一种新型可调谐锁模光纤激光器

利用法布里-珀罗腔的激光二极管作为调制器件，实现环形腔光纤激光器的主动锁模。并利用法布里-珀罗腔的激光二极管的多纵模特性，把激光二极管当作一梳状滤波器，通过偏振控制器来调整入射到激光二极管内光的偏振态，同时均衡腔内增益，得到波长大范围可调谐的锁模激光，其脉冲宽度约为48ps，脉冲重复速率2GHz。     

L波段线型腔波长可调谐掺铒光纤激光器

报道了工作波长在L波段的由两个光纤环境构成线型谐振腔的掺铒光纤激光器，通过调整环境中偏振控制器的状态来改变环境对不同波长的反射率以实现某些波长的激光输出。线型腔内的激光工作介质为两段不同掺杂浓度的掺铒光纤，其中一段铒光纤由一980nm激光器抽运，其产生的放大自发辐射谱在腔内再同时对两段掺铒光纤进行抽运，使它们的增益谱移位到L波段。实验中观察到了波长从1566．4nm到1592.4nm范围内可调的稳定的连续激光输出，其波长调谐范围达26nm。     

利用啁啾光纤光栅色散特性实现波长可调谐的主动锁模掺铒光纤环行腔激光器

在环形腔主动锁模光纤激光器中引入啁啾光纤光栅，利用啁啾光纤光栅的大色散特性，通过调节调制频率，实现波长调谐，调谐范围2nm。所得脉冲为重复频率2．5GHz，脉宽约60ps的正啁啾脉冲，。     

Design of Broadband L-band Erbium Doped Fiber Amplifier

1　Ｉｎｔｒｏｄｕｃｔｉｏｎ　　Ｗａｖｅｌｅｎｇｔｈ ｄｉｖｉｓｉｏｎｍｕｌｔｉｐｌｅｘｉｎｇ(ＷＤＭ )ｍｅｔｈｏｄｇｉｖｅｓａｓｏｌｕｔｉｏｎｏｆｄｅｍａｎｄｏｎｔｈｅｈｉｇｈｓｐｅｅｄａｎｄｈｉｇｈｃａｐａｃｉｔｙｔｒａｎｓｍｉｓｓｉｏｎ .ＯｎｅｏｆｔｈｅｋｅｙｔｅｃｈｎｏｌｏｇｙｏｆｔｈｅＷＤＭｔｒａｎｓｍｉｓｓｉｏｎｉｓｔｏｂｒｏａｄｅｎｂａｎｄｗｉｄｔｈｏｆｅｒｂｉｕｍ ｄｏｐｅｄｆｉｂｅｒａｍｐｌｉｆｉｅｒ (ＥＤＦＡ)ａｎｄｔｏｇｅｔｔｈｅｗｉｄｅｂａｎｄａｎｄｆｌａｔ ｇａｉｎＥＤＦＡ .…     

NMR spectral quantitation by principal component analysis. III. A generalized procedure for determination of lineshape variations

We present a general procedure for automatic quantitation of a series of spectral peaks based on principal component analysis (PCA). PCA has been previously used for spectral quantitation of a single resonant peak of constant shape but variable amplitude. Here we extend this procedure to estimate all of the peak parameters: amplitude, position (frequency), phase and linewidth. The procedure consists of a series of iterative steps in which the estimates of position and phase from one stage of iteration are used to correct the spectra prior to the next stage. The process is convergent to a stable result, typically in less than 5 iterations. If desired, remaining linewidth variations can then be corrected. Correction of (typically) unwanted variations of these types is important not only for direct peak quantitation, but also as a preprocessing step for spectral data prior to application of pattern recognition/classification techniques. The procedure is demonstrated on simulated data and on a set of 992 (31)P NMR in vivo spectra taken from a kinetic study of rat muscle energetics. The proposed procedure is robust, makes very limited assumptions about the lineshape, and performs well with data of low signal-to-noise ratio.     

一种不等带宽光学梳状滤波器

提出了一种新型—Michelson—三面镜FabryPerot型50GHz不等带宽光学梳状滤波器设计方案,分析和模拟表明:该器件将一路信道间隔为50GHz的输入信号分离成信道间隔为100GHz的奇偶两路输出信号,其中在3dB处,奇数信道带宽大于30GHz用于10Gb/s传输,偶数信道带宽大于60GHz用于40Gb/s传输对于将来的40Gb/s系统,该器件具有优势.     

光纤光栅的温度补偿

提出了一种简单、小型的光纤光栅温度补偿器件，将光纤光栅粘贴在具有负热膨胀系数的材料上，实现了光纤光栅的温度补偿。该器件在-20～44℃温度范围内光栅波长变化0.08m，是未补偿光纤光栅的1／8。     

反向驱动的异质结有机薄膜电致发光

成功制备了结构为ITO／PDDOPV／PPQ／Al的异质结聚合物发光二极管。该器件在正反向偏压下均可发光。在正向偏压下的光发射主要来自PDDOPV，但在反向偏压下的光发射则包括来自PPQ的蓝光发射和PDDOPV的黄光发射。蓝光强度与黄光强度的比值随着反向偏压的增加而增加，当反向直流电压分别为22V、24V、26V、28V时，其电致发光光谱中PPQ与PDDOPV的峰高比IPPQ／IPDDOPV分别为1．092、1．329、1．605、2．046。换句话说，该器件的发光颜色是压控可调的，这对实现彩色显示是极为有利的。分析了在反向偏压下的发光机理以及IPPQ／IPDDOPV受电压控制的原因。     

光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。     

Blocking probability analysis of survivable routing in WDM optical networks with/without sparse-wavelength conversion

In this paper, a new algorithm for wavelength assignment has been proposed and its performance is evaluated in terms of blocking probability and fairness. It has been shown that the proposed algorithm offers the least blocking probability. The blocking performance of wavelength division multiplexing (WDM) network has been analyzed for the network having 10 nodes and for varying loads. As the load per link (in Erlangs) increases, the blocking probability increases. The result shows that the performance of first-fit algorithm is better than random algorithm whereas the proposed algorithm offers the least blocking.