Determination of trace impurities in boron nitride by graphite furnace atomic absorption spectrometry and electrothermal vaporization inductively coupled plasma optical emission spectrometry using solid sampling

Two digestion-free methods for trace analysis of boron nitride based on graphite furnace atomic absorption spectrometry (GFAAS) and electrothermal vaporization inductively coupled plasma spectrometry optical emission (ETV-ICP-OES) using direct solid sampling have been developed and applied to the determination of Al, Ca, Cr, Cu, Fe, Mg, Mn, Si, Ti and Zr in four boron nitride materials in concentration intervals of 1–23, 54–735, 0.05–21, 0.005–1.3, 1.6–112, 4.5–20, 0.03–1.8, 6–46, 38–170 and 0.4–2.3 μg g^− 1, respectively. At optimized experimental conditions, with both methods, effective in-situ analyte/matrix separation was achieved and calibration could be performed using calibration curves measured with aqueous standard solutions. In solid sampling GFAAS, before sampling, the platform was covered with graphite powder and, for determination of Si, also the Pd/Mg(NO₃)₂ modifier was used. In the determination of all analyte elements by solid sampling ETV-ICP-OES, Freon R12 was added to argon carrier gas. For solid sampling GFAAS and ETV-ICP-OES, the achievable limits of detection were within 5 (Cu)–130 (Si) ng g^− 1 and 8 (Cu)–200 (Si) ng g^− 1, respectively. The results obtained by these two methods for four boron nitride materials of different purity grades are compared each with the other and with those obtained in analysis of digests by ICP-OES. The performance of the two solid sampling methods is compared and discussed.     

Mechanism of silicon film deposition in the RF plasma reduction of silicon tetrachloride

Plasma-chemical reduction of SiCl₄ in mixtures with H₂ and Ar has been studied by optical emission spectroscopy (OES) and laser interferometry techniques. It has been found that the Ar:H₂ ratio strongly affects the plasma composition as well as the deposition (r _D) and etch (r _E) rates of Si: H, Cl films and that the electron impact dissociation is the most important channel for the production of SiCl_x species, which are the precursors of the film growth. Chemisorption of SiCl_x and the reactive surface reaction SiCl_x+H–SiCl_(x–1)0+HCl are important steps in the deposition process. The suggested deposition model givesr _D [SiCl_x][H], in agreement with the experimental data. Etching of Si: H, Cl films occurs at high Ar: H₂ ratio when Cl atoms in the gas phase become appreciable and increases with increasing Cl concentration. The etch rate is controlled by the Cl atom chemisorption step.     

CrIII-Phthalocyaninate: Darstellung,Eigenschaften und Kristallstruktur von l-Bis(triphenylphosphin)iminium-trans-di(nitrito(O))phthalocyaninato(2–)-chromat(III)

