一维纳米材料Cs0.2WO3和W18O49长度与红外吸收关联性的Mie散射理论推导及实验验证

研究表明二元、三元钨基氧化物的红外吸收性能具有尺寸和形貌依赖性,但还没有普适性的物理学机理及计算方法。本工作基于Mie散射理论,推导了一维材料的长度与光吸收性能之间的关系,通过理论推导计算和实验验证,探究了纳米钨基氧化物的红外吸收性能与颗粒长度的关联性。首先,基于Mie散射理论的推演和计算,揭示了增加纳米Cs_(0.2)WO_3和W_(18)O_(49)材料长度可适度提高其近红外吸收性能的规律。其次,测试了合成的不同长度Cs_(0.2)WO_3纳米棒和W_(18)O_(49)纳米线的红外吸收性能,结果与理论计算及模拟相吻合。其中在2 500～20 000 nm波长范围内Cs_(0.2)WO_3纳米棒和W_(18)O_(49)纳米线随长度的变化趋势不同,Cs_(0.2)WO_3纳米棒的红外吸收性能随长度的增加而增加,而W_(18)O_(49)纳米线的红外吸收性能随长度的增加而减弱。Cs_(0.2)WO_3纳米棒和W_(18)0O_9纳米线的光热效应均随长度的增加而增加,增幅分别达18.5%和12.7%,再次验证了长度效应。     

基于kinect和unity的虚拟手抓取碰撞检测算法

针对目前碰撞检测算法效率低精度差的问题,提出了一种改进的层次方向包围盒（OBB）算法。首先通过位置关系判断虚拟手是否在物体包围球的邻近区域,然后用OBB和八叉树算法进行详细的碰撞检测,最后利用离散点到虚拟手简化面的矢量计算法实现精确的碰撞检测。实验结果表明,随着三维物体基元数目的增多,这种由粗略到精确递进的检测方式极大的提高了碰撞检测的效率和精度,具有可行性。该算法适用于任何复杂场景中刚体结构模型的碰撞检测,在运行时候不存在滞后情况,显示流畅,而且碰撞检测精度高,完全能够满足虚拟环境实时性和精确性的要求。     

Experimental research of effects of different rotation radii on the growth rate of potassium dihydrogen phosphate crystals

Comparing with the traditional concentric rotation method (rotation radius is 0 cm), the effects of different rotation radii on the growth rate of KDP crystals were studied by experimental methods. It was found that with the increase of rotation radius from 0 cm, the growth rate of each direction of crystals first increased and then decreased in a size‐unchanged vessel. The smaller the distance between the crystal and vessel wall, the less the growth rate. This phenomenon was named the “wall collision effect”. Also, the value of growth rate reached a maximum when the rotation radius was about half of its allowable largest value in the size‐unchanged vessel. In addition, an increase of the rotation radius could improve the crystal growth rate under the same linear velocity of crystal movement. Finally, the uniformity of crystal growth has also been analyzed compared with the concentric rotation radius. It was found that the uniformity of crystal growth was best when the rotation radius was half of its allowable maximum value, and it was more conducive to the actual application of KDP crystals.     

Electrospun CuFe2O4 nanotubes as anodes for high-performance lithium-ion batteries

Herein,we report on the synthesis and lithium storage properties of electrospun one-dimensional(1D) CuFe_2O_4 nanomaterials.1D CuFe_2O_4nanotubes and nanorods were fabricated by a single spinneret electrospinning method followed by thermal decomposition for removal of polymers from the precursor fibers.The as-prepared CuFe_2O_4 nanotubes with wall thickness of ~50 nm presented diameters of ~150 nm and lengths up to several millimeters.It was found that phase separation between the electrospun composite materials occured during the electrospinning process,while the as-spun precursor nanofibers composed of polyacrylonitrile(PAN),polyvinylpyrrolidone(PVP) and metal salts might possess a core-shell structure(PAN as the core and PVP/metal salts composite as the shell) and then transformed to a hollow structure after calcination.Moreover,as a demonstration of the functional properties of the 1D nanostructure.CuFe_2O_4 nanotubes and nanorods were investigated as anodes for lithium ion batteries(LIBs).It was demonstrated that CuFe_2O_4 nanotubes not only delivered a high reversible capacity of ~816 mAh·g~(-1) at a current density of 200 mA·g~(-1)over 50 cycles,but also showed superior rate capability with respect to counterpart nanorods.Probably,the enhanced electrochemical performance can be attributed to its high specific surface areas as well as the unique hollow structure.     

