各向异性内包层对双包层光纤特性影响的分析

提出了单轴各向异性材料为内包层，且其主轴沿光纤轴线（z轴）方向的双包层光纤模型，推出了矢量模特征方程，重点研究了主轴折射率比kcl对波导色散的影响，针对从矢量模特征方程求解波导色散因表达式极为复杂而无法直接求解的困难，提出了一种求解波导色散的有效方法，研究结果发现可以在不改变光波导结构参量的条件下，通过改变kcl可有效地改变光纤的波导色散，也分析了kcl、几何参量S、光学参量R对低次模的传输和截止特性的影响。研究结果为获得更为理想的色散补偿、色散平坦光纤及设计新型无源光器件提供了重要的依据。     

从薄膜波导传播衰减的角度研究光学薄膜的损耗:(Ⅱ)实验分析

本文从实验的角度介绍从薄膜导波传播衰减研究光学薄膜损耗的方法,并以一些低损耗的光学薄膜样品的测量结果说明这种方法对损耗研究的灵敏程度及其优越性.     

准位相匹配铌酸锂波导倍频特性分析与优化设计

用标量有限元方法计算了周期性极化的铌酸锂光波导中模折射率和模场分布,并在计算中引入铌酸锂晶体折射率与温度变化的关系,分析了准位相匹配铌酸锂波导倍频效率与极化反转光栅周期、基频光波长、波导器件温度等关系.理论分析与实验结果符合得很好.在此基础上,分析了波导制作参数与倍频效率、光栅周期与晶体温度,以及温度带宽与光栅通光方向长度等关系,进而对铌酸锂波导倍频器件进行优化设计. 关键词： 铌酸锂 光波导 准位相匹配 有限元     

Investigation of Infrared Photonic Crystal Slab with Defect Waveguides

This paper deals with the two dimensional (2-D) infrared photonic crystal slab with an air-bridge structure featuring defect waveguides in which the optical propagation properties were obtained by measurements of transmission spectra. 3-D finite-difference time-domain (FDTD) simulations have revealed the appearance of four defect propagation modes for the band structure and transmission spectra in the air-bridge slab. These defect modes were experimentally identified in the measured transmission spectra.     

二维圆柱坐标系中五角形共形网格算法

 时域有限差分（FDTD）算法求解电磁问题时，如果目标结构不能和传统网格体系共形，往往采用局部共形网格或非正交网格算法。详细讨论了二维圆柱坐标系中五角形共形网格算法，该算法能方便地对倾斜薄层媒质或电导率不均匀的倾斜媒质等复杂结构建模,并以锥形电磁脉冲天线为例，验证了该算法的有效性。     

快速计算阵列波导光栅波导耦合系数的修正重叠积分方法

提出了一种修正的重叠积分方法用以计算阵列波导光栅(AWG)波分复用器件中光从自由传输区域到阵列波导的耦合系数,并和光束传播法(BPM)数值方法计算得到的结果做了比较通过比较分析,得出结论:当波导中心距不是太小时,用修正重叠积分这一快速方法是合适的.     

Lognormal Modes of Dielectric Optical Waveguides

It is shown that, at a critical point where the effective refractive index of a mode coincides with the bulk index of a cladding region, optical waveguide modes exhibiting a lognormal feature are supportable for a hyperlongrange refractive-index profile. As a typical example of waveguides that support lognormal modes a parabolic-index core surrounded by a depressed-index cladding is presented.     

Er3+,Yb3+共掺磷酸盐玻璃沟道波导放大器

在自行研制的Er3 ，Yb3 共掺磷酸盐玻璃基质上用离子交换方法制作出沟导光波导放大器。在110mW的抽运功率下(抽运光波长为980nm)，在1．8cm长的器件上获得了3．8dB的小信号(信号光波长为1．55μm)增益，单位长度上的增益为2．1dB／cm。     

Design and analysis of a new silicon-on-insulator waveguide Michelson interferometer sensor

A new designed and analyzed silicon-on-insulator (SOI) waveguide Michelson interferometer (SMI) sensor is proposed in this paper. The authors compare an optical SMI sensor, a silicon-on-insulator Bragg waveguide grating (SBG) sensor, and a fiber Bragg grating sensor (FBG) for temperature sensing in medicine applications. The SMI sensor has 20 times sensing more accuracy than the FBG sensor. Moreovr, the full width at half maximum (FWHM) of the pass-band frequency responses of our proposed SMI can be designed much narrower than FBG and SBG sensors for sensing resolution enhancement. Further, the improved characteristics of the SMI demonstrated in this paper could pave the way for future high density temperature monitoring medicine applications.     

二维平板光子晶体直波导的制备和光传输特性的测量

利用聚焦离子束刻蚀的方法在SOI(silicon on insulator)基片上制备了W3型二维光子晶体直波导.观察并测量了近红外激光通过光子晶体波导的散射图形和透过谱.实验结果说明，激光在有引入引出脊形波导的光子晶体直波导中具有很好的传输特性. 关键词： 光子晶体波导 光子带隙 脊型波导