Cr^III Phthalocyaninates: Synthesis, Properties, and Crystal Structure of l-Bis(triphenylphosphine)iminium trans-Di(nitrito(O))phthalocyaninato(2–)chromate(III) [Cr(H₂O)₂Pc^2?]I_x reacts with excess (PNP)NO₂ in dimethylformamide to yield less soluble greenblack l-bis(triphenylphosphine)iminium trans-di(nitrito(O))phthalocyaninato(2–)chromate(III), ^l(PNP)^trans[Cr(ONO)₂Pc^2?], which crystallizes in the triclinic space group P1 (No. 2) with Z = 2. The Cr atom is in the center of the Pc^2? ligand and the two nitrite ions are monodentate O-coordinated in a mutually trans arrangement to the Cr atom. The Cr? O and Cr? N_iso bond distances are 1.9898(14) und 1.981(2) Å, respectively. The geometric data of the coordinated nitrite ion are: d(N? O) = 1.307(2) Å; d(N? O) = 1.205(2) Å; ?(O? N? O) = 113.7(2)°; ?(Cr? O? N) = 116.85(12)°. The non-bonding O atoms are trans to the Cr atom. The Pc^2? ligand is slightly saddled. Three weak spin-allowed trip-quartet(TQ) transitions (in 10³ cm^?1): TQ1 (8.20) < TQ2 (11.3) < TQ3 (20.33) and the characteristic π-π* transitions of the Pc^2? ligand: B (14.68) < Q₁ (27.1) < Q₂ (29.0) < N (35.4) are observed in the UV-VIS-NIR spectrum. Prominent luminescence spectra are obtained by excitation within the TQ1 region, in which the spin-forbidden trip-sextet transition at 7376 cm^?1 dominates at low temperatures (T < 50 K). The vibrational spectra are discussed. In coincidence of the excitation lines with TQ3, v_s(Cr? O) at 378 cm^?1 is selectively resonance Raman (RR) enhanced. v_as(Cr? O) is observed in the FIR spectrum at 391 cm^?1. The following internal vibrations (in cm^?1) of the nitrito ligand are in the MIR spectrum: v_as(N? O)/1447 > v_as(N? O)/1018/1029 > δ(O? N? O)/828 and in the RR-spectrum: v_s(N? O)/1410 > v_s(N? O)/952, the last followed by three overtones.     

Investigations on the use of pneumatic cross-flow nebulizers with dual solution loading including the correction of matrix effects in elemental determinations by inductively coupled plasma optical emission spectrometry

The use of a so-called trihedral and a T-shaped cross-flow pneumatic nebulizer with dual solution loading for inductively coupled plasma optical emission spectrometry has been studied. By these devices analyte clouds from two solutions can be mixed during the aerosol generation step. For both nebulizers the correction of matrix effects using internal standardization and standard addition calibration in an on-line way was investigated and compared to elemental determinations using a conventional cross-flow nebulizer and calibration with synthetic standard solutions without matrix matching. A significant improvement of accuracy, both for calibration with internal standardization and standard addition, was obtained in the case of four synthetic solutions containing each 40 mmol L^− 1 Na, K, Rb and Ba as matrix elements and 300 μg L^− 1 Cd, Co, Cr, Cu, Fe, Mn, Ni and Pb as analytes. Calibration by standard addition in the case of dual solution loading has been shown to be very useful in the determination of elements at minor and trace levels in steel and alumina reference materials. The results of analysis for minor concentrations of Cr, Cu and Ni in steel as well as for Ca, Fe, Ga, Li, Mg, Mn, Na, Si and Zn in alumina powder certified reference materials subsequent to sample dissolution were found to be in good agreement with the certificates. Limits of detection were found to be only slightly above those for a conventional cross-flow nebulizer and a precision better than 3% was realized with both novel nebulizers.     

Synthesis and property of soluble poly(1,1′-dialkyl-3,3′-ferrocenylenevinylene)s via titanium-induced dicarbonyl-coupling reaction of 1,1′-dialkylferrocene-3,3′-dicarbaldehydes

1,1′-Dialkylferrocene-3,3′-dicarbaldehydes ( 1a–c ) with long alkyl chains such as ethyl, hexyl, and dodecyl groups were prepared in 13–25% yield via three-step reactions. The titanium-induced dicarbonyl-coupling reaction of 1a–c gave poly(1,1′-dialkyl-3,3′-ferrocenylenevi-nylene)s ( 2a–c ) in quantitative yields, which were the molecular weights of 3000–10,000 and highly soluble in chloroform, benzene, and hexane. The electrical conductivity and the third-order nonlinear optical susceptibility for poly(1,1′-dihexyl-3,3′-ferrocenylenevinylene) ( 2b ) were estimated to be 1 × 10^?2 S/cm on doping with iodine and 1–4 × 10^?12 esu at a wavelength of 1–2.4 μm, respectively. © 1995 John Wiley & Sons, Inc.     

