Pyrolysis chemical ionization mass spectrometry of cellulose ethers

Pyrolysis ammonia chemical ionization (PyCI) mass spectrometry was performed on hy-droxyethyl-, hydroxypropyl-,methyl-, hydroxypropylmethyl-, and ethylhydroxyethyl cel-luloses. The mass peaks in the PyCI mass spectra of these cellulose ethers could be assigned to the ions of pyrolytic dissociation products which form via the [2 + 2 + 2] cycloreversion and the E_i elimination pyrolysis pathway. Structural information about the residual amount of nonderivatized cellulose, the relative chain length distributions of the substituents in hydroxyalkyl celluloses, and the end-capping of hydroxyalkyl substituents by alkyl groups in the mixed cellulose ethers is obtained. Interference of secondary pyrolysis products in the PyCI mass spectra is found to be of minor importance, especially in the lower mass regions. © 1995 John Wiley & Sons, Inc.     

Multinuclear magnetic resonance study of some mesoionic oxatriazoles containing nitrogenous exocyclic groups

¹H,¹³C,¹⁴N and¹⁵N NMR measurements are reported for four mesoionic 1-oxa-2, 3, 4-triazoles containing exocyclic nitrogenous groups. The NMR signal assignments are discussed and compared with those previously published for some corresponding oxatriazoles. The results obtained support the proposed cyclic mesoionic structures for the compounds studied. The questions of possible charge delocalization and valence tautomerism are addressed. Compound with N^– H as a exocyclic group (Fig. 1) is found to be relatively unstable, this is attributed to proton migration in the corresponding non-cyclic form of this molecule.Published in Khimiya Geterotsikiicheskikh Soedinenii, No. 9, pp. 1260–1263, September, 1995.     

胶体颗粒大小的分布——Ⅱ.物理显影中胶体催化剂颗粒大小的分布函数

本文用对数正态分布对物理显影中常用的Au、Ag及Ag_2s胶体催化剂的颗粒大小的实验分布进行了拟合。理论分布与实验分布的比较表明:本实验条件下制备的十二组胶体溶液其颗粒大小都服从了对数正态分布,并且不依赖于胶体的组成、大小及制备方法。因此,它们很可能遵从了同样的成核成长规律。     

Characteristics of Ti0.97Co0.03O2:Sb0.01 dilute magnetic semiconducting thin films deposited at 500 °C by pulsed laser deposition

Epitaxial Ti_0.97Co_0.03O₂:Sb_0.01(TCO:Sb) films were deposited on R-Al₂O₃ (1 1 0 2) substrates at 500 °C in various deposition pressures by pulsed laser deposition. The solubility of cobalt within the films increases with decreasing deposition pressure at a deposition temperature of 500 °C. The TCO:Sb films deposited at 5×10⁻⁶ Torr exhibit a p-type anomalous Hall effect having a hole concentration of 6.1×10²²/cm³ at 300 K. On the other hand, films deposited at 4×10⁻⁴ Torr exhibits an n-type anomalous Hall effect having an electron concentration of about 1.1×10²¹/cm³. p- or n-type DMS characteristics depends on the change of the structure of TCO:Sb films and the solubility of Co is possible by controlling the deposition pressure.     

Synthesis and polymerization of a new nitrogen‐containing bis‐ortho‐diynylarene monomer

This study focuses on the preparation, characterization, and optical properties of new bis(3,4‐diphenylethynylphenyl)phenylamine. This is the first nitrogen‐containing bis‐ortho‐diynylarene (BODA) monomer having a nitrogen atom as the spacer group. BODA monomers are usually prepared from common bisphenols, thereby providing great synthetic versatility and the opportunity to develop a wide array of novel polyarylene thermosets by varying the aromatic spacer group. The new bis(3,4‐bisphenylethynylphenyl)phenylamine was synthesized in five steps. This compound emits an intense blue color (λ = 438 nm) upon irradiation by UV light and may be suitable for use as an emitting layer in electroluminescent devices. Bis‐(3,4‐bisphenylethynylphenyl)phenylamine and its polymer have photoluminescence quantum yields 34 and 38%, respectively, and long excited‐state lifetimes of 3.2 and 3.6 ns, respectively. The structure of the monomer and its polymer were characterized using spectroscopic techniques including Ultraviolet–visible Spectrophotometer, Photoluminescence Spectrophotometer, Fourier Transform infrared spectroscopy, and Gel Permeation Chromatography. The polymerizations were studied by Differential Scanning Calorimeter. The amount of weight loss and the thermostability of the nitrogen‐containing polymer were determined from thermogravimetric analysis. The electrical conductivity of neat HCl‐doped BODA‐derived polymer film was measured according to the standard four‐point probe technique. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6988–6996, 2006     

