An Efficient and Green Synthesis of 5-Oxo-5, 6, 7, 8-tetrahydro- 4H-benzo-[b]-pyran Derivatives Promoted by InCl_3·4H_2O Under Microwave Irradiation

Construction of tetrahydropyran rings has attracted a great deal of interests in organic synthesis in recent years1, since tetrahydropyran moiety constitutes a structural unit in a number of natural products2. In addition, tetrahydropyran derivatives possess wide range of biological activities and pharmacological properties, such as anticancer activity3 and antihypersensitivity4. Many methods for the preparation of such compounds have already been developed5. Among them, condensation of α, β…     

微波合成铝掺杂钻酸锂材料及性能研究

以LiOH·H2O，Al2O3和Co3O4为原料，微波加热合成Li离子电池正极材料LiAlxCo（1-x）O2．通过XRD测试表征了不同Al加入量时合成产物的晶体结构，确定当x≤0．4时，产物为单一相层状结构．计算了不同x时LiAlxCo（1-x）O2的晶胞参数，随着x的增大，a值减小，c值增大．对合成LiAlxCo（1-x）O2样品进行DSC—TGA测试，结果表明，当x不同时，合成样品的热稳定性不同．SEM测试表明，合成晶体粒度较均匀，粒径在5μm左右．电化学测试表明，LiAl0.2Co0.8O2的电化学性能最好，首次循环放电容量为127mAh／g，多次循环容量损失率小于LiCoO2．     

四针状氧化锌晶须的制备及其吸波性能的研究

随着雷达探测、卫星通信、航天航空和电子对抗等高科技的发展，特别是近年来抗电磁波干扰、隐形技术、微波暗室等研究领域的兴起．对电磁波吸波材料的研究日益受到人们的重视。随着现代电子工业和信息产业的高速发展．产生电磁波的电子产品（诸如计算机、电视机、手机、微波炉及电磁炉等）的数量急剧增加，     

微波辐射下2-氨基-7-甲基-4-芳基-5-氧代-4H,5H-吡喃并[4,3-b]吡喃-3-腈的一步合成

芳醛、丙二腈与6-甲基-4-羟基-2-吡喃酮在微波辐射下, 一步反应得到一系列2-氨基-7-甲基-4-芳基-5-氧代-4H,5H-吡喃并[4,3-b]吡喃-3-腈, 该反应时间短、产率较高、环境友好、后处理简单. 产物的结构经红外光谱、核磁共振谱和元素分析表征, 产物4g的结构经单晶X射线衍射进一步确证; 并对反应过程提出了可能的机理.     

Microfabricated bioreactor chips for immobilised enzyme assays

A microfabricated device is reported that has been designed to permit the in situ packing of a section of channel with enzyme immobilised onto controlled pore glass (CPG). It is fabricated from glass and polydimethylsiloxane and to prevent dead volumes, has dedicated channels for packing the reactor. The device has the advantage of being simple in design, the flow through enzyme reactor channel being simply a widened section of the analyte channel. The system is suitable for both hydrodynamic and electro-osmotic pumping, and is designed such that when the packing is exhausted it can be repacked. Controlled pore glass provides a reproducible none swelling, high porosity medium onto which the enzyme could be immobilised. The large particle size meant that it was vital to optimise the immobilisation procedure in order to achieve acceptable enzyme activity. The microfabricated device was developed with two enzymes of different molecular masses; alkaline phosphatase and xanthine oxidase. The pore size of the CPG was found to be very important for xanthine oxidase, where the 697 Å pore size (120-200 mesh) CPG was found to give the highest activity (18-20% activity retained after immobilisation). The microfabricated device was used for the assay of p-nitrophenyl phosphate and hypoxanthine with spectrophotometric detection at 405 and 470 nm, respectively. The limits of detection were 5 and 8 μM, respectively.     

