonaqueous microemulsions — phase diagrams and variation of the composition in the quaternary and ternary systems

A variety of quaternary and ternary systems of the type of dodecane/aliphatic alcohols/Na-dodecyl sulphate/water or a water-replacing component (formamide, ethylene glycol, propylene glycol, propylene carbonate, dimethylsulfoxide, acetonitrile) were subjected to a comparative analysis of microemulsification. The compositions of the systems of the type of oil/surfactant/cosurfactant/water or nonaqueous liquid were changed with respect to surfactant (Na-dodecyl sulfate and triton X 114) concentration, cosurfactant (homologous aliphatic alcohols) concentration and mixing ratio of water and water-replacing component. The appertaining phase diagrams were plotted and compared with those of aqueous systems.The experimental results suggest that the phase regions, which are designated as nonaqueous microemulsions, probably represent, not only microemulsions in the usual sense, but a separate kind of mixed phase whose microstructure is examined by special studies. Analogously to aqueous microemulsion systems, transparency and spontaneous formation of homogeneous multicomponent systems cannot serve as the sole criteria for waterless microemulsion formation. But they are important guiding properties of microemulsion formation in multicomponent systems.The variety of components involved in the chemical composition and the current insufficient knowledge do not permit to generally decide whether nonaqueous systems can be assigned to microemulsions or to molecular solutions. For clarifying this problem a detailed examination of the miscibility behavior, especially that of binary systems as a function of temperature, and the role that surfactant and cosurfactant play in the formation of homogeneous systems will be necessary.     

Individual determination of ortho and non-ortho substituted polychlorobiphenyls (PCBs) in sediments by high performance liquid chromatographic pre-separation and gas chromatography/ECD detection

Summary An analytical procedure for the individual determination of ortho and non-ortho PCB congeners in sediments, using high performance liquid chromatography (HPLC) preseparation and gas chromatography/ECD detection, is described. Gas chromatography/FTIR spectrometry (GC/FTIR) and gas chromatography/mass spectrometry (GC/MS) were employed for individual congener identification and determination. Sample extraction, clean-up of extract and selective elution procedures were optimized by using reference certified marine sediment samples. Recovery and precision were typically 83% and 16% respectively at 2 ng/g of total PCB content. The proposed procedure, tested by analyzing real sediment samples, showed a reproducibility better than 20% at 13 ng/g PCB level.