Growth of oxide thin films for optical gas sensor applications

Tungsten trioxide and titanium dioxide thin films were synthesised by pulsed laser deposition. We used for irradiations of oxide targets an UV KrF* (λ = 248 nm, τ_FWHM ≅ 20 ns, ν = 2 Hz) excimer laser source, at 2 J/cm² incident fluence value. The experiments were performed in low oxygen pressure. The (0 0 1) SiO₂ substrates were heated during the thin film deposition process at temperature values within the 300-500 °C range. The structure and crystalline status of the obtained oxide thin films were investigated by high resolution transmission electron microscopy. Our analyses show that the films are composed by nanoparticles with average diameters from a few to a few tens of nm. Moreover, the films deposited at substrate temperatures higher than 300 °C are crystalline. The tungsten trioxide films consist of a mixture of triclinic and monoclinic phases, while the titanium dioxide films structure corresponds to the tetragonal anatase phase. The oxide films average transmittance in the visible-infrared spectral range is higher than 80%, which makes them suitable for sensor applications.     

Structural, morphological, wettability and thermal resistance properties of hydro-oleophobic thin films prepared by a wet chemical process

The structural properties of fluorine containing polymer compounds make them highly attractive materials for hydro-oleophobic applications. However, most of these exhibit low surface energy and poor adhesion on the substrates. In the present investigation, crack free, smooth and uniform thin films of poly[4,5-difluoro-2,2-bis(trifluoromethyl)-1,3-dioxole]-co-tetrafluoroethylene (TFD-co-TFE) with good adhesion have been deposited by wet chemical spin-coating technique on polished AISI 440C steel substrates. The as-deposited films (xerogel films) have been subjected to annealing for 1 h at different temperatures ranging from 100 to 500 °C in an argon atmosphere. The size growth of the nano-hemispheres increased from 8 nm for xerogel film to 28 nm for film annealed at 400 °C. It was found that as the annealing temperature increased from 100 to 400 °C, nano-hemisphere-like structures were formed, which in turn have shown increase in the water contact angle from 122° to 147° and oil (peanut) contact angle from 85° to 96°. No change in the water contact angle (122°) has been observed when the films deposited at room temperature were heated in air from 30 to 80 °C as well as exposed to steam for 8 days for 8 h/day indicating thermal stability of the film.     

Matrix assisted pulsed laser evaporation processing of triacetate-pullulan polysaccharide thin films for drug delivery systems

We report the first successful deposition of triacetate-pullulan polysaccharide thin films by matrix assisted pulsed laser evaporation. We used a KrF* excimer laser source (λ = 248 nm, τ ≈ 20 ns) operated at a repetition rate of 10 Hz. We demonstrated by FTIR that our thin films are composed of triacetate-pullulan maintaining its chemical structure and functionality. The dependence on incident laser fluence of the induced surface morphology is analysed.     

固体样品进样技术中汞量定标方法的研究

在原子吸收光谱分析中,固体样品直接进样是目前的研究课题之一。本文主要报道作者在分析汞中所进行的固体直接进样技术工作和讨论。在我们研制成功的KT—81型塞曼效应测汞仪中,针对元素汞蒸气压高的特点,用饱和汞蒸气作为汞量标准,实现了固体样品,如土壤、污泥、毛发、煤、食品等汞含量的直接进样测定。汞蒸气一次制备后可长期使用。分析汞时,只要用标准气体任意校验一次就可测量。1～2分钟能分析一个样品,S<0.3ng。r<5%。此法用NBS标准物质验证过。     

The elimination of fast variables in complex chemical reactions. III. Mesoscopic level (irreducible case)

The master equation for a complex chemical reaction cannot always be reduced to a simpler master equation, even if there are fast and slow individual reaction steps. Nevertheless the elimination of intermediates can be carried out with the help of the-expansion. This is illustrated with a well-known complex reaction: the dissociation of N₂O₅. It is shown that the intrinsic fluctuations in the N₂O₅ decay are larger than those implied by the master equation suggested by the macroscopic rate law.