The pentacene films on the glass/ITO surface: structure and optical properties

Abstract

The structure, morphology and optical transmittance spectra of pentacene films on the (glass/ITO) surface were studied. The films were grown by two methods - the thermal vacuum deposition (TVD) and pulsed laser deposition (PLD). The electron diffraction pattern from thermally deposited pentacene films confirms their polycrystalline structure while the diffraction pattern of PLD-coated layers has a diffusion character. The results obtained showed that layers deposited by the TVD method has an optical spectrum that is characteristic for the pentacene film in contrary to the layers deposited by the PLD method. It is found a sensitivity of the optical transmittance of pentacene films to the ammonia action, which may be used for development the optical gas sensor.     

多通道表面放电光泵浦源触发特性研究

介绍了多通道表面放电光泵浦源的设计,理论分析了触发电压幅值及上升时间、绝缘基板厚度等参数对所设计光泵浦源触发特性的影响。分析表明：在触发电压作用下,通道两电极处电场出现强烈畸变,而通道中间电场基本为零。采用高速相机拍摄泵浦源的放电图像以及电流线圈测量各通道的放电电流这两种方法实验研究了泵浦源的同步性及放电均匀性。当氮氩混合气体总气压为0.1 MPa (氮氩体积比为3∶7),充电电压20 kV,触发电压30 kV,前沿约10 ns时,成功实现了10通道均匀放电,抖动约20 ns。实验结果表明：在保证放电装置绝缘良好的情况下,若充电电压和触发电压越高,触发电压上升时间越短,触发电极至通道的有效距离越短,则多通道放电的抖动就越小,放电均匀性越好。     

170 Mb/s multilevel transmission over 115 m standard step-index plastic optical fiber using an integrated optical receiver

An optical receiver having a high linearity is used for multilevel communication over standard step plastic optical fiber. A large-diameter photodiode with an antireflection coating optimized for red light was integrated. These features enable the used optical receiver to be a promising plastic optical fiber receiver. An error free (< 10⁻⁸) 170 Mb/s data rate over 115 m standard PMMA step-index plastic optical fiber is achieved with four-level and eight-level pulse amplitude modulation.     

激光点火系统用高功率光纤光开关

仿真和实验研究了一种控制Nd:YAG脉冲激光能量通断的光纤直接连接型光开关。建立光纤耦合模型,分析了光纤对准误差中对耦合效率的影响,其中横向偏移的影响最显著。采用微机电系统V型槽固定光纤,微小型凸轮作为制动器,步进电机驱动凸轮旋转,微小型凸轮与移动光纤相切,带动光纤移动,实现两光纤的错开和对准。制造了这种高功率直接连接型光纤光开关原理样机,并进行了主要性能测试。测试结果表明,这种光开关能够满足激光点火系统的大容量、高隔离度的要求。     

宽视场长焦距离轴三反射镜光学系统的设计

分析了离轴三反射镜系统成像特性．根据共轴三反射镜光学系统像差理论，确定结构参数的基本计算公式．设计了长焦宽视场的离轴三反射镜光学系统，分析了系统结构参量对像差的影响．结果表明，该系统视角较大，地面复益范围较宽，成像质量接近衍射极限．     

周期极化LiNbO3脉冲走离效应分析

建立了包含高阶群速色散的OPCPA 数值模拟程序,并以准相位匹配的周期极化的LiNbO3(PPLN)参量放大器为例,在信号光是中心波长1 053 nm,脉宽100 fs的飞秒脉冲经展宽器展宽800 ps的啁啾脉冲,输入能量约0.6 nJ,泵浦光波长527 nm,脉宽3 ns,初始输入泵浦光强300 MW/cmLiNbO2,PPLN晶体的非共线角1.49°,极化周期9.7 μm的条件下, 对OPCPA过程前级的高阶群速色散引起的走离效应对泵浦光、信号光频谱和脉冲形状的影响等具体特性进行了数值模拟。结果表明：在合适的晶体长度下,高阶群速色散对参量转换效率的影响不大,但它对输出信号光的时间波形和频谱有较大影响,会引起脉冲时间形状畸变和频谱漂移。     

光信息科学与技术专业实践教学的探索

在四年办学经验的基础上,探索了适合地方经济建设的光信息科学与技术的本科专业的实践教学体系,进一步提升了办学水平。     

光信息科学与技术专业的教学改革——双语教学

分析了光信息科学与技术专业的特点,探讨了该专业双语教学改革的特点和提高双语教学效果的方法,为专业发展提出了思路。     

Gain characteristics and optimization of dual-pump fiber optical parametric amplifier using two-section highly nonlinear fibers

In this paper the gain characteristics of two-pump fiber optical parametric amplifiers (FOPA) with two-section highly nonlinear fibers are analyzed numerically and the parameters of the fibers are optimized to reach broad and flat gain spectra using genetic algorithm. Different from the previous methods, here the space between two pump wavelengths and the parameter β₄ of the fibers are included as a pivotal factor in the optimization. The numerical simulation shows that using two-section practical high nonlinear fibers, the amplifier may reach 110 nm bandwidth covering 1495–1605 nm with 10.5 dB average gain and gain ripple of 0.17 dB, when the total pump power is 1 W.