Millimeter-Wave Spectroscopy of Methylfuran Isomers: Local vs. Global Treatments of the Internal Rotation

Methylfurans are methylated aromatic heterocyclic volatile organic compounds and primary or secondary pollutants in the atmosphere due to their capability to form secondary organic aerosols in presence of atmospheric oxidants. There is therefore a significant interest to monitor these molecules in the gas phase. High resolution spectroscopic studies of methylated furan compounds are generally limited to pure rotational spectroscopy in the vibrational ground state. This lack of results might be explained by the difficulties arisen from the internal rotation of the methyl group inducing non-trivial patterns in the rotational spectra. In this study, we discuss the benefits to assign the mm-wave rotational-torsional spectra of methylfuran with the global approach of the BELGI-Cs code compared to local approaches such as XIAM and ERHAM. The global approach reproduces the observed rotational lines of 2-methylfuran and 3-methylfuran in the mm-wave region at the experimental accuracy for the ground vt=0 and the first torsional vt=1 states with a unique set of molecular parameters. In addition, the V3 and V6 parameters describing the internal rotation potential barrier may be determined with a high degree of accuracy with the global approach. Finally, a discussion with other heterocyclic compounds enables the study of the influence of the electronic environment on the hindered rotation of the methyl group.     

ACTIVE CONTROL OF A FLEXIBLE CANTILEVER PLATE WITH MULTIPLE TIME DELAYS

Active control of a flexible cantilever plate with multiple time delays is investigated using the discrete optimal control method. A controller with multiple time delays is presented. In this controller, time delay effect is incorporated in the mathematical model of the dynamic system throughout the control design and no approximations and assumptions are made in the controller derivation, so the system stability is easily guaranteed. Furthermore, this controller is available for both small time delays and large time delays. The feasibility and efficiency of the proposed controller are verified through numerical simulations in the end of this paper.     

兔VX2移植肝癌及隔离灌注模型建立方法探究

应用开腹瘤块包埋法建立了兔移植肝癌模型,探讨了改良动脉插管技术及提高隔离灌注模型建立的成功率.采用的方法是将实验兔建立移植肝癌模型10d后,按动脉插管方法随机分为3组：A组为直视下儿科静脉留置针插管;B组为显微镜下儿科静脉留置针插管;C组为直视下硬膜外麻醉导管插管.建模成功后经肝动脉灌注奥沙利铂,隔离灌注模型建立前测量肿瘤生长大小,常规病理观察肿瘤,比较插管成功率.研究结果表明：肿瘤生长良好,应用儿科静脉留置针插管成功率明显高于硬膜外麻醉导管,显微镜下插管较直视下无统计学意义,奥沙利铂浓度外周静脉显著低于流出道.由此认为采用儿科静脉留置针插管操作简单,成功率高,建立隔离灌注模型外周血药物泄漏少,阻断较完全,是一种实用的隔离灌注建立方法.     

A comparison of quantitative nuclear magnetic resonance methods: internal,external, and electronic referencing

The performance of three quantitative NMR methods was compared in terms of short‐term and long‐term precision and accuracy, robustness, linear range, and general applicability. The Internal Reference method employs a reference material co‐dissolved with sample; the External Reference method employs a reference material contained in a separate solution; and the third method, known as Electronic REference To access In vivo Concentrations (ERETIC), employs an externally calibrated digital reference peak. The Internal Reference method results were the most precise and remained stable within 0.1% for at least 4 weeks. The results from the External Reference and ERETIC methods were practically equivalent to each other during this time. These methods exhibited small differences relative to the standard set by the Internal Reference method and slightly lower precision, establishing them as practical alternatives to the Internal Reference method. In contrast to the Internal Reference method, the External Reference and ERETIC methods possess several advantages that address peak overlap, flexibility of calibration, and duration of applicability. The study was designed such that each spectrum contained the information needed to compare the three methods while all other variables were kept constant. Applicability of pulse width compensation is addressed. ERETIC software compensation and minor adjustments to 90° pulse width were concluded to be unnecessary for this system. Although each of the methods was applied here to specifically calculate and compare chemical purity values, this evaluation applies generally to absolute quantitation by NMR. Copyright © 2013 John Wiley & Sons, Ltd.     

Frequency‐dependent NMR relaxation of liquids confined inside porous media containing an increased amount of magnetic impurities

Frequency‐dependent NMR relaxation studies have been carried out on water (polar) and cyclohexane (nonpolar) molecules confined inside porous ceramics containing variable amounts of iron oxide (III). The porous ceramics were prepared by compression of powders mixed with iron oxide followed by thermal treatment. The pore size distribution was estimated using a technique based on diffusion in internal fields that exposed a narrow distribution of macropore sizes with an average pore dimension independent of iron oxide content. The relaxation dispersion curves were obtained at room temperature using a fast field cycling NMR instrument. They display an increase of the relaxation rate proportional to the iron oxide concentration. This behavior is more prominent at low Larmor frequencies and is independent of the polar character of the confined molecules. The results reported here can be fitted well with a relaxation model considering exchange between molecules in the close vicinity of the paramagnetic centers located in the surface and bulk‐like molecules inside the pores. This model allows the extraction of the transverse diffusional correlation time that can be related to the polar character of the confined molecules. Copyright © 2013 John Wiley & Sons, Ltd.     

Improved excitation uniformity in multiple‐quantum NMR experiments of mixtures

Multiple‐quantum ¹H NMR spectroscopy has been finding a renewed interest for its possible applications in the analysis of mixtures of small molecules, due to its simplification properties. A crucial aspect of this application of multiple‐quantum NMR is the sensitivity of the spectrum intensity to the molecular structure and to the parameterization of the experiment, which could result in the missing of some components. We demonstrate that a general scheme to overcome this drawback consists in varying the experiment parameterizations over a small number of values, selected according the values of the couplings and the relaxation rates. Copyright © 2013 John Wiley & Sons, Ltd.     

Optical inspection by internal reflection and spatial filtering

Some optical techniques for surface inspection applications are described. Paper texture is analyzed by a frustrated-total-internal-reflection method followed by spatial filtering of the diffracted pattern. Fibre-optics and micro-lenses are used to obtain a rugged and flexible sensor. Similar sensors are used for defect monitoring of roughly-polished surfaces. The practical aspects of sensor manufacture, speckle and vignetting considerations are discussed.     

An extended continuous Newton method

This paper describes a numerical realization of an extended continuous Newton method defined by Diener. It traces a connected set of locally one-dimensional trajectories which contains all critical points of a smooth functionf: ⁿ . The results show that the method is effectively applicable.The authors would like to thank L. C. W. Dixon for pointing out some errors in the original version of this paper and for several suggestions of improvements.     

New general guidance method in constrained optimal control,part 2: Application to space shuttle guidance

The application and the performance of the neighboring optimal feedback scheme presented in Part 1 of this paper is demonstrated for the heating-constrained cross-range maximization problem of a space-shuttle-orbiter-type vehicle. This problem contains five state variables, two control variables, and a state variable inequality constraint of order zero.This research was supported in part by the Deutsche Forschungsgemeinschaft under the Schwerpunktprogramm Anwendungsbezogene Optimierung und Steuerung.The authors wish to express their sincere and grateful appreciation to Professor Roland Bulirsch who encouraged this work.