Potentiometric determination of diclofenac in pharmaceutical formulation by membrane electrode based on ion associate with base dye

The characteristics,performance and application of membrane electrode based on ion associate of diclofenac with base dye Safranine T are described.The electrode response to diclofenac has the sensitivity of 47±1.0 mV decade~(-1)over the range of 5×10~(-5)to 5×10~(-2)mol/L at pH 6-12,and the detection limit of 3.2×10~(-5)mol/L.The electrode is easy assembled at a relatively low cost has fast response time(2-4 s)and can be used for a period up to 3.5 months without any considerable divergence in potential.The proposed sensor displayed good selectivity for diclofenac in the presence of different substances.It was used to determine diclofenac in pharmaceuticals by means of the standard addition method.     

Synthesis and optical resolution of a series of inherently chiral calix[4]crowns with cone and partial cone conformations

A series of inherently chiral calix[4]arenes with cone and partial cone conformations and with crown ether moieties of variable size have been readily synthesized. By taking advantage of the carboxy appendage on the lower rim, these were condensed with the chiral auxiliary (S)-BINOL to form diastereomers which, in most cases, could be separated by preparative TLC, or more desirably, by column chromatography on silica gel (diastereomeric excess >99 % based on HPLC analysis). Seven enantiopure antipodes of inherently chiral calix[4]crowns were obtained after hydrolysis. It has been found that both the size of the crown moiety and alkylation of the last phenolic hydroxy group (accompanied with or without a change in the conformation) affect the separation of the diastereomers.     

Absolute configuration of C2-symmetric spiroselenurane: 3,3,3',3'-tetramethyl-1,1'-spirobi[3 H,2,1]benzoxaselenole

The enantiomers of 3,3,3',3'-tetramethyl-1,1'-spirobi[3 H,2,1]benzoxaselenole have been separated on a chiral preparative chromatographic column. The experimental vibrational circular dichroism (VCD) spectra have been obtained for both enantiomers in CH(2)Cl(2). The theoretical VCD spectra have been obtained by means of density functional theoretical calculations with the B3 LYP density functional. From a comparison of experimental and theoretical VCD spectra, the absolute configuration of an enantiomer with positive specific rotation in CH(2)Cl(2) at 589 nm is determined to be R. This conclusion has been verified by comparing results of experimental optical rotatory dispersion (ORD) and electronic circular dichroism (ECD) to predictions of the same properties using the B3 LYP functional for the title compound.     

Multistate/multifunctional behaviour of 4'-hydroxy-6-nitroflavylium: a write-lock/read/unlock/enable-erase/erase cycle driven by light and pH stimulation

We have investigated the network of reactions observed for the photochromic 4'-hydroxy-6-nitroflavylium compound in aqueous solutions upon pH changes (including pH jump and stopped flow experiments) and light excitation. The changes observed in the NMR and UV/Vis spectra allowed identification of ten different forms in which this compound can be transformed depending on the experimental conditions. Equilibrium and kinetic constants have been determined. Compared with other members of the flavylium family, 4'-hydroxy-6-nitroflavylium is characterized by a large cis-->trans isomerization barrier, and a very efficient hydration reaction. These peculiar features allow writing, reading, storing and erasing photonic information on 4'-hydroxy-6-nitroflavylium by a novel cyclic process that involves the following steps: write-lock/read/unlock/enable-erase/erase.     

Nanoparticles: scaffolds for molecular recognition

Monolayer and mixed-monolayer protected clusters (MPCs and MMPCs) have great potential to combine molecular functionality with the intrinsic properties of nanometer-sized scaffolds. This synergy can be used to create complex functional devices, including redox-active, electronic, or magnetic storage devices, solution-based sensors, and highly efficient catalysts. This review outlines some of the recent developments in nanoscale receptors based on synthetic and nonbiological recognition elements. In these nanoparticle systems, molecular recognition is achieved by covalent attachment of receptors on the nanoparticles coupled with noncovalent interactions to target substrates. Synthetic host-guest systems, hydrogen bonding, change in redox states, pi-pi stacking, rotaxane formation, and ion recognition are the main topics covered in this review.