Energy‐dependent normal and unusually large inverse chlorine kinetic isotope effects of simple chlorohydrocarbons in collision‐induced dissociation by gas chromatography‐electron ionization‐tandem mass spectrometry

Kinetic isotope effects (KIEs) occurring in mass spectrometry (MS) can provide in‐depth insights into the fragmentation behaviors of compounds of interest in MS. Yet, the fundamentals of KIEs in collision‐induced dissociation (CID) in tandem mass spectrometry (MS/MS) are unclear, and information about chlorine KIEs (Cl‐KIEs) of organochlorines in MS is particularly scarce. This study investigated the Cl‐KIEs of dichloromethane, trichloroethylene, and tetrachloroethylene during CID using gas chromatography‐electron ionization triple‐quadrupole MS/MS. Cl‐KIEs were evaluated with MS signal intensities. All the organochlorines presented large inverse Cl‐KIEs (<1, the departures of Cl‐KIEs from 1 denote the magnitudes of Cl‐KIEs), showing the largest magnitudes of 0.797, 0.910, and 0.892 at the highest collision energy (60 eV) for dichloromethane, trichloroethylene, and tetrachloroethylene, respectively. For dichloromethane, both intra‐ion and inter‐ion Cl‐KIEs were studied, within the ranges of 0.820–1.020 and 0.797–1.016, respectively, showing both normal and inverse Cl‐KIEs depending on collision energies. The observed Cl‐KIEs generally declined from large normal to extremely large inverse values with increasing collision energies from 0 to 60 eV but were inferred to be independent of MS signal intensities. The Cl‐KIEs are dominated by critical energies at low internal energies of precursor ions, resulting in normal Cl‐KIEs; while at high internal energies, the Cl‐KIEs are controlled by rotational barriers (or looseness/tightness of transition states), which lead to isotope‐competitive reactions in dechlorination and thereby inverse Cl‐KIEs. It is concluded that the Cl‐KIEs may depend on critical energies, bond strengths, available internal energies, and transition state looseness/tightness. The findings of this study yield new insights into the fundamentals of Cl‐KIEs of organochlorines during CID and may be conducive to elucidating the underlying mechanisms of KIEs in collision‐induced and photo‐induced reactions in the actual world.     

再谈"小球与均质自由杆的碰撞"

讨论了小球在杆上任一点的碰撞问题,并指出《大学物理》2006年第5期《小球与均质自由杆的碰撞》一文中"完全非弹性碰撞后两物体不一定粘在一起共同运动"的说法是错误的.     

三维非连续变形分析方法碰撞分析及其应用

将具有完备动力学理论的非连续变形分析(DDA)方法应用于块体碰撞研究。基于三维DDA(3D DDA)方法,按时步输出块体碰撞过程速度变化和接触嵌入量,进而得到块体碰撞恢复系数、冲量、冲击力。以此为参考指标,采用斜抛、面-面对心等碰撞模型,验证3D DDA方法模拟块体碰撞的有效性,并将3D DDA方法应用于多米诺骨牌倾倒、滚石边坡成灾及防护等算例分析,探讨了多米诺骨牌倾倒机制、滚石启动及运动行为、滚石灾害防护方案。结果表明:多米诺骨牌间距越大,同一块体被碰撞时间越迟,其最终稳定时间也越迟,与下一块体碰撞的动能越大;滚石运动呈侧向平动及转动三维运动特征,每一次碰撞,均引起动能、轨迹或状态的显著变化;滚石拦挡设施弹簧刚度越大,越先达到最大冲击力,最大冲击力随弹簧刚度的增加而减小;可结合树木阻挡效应,耗散滚石动能,降低滚石飞跃高度,使滚石灾害减轻或控制在防护范围以内。     

