WOx/TiO2光催化剂的可见光催化活性机理探讨

采用磁控溅射技术在用浸渍提拉法制得的TiO2薄膜上，溅射氧化钨层,通过气相反应中光催化降解二甲苯的实验表明，WOx/TiO2薄膜具有可见光活性.通过UV-Vis吸收光谱、X射线光电子能谱（XPS）等方法对其可见光活性的机理进行探索.UV-Vis吸收光谱表明WOx,TiO2对可见光响应的范围有一定的扩展,吸收强度增加.XPS表明WOx/TiO2薄膜表面形成了明显的W杂质能级和Ti缺陷能级,这是WOx/TiO2在可见光范围有一吸收的主要原因,也是光催化剂具有可见光活性的必要条件之一，同时杂质能级的存在使半导体费米能级上移,载流子增加,光催化效率提高.     

Immobilization of thiabendazole-specific monoclonal antibodies to silicon substrates via aqueous silanization

Monoclonal antibodies specific for thiabendazole were immobilized to silicon, silicon dioxide, stoichiometric silicon nitride, and silicon-rich silicon nitride surfaces. This work provides the foundation for the development of a homogeneous sensor system for rapid detection and quantification of thiabendazole residues in produce and animal tissue. Immobilization was performed via aqueous silanization of the substrate followed sequentially by treatment with glutaraldehyde and contact with antibody solution in the presence of detergent. Surfaces were challenged with thiabendazole-horseradish peroxidase conjugate in an ELISA format to estimate immobilized antibody load. A stable and reproducible surface loading of 2 x 10¹¹ antibodies/cm² was obtained only after surfaces received postimmobilization treatments to remove nonspecifically adsorbed antibody. No difference in surface loading was noted when using 30% hydrogen peroxide rather than nitric acid for silanol activation. Little difference was noted among the antibody loadings achieved on the various silicon substrates. Bound antigen-enzyme conjugate was eluted with 0.1N acetic acid and reproducible surface activity was measured for up to four consecutive antigen challenges. Immobilized antibody surfaces were stabilized with 2% sucrose, dehydrated at 37‡C and stored in vacuum or stored at 4‡C in phosphate buffered saline containing 0.01% sodium azide without significant loss of activity.     

石英晶体微天平技术研究纳米TiO_2表面Cu(Ⅱ)吸附与光化学还原过程

环境中排放的重金属离子Cu!对水生和陆生生物有强的毒害性。饮用水中Cu!的浓度高于1.0mg·L-1时,将会导致人畜得血色沉着病和胃肠粘膜病[1]。Cu!无法进行生物降解,除去废水中Cu!的常见方法有离子交换、置换、化学沉淀等[2],然而这些方法需要消耗大量的化学试剂,成本高。近来,研     

二氧化碳与丙烯直接合成甲基丙烯酸用CuPMo／TiO2催化剂的研究

 用溶胶－凝胶法以磷钼酸（MPA）的铜盐溶液水解钛酸四丁酯制备了CuPMo／TiO2催化剂，并用ICP，XRD，TG－DTA，IR，TPD－MS和微反技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化性能．结果表明：杂多钼酸盐与TiO2表面通过O2－桥发生键联．在623K下，杂多阴离子仍保持其原有的Keggin结构；CO2在Lewis酸位Cu（Ⅱ）和Lewis碱位Cu－O－Mo桥氧的协同作用下形成卧式吸附态Cu（Ⅱ）←O－（CO）←（O－－Cu）；丙烯以分子吸附态在催化剂上吸附；在空速1500h－1，压力1MPa和温度563K的反应条件下，丙烯的转化率为4．2％，甲基丙烯酸的选择性为96％．     

Influence of the conditions of manufacture of nanomeric zirconium dioxide,stabilized with yttrium oxide,on its catalytic properties in the oxidation of CO

The morphological and catalytic properties of samples of nanomeric zirconium dioxide, stabilized with yttrium oxide, manufactured via the effect of a UHF field during the process of drying precipitated zirconium hydroxide and calcination at temperatures from 300 to 1000 °C, were studied. It was shown that the highest activity in the oxidation of CO occurred with 40 nm particles of zirconium dioxide prepared at 1000 °C. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 43, No. 2, pp. 96–101, March–April, 2007.     

用碘酸钾滴定法标定二氧化硫标准溶液

用KIO3滴定法标定SO2标准溶液,RSD≈0.10%,标定结果与标准法结果无显著性差异,相对误差<±0.3%。     

钛铁矿中钛的测定

利用钛铁矿能显著吸收微波的介电特性，采用家用微波炉，在微波辐照下，用浓磷酸消解矿样，并用氧化还原滴定法测定钛的含量，试验结果表明，该方法能快速分解矿样，测定结果准确，与传统分析方法比较，该法具有简便、快速、低耗、适应大批量样品分析等优点。还对钛铁矿的结构作了X-射线衍射分析。     

二氧化碳多相催化加氢的新进展

就近年来关于ＣＯ２活化、几个重要的ＣＯ２多相催化加氢反应及廉价氢的供给的研究进展进行综述。参考文献３４篇。     

一种用于空气中二氧化碳现场测定的新方法

一种用于空气中二氧化碳现场测定的新方法于爱民，杨广德，王锐，金钦汉（吉林大学化学系，长春１３００２３）关键词微波诱导等离子体，离子化检测器，气相色谱仪，二氧化碳二氧化碳在植物生长代谢及其生态平衡过程中起着重要作用，现场测定二氧化碳是目前农业、环境科学...     

SiO_2负载钼催化剂的合成及其催化乙烯二聚、同系化和歧化的反应性能

从单核及双核二甲胺钼络合物出发,制备了SiO_2负载的钼催化剂。程序升温分解实验(TPDE)及红外测试表明,双核钼络合物与SiO_2作用生成双钼中心物种,此物种可催化乙烯的二聚反应。280℃活化后此双钼中心物种变成单钼中心物种,单钼物种只催化乙烯的同系化及歧化反应。