Inclusion-dependent mechanism of modification of cyclodextrins with heterocycles

Mono(6-deoxy-dimethylpyridinium)-β-cyclodextrins have been synthesized in reaction of mono (p-toluenesulfonyl) derivative of β cyclodextrin with the appropriate lutidine under microwave irradiation and conventional conditions. The results indicate that the mechanism consists of inclusion complex formation.     

Emulsion polymerization of methyl methacrylate under pulsed microwave irradiation

Emulsion polymerization of methyl methacrylate (MMA) under pulsed microwave irradiation (PMI) with higher peak pulse power was studied. The effects of various parameters of PMI on the polymerization were analyzed and compared with that under conventional heating (CH) process. The results were summarized, as compared with that under CH, as follows. The amount of initiator used to reach constant conversion reduced by 50% at the same polymerization time; at the same initiator concentration 0.15 and 0.2 wt.%, the polymerization rate increased by 131% and 163%, respectively. The molecular weight of polymer obtained was 1.1-2.0 times larger than that under CH; at the same irradiation energy, the conversion achieved using a lower pulse power was greater than that using a higher pulse power. There seemed to be a factor of the irradiation energy efficiency; in other words, for the monomer conversion, the irradiation energy of low pulse power had a higher efficiency. The conversion achieved using a 3.5 μs pulse width was almost the same as that using a 1.5 μs pulse width. The results indicated that PMI had a significant non-thermal effect on the emulsion polymerization of MMA so as to effectively enhance the polymerization rate. The glass transition temperature (T_g), the polydispersity index (PDI) and the regularity of the polymer obtained using two processes were similar, indicating that the physical properties and microstructure of the polymer were not modified by the use of microwaves.     

Reactions of substituted furo[3,2-<Emphasis Type="Italic">b</Emphasis>]pyrrole-5-carboxhydrazides and their biological activity

The reactions of substituted furo[3,2-b]pyrrole-5-carboxhydrazides 1 with 5-arylfuran-2-carboxaldehydes 2, 4,5-disubstituted furan-2-carboxaldehydes 3 and thiophene-2-carboxaldehyde 4 has been studied. The advantage of microwave irradiation on some of these reactions was reflected in the reduced reaction time and increased yields. Reactions of 1 with 4-substituted 1,3-oxazol-5(4H)-ones 11 led to diacylhydrazines 13 or to imidazole derivatives 14 depending on the temperature. 1,2,4-Triazole-3-thione 17 was synthesized by two-step reaction of 1 with phenylisothiocyanate and subsequent base-catalyzed cyclization of thiosemicarbazide 16. The effects of hydrazones 5–10 on inhibition of photosynthetic electron transport in spinach chloroplasts and chlorophyll content in the antialgal suspensions of Chlorella vulgaris were investigated.     

本征导电聚合物的智能性

在化学掺杂或电化学掺杂过程中，性质发生可逆性变化的本征导电聚合物是一种潜在的智能材料，可望实现或部分实现传感、处理和执竽功能，适于制成电机执行器、智能窗、化学分离与释放体系、传感器和非线性光学器件等。     

微波作用下2,5-二取代-1,3,4-噁二唑的合成

2 ,5 二取代 1 ,3 ,4 二唑可用作药品 ,光敏物质 ,闪烁体 ,激光材料 ,高分子液晶单体等[1- 5] 。一种是以芳香酸与水合肼作为原料用多聚磷酸作为脱水环合剂来合成此类化合物[6 ] ,另一种是由芳香酸转变为芳香酰氯或酯 ,再与水合肼反应得到单酰肼或二酰肼 ,最后用三氯氧磷[7] ,五氧化二磷和五氯化磷[8] ,一氯三甲硅[9] 脱水环合 ;此外 ,用水合肼和尿素合成得到的氨基脲代替水合肼 ,与芳香酸缩合合成二唑[10 ] ,这些方法共同的缺陷是 :环合时间较长 ,少者 4～ 5ｈ ,多则 8ｈ。近年来 ,微波技术在有机合成及其杂环化合物的合成中得到了广…