Readjustment of the Bohr stopping force from energies of keV/n to a few tens of MeV/n ions in elemental targets

An analytical approach for the electronic stopping force for non-relativistic energies that has no adjustable parameters has been developed. The approach combines the Bohr model for the close collisions and the Firsov model for the distant collisions. In order to combine the two models, a probabilistic model was introduced. We have applied our model to ¹⁶O in ¹²C, ¹⁶O in ²⁷Al, ⁸⁴ Kr in ²⁷Al, ⁵Li in ¹²C, ¹²C in ¹²C, and ¹³²Xe in ¹²C systems and compared with SRIM/MSTAR software, the original Bohr model, the Firsov model and available experimental data. We have found that the calculated electronic stopping force values are in agreement with the general qualitative behaviour of the electronic stopping force as a function of particle velocity reported in the literature. The proposed analytical formula is expected to be valid for other projectile-target combinations but more experimental data are needed to verify this assumption.     

Instantaneous work hardening behaviour of two-phase tungsten heavy alloys: a phenomenological approach

ABSTRACT

The present work describes a phenomenological approach to explain the instantaneous behaviour of tungsten heavy alloys (WHAs) in heat-treated and swaged conditions. The strengths and elongation values of heat-treated materials are lower and higher than those of the swaged samples respectively. The heat-treated materials exhibit two slopes in true stress–true plastic strain curves and follow the Ludwigson constitutive equation. On the other hand, swaged materials display a single slope and adhere to typical Swift constitutive equation. The latter reflect the presence of pre-strain in the materials due to swaging deformation. The fracture surfaces in heat-treated materials consist of W-W decohesion along with matrix rupture and W-cleavage, while swaged samples consist of mainly W-cleavage. Both the materials display three typical stages (I, II and III) of work hardening. The second derivatives of true stress–true plastic strain curves of these alloys exhibit a perfect parabola although the nature of true stress–true strain as well as true stress–true plastic strain curves is quite different in heat-treated and swaged materials. This has been observed for the first time in WHAs consisting of matrix and W-grains. The shape of the parabola is simple and easy to fit. The fitting parameters of parabolas have been successfully employed to explain the flow behaviour of a large number of tungsten heavy alloys having two-phase microstructure in different processing conditions.     

Nucleon effective mass splitting and density-dependent symmetry energy effects on elliptic flow in heavy ion collisions at E_(lab)= 0.09 ～ 1.5 GeV/nucleon

By incorporating an iso spin-dependent form of the momentum-dependent potential in the ultra-relativistic quantum molecular dynamics(UrQMD) model,we systematically investigate effects of the neutron-proton effective mass splitting m*_(n-p)=m*_n-m*_p/m and the density-dependent nuclear symmetry energy E_(sym)(ρ) on the elliptic flow v_2 in~(197)Au+~(197) Au collisions at beam energies from 0.09 to 1.5 GeV/nucleon.It is found that at higher beam energies(≥0.25 GeV/nucleon) with the approximately 75 MeV difference in slopes of the two different E_(sym)(ρ),and the variation of m*_(n-p) ranging from-0.03 to 0.03 at saturation density with isospin asymmetry δ=(ρ_n-ρ_p)/ρ-0.2,the E_(sym)(ρ) has a stronger influence on the difference in v_2 between neutrons and protons,i.e.,v_2~n-v_2~p,than m*_(n-p) has.Meanwhile,at lower beam energies(≤0.25 GeV/nucleon),v_2~n-v_2~p is sensitive to both the E_(sym)(ρ) and the m*_(n-p).Moreover,the influence of m*_(n-p) on v_2~n-v_2~p is more evident with the parameters of this study when using the soft,rather than stiff,symmetry energy.