椭圆法用于阳极溶出伏安法测定微量银

用新物理量Ｖｏｐ的椭圆法对阳极溶出伏安法分析的含银离子浓度为１０＾５－１０＾－９ｍｏｌ／Ｌ的一系列溶液进行了研究。结果表明：光学方法与电化学方法所得分析结果相同；椭圆法可检测的浓度下限比电化学方法低一个数量级以上。而且测量的相对平均偏差也小于电化学方法。     

Spectral and photochemical characteristics of CdSe nanoparticles stabilized in polymer-containing media

The optical characteristics of CdSe nanoparticles, produced in aqueous solutions and polymer films in the reaction of cadmium chloride and sodium selenosulfate, were studied. The main parameters that make it possible to vary the forbidden band width were identified. The absorption, photoluminescence, Raman, and nonstationary decolorization spectra of CdSe nanoparticles of various sizes were analyzed. It was demonstrated that under the conditions of pulsed irradiation the CdSe nanoparticles are capable of accumulating excess electrons and inducing redox transformations in components of the solution (oxygen, methylviologen, and sulfite ions). __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 42, No. 3, pp. 150–155, May–June, 2006.     

非线性光学材料──水草酸铵

一水草酸铵（简称ＡＯＭ）是一种优良的电光晶体￣［１］。文献￣［１，２］报道了该晶体的晶体结构，化学式为（ＮＨ＿４）＿２Ｃ＿２Ｏ＿２·Ｈ＿２Ｏ，属正交晶系，Ｐ２２２空间群，晶胞参数ａ＝０．８０３５ｎｍ，ｂ＝１。０３１ｎｍ，ｃ＝０．３８０１ｎｍ，ｚ＝２。本文拟报道ＡＯＭ单晶生长，热化学分析，透过波段以及非线性光学性质的初步研究。     

1，2—二氯丙烷裂解反应光窗结焦机理的研究

有机化合物在光窗上的结焦严重地影响激光引发化学反应及光学原位实时探测。本文报道在1，2－二氯丙烷反应系统中，光窗结焦现象同时存在于激光引发反应及热反应过程中，对光窗在300℃条件 下的结焦机理研究表明，少量氧气在光窗结焦过程中起关键作用。结焦前驱体的红外光谱研究表明，前驱体的可能结构为1－丙炔－1，3－二醇的缩聚体。该化合物极易通过缩聚反应形成更大的分子，最终导致光 窗结焦。对系统及反应物进行彻底除氧，光窗结焦现象大为改善。     

一种主链含非线性光学活性基团聚合物的合成

把非线性光学(NLO)发色基团引入到聚合物主链中,既可以增大聚合物中NLO基团的含量,从而提高聚合物的宏观NLO系数,又能够提高NLO聚合物的极化稳定性。本文报道一种由酚酞环氧树脂(PPh)与对硝基苯胺(NA)得到的NLO聚合物的合成及其极化松弛。 所用酚酞环氧树脂系自制,环氧值0.427。对硝基苯胺北京化工厂产,分析纯。N,N-二甲基甲酰胺为中国医药公司售品,化学纯,用前减压蒸馏精制,乙醇、丙酮均为北京化工厂生产,分析纯。在氮气保护下将等当量的PPh与NA溶于DMF中于150℃反应6～8小时后,倒     

含吩噻嗪金属配合物的合成及非线性光学性质研究

本文报道了一种新的配体:10-乙基-3-甲酰吩噻嗪缩肼基二硫代甲酸甲酯(HL)及其金属配合物的合成。采用了元素分析、质谱、核磁共振、红外光谱对配体及其金属配合物进行了表征。此外,并应用紫外、荧光和Z-扫描技术,测定了配体及其金属配合物的荧光最佳发射波长(λ_max^em)、荧光量子产率(Φ_f)、寿命(τ)和非线性光学性质。结果表明它们在DMF溶液中都能发射出较强的橄榄色荧光,配体及其金属配合物都有双光子吸收,并且金属配合物的非线性光学效应比配体明显增强。用半经验量子化学方法(RHF/PM3)计算结果与实验值较为吻合。     

Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

分子内环加成的甾体全合成

近年来,分子内环加成反应已广泛用于甾体化合物全合成,其主要一步是由取代的苯并环丁烯热裂而成的5,6-二亚甲基-1,3-环己二烯发生区域专一和立体选择性的环加成反应,构成甾体骨架。现在用此法已合成了一系列消旋和光学活性的甾体化合物。     

液芯光纤光度法在乙醇水溶液中测定铂(Ⅱ)、钛(Ⅳ)

采用氟塑料长光纤管，以４２％乙醇水溶液作液芯，组成液芯光纤，基于铂与氯化亚锡、钛与过氧化氢形成黄色络合物在乙醇水溶液中很稳定，拟定了测定铂、钛的液芯光纤光度法。该法灵敏度高，用 １ｍ长光纤作吸收池，铂的灵敏度为 ４． ８４５ Ａ／ｍｇ· Ｌ－１，钛的灵敏度为１．４１Ａ／ｍｇ· Ｌ－１（Ａ为吸光度），与常规法（１ｃｍ）比色皿相比灵敏度提高了 １００倍。该法测定了催化剂中铂，煤灰粉中钛，结果与推荐值相符。     

聚酰胺酸及其接枝衍生物的三阶非线性光学性能研究

设计合成了苯代三聚氰胺与均苯四酸二酐缩聚物, 及不同侧链的p-π共轭缩聚物, 并以量子化学PM3/CIS方法为基础, 利用完全态求和(SOS)公式, 对不同侧链取代的聚酰胺酸的分子进行了几何构型优化, 并计算了其三阶非线性光学系数γ. 研究了不同侧链对聚合物三阶非线性性能的影响. 这些结果对合成具有优良加工性能的三阶非线性光学材料是有一定的指导作用.