陶瓷基钛掺杂硅胶块体吸附剂研究

以陶瓷纤维纸为基材, 顺次经水玻璃、酸性硫酸氧钛溶液浸渍共沉淀制得新型蜂窝状陶瓷基钛掺杂硅胶块体吸附剂. FTIR谱在波数954 cm^－1附近的特征吸收峰表明钛掺杂硅胶中存在Si-O-Ti键; XRD谱显示掺杂材料为无定型非晶相材料; SEM显示钛掺杂硅胶粒子较好地分散在陶瓷纤维表面及其空隙中; 用EDS及XPS揭示了材料的组成和钛原子含量, 根据钛掺杂前后XPS中Si2p, O1s, Ti2p 3/2电子结合能变化以及²⁹Si MAS NMR中硅原子化学位移差异, 进一步表明钛原子替代硅原子进入了四面体骨架; BET分析显示掺杂材料以中孔为主. 与硅胶相比, 由于钛掺杂, 其比表面积、孔容增大, 吸附性能、耐热性能增强.     

石英的顺磁中心在电子自旋共振测年中的特性及应用

沉积物的电子自旋共振测年是利用石英矿物中的顺磁中心浓度确定总辐射能量,进而推定石英矿物的埋藏年代。石英中可用于测年的顺磁中心包括E′心、Al心、Ti心和Ge心。E′心需要经过热活化后才能测年。Al心是一种电子空穴心,在低温下可观测到较强的信号值。光照可以使Al心漂白,但有残留值存在。Ti心、Ge心都是电子中心,Ti心在低温测试中可见,信号微弱。Ge心光晒退最敏感,在常温观测中可见。不同顺磁中心的形成机理不同,导致它们具有不同的特性,适用于不同沉积环境中的样品测年,在冰碛物中Ge心测年更具有可行性。电子自旋共振测试时降低温度可使信号增强,Ti心在10 K和15 K时信号强度最大;Al心在20 K时信号最强;Ge心在200 K时信号明显增强。在电子自旋共振测年中可根据不同顺磁中心信号强度的变化调整测试温度获得信号的最优值。在以后的电子自旋共振(ESR)测试中可以选取信号最强时的测试温度进行测试,以增强微弱信号的信噪比,有利于对复杂的信号形态的分辨确定,提高对信号强度定量的准确性。     

LiCoO2/LiNiO2/LiMn2O4材料安全性能的研究

随着锂离子电池的大型化,对电池安全性能的研究显得更为重要。锂离子电池的安全性有不同的测试方法,如进行过充试验和短路试验。在这些安全性试验中,以及在滥用中出现的安全性的问题,大多是由于电池内部温度升高,进而触发了大量放热的副反应[1],引起电池发生爆炸。本文通过对AA     

辣素微胶囊的原位聚合法制备与热降解动力学

在乳液体系中,以尿醛为壁材,以原位聚合法制备了辣素同系物———N-香草基壬酰胺微胶囊。红外光谱证实了尿醛的形成,X-射线衍射显示了同样作为半晶高分子囊壁,尿醛包裹囊心前后出现的结构晶型差异。根据吸附等温曲线假设微胶囊为紧密堆积形式,对于尿醛单体颗粒和尿醛微胶囊的TGA,采用Achar-B rind ley-Sharp-W endworth方法,对两者进行热重数据的处理,以作图法求得了动力学参数,确定了热降解动力学模式函数,回归系数良好。TGA求解的活化能数据证明由于晶型差异,导致单体与微胶囊热稳定性不同,从而与XRD结论一致。     

尿素作为添加剂低温制备高活性的TiO2光催化剂

以钛酸丁酯为原料,尿素作为添加剂,在酸性水溶液中室温制备了稳定透明的TiO2水溶胶。经过300℃低温焙烧2 h,得到了由锐钛矿和金红石组成的TiO2混晶。用XRD、FT-IR对催化剂进行了表征。以甲基橙为降解对象研究了TiO2的光催化活性,实验结果显示所制备的TiO2具有比Degussa P25更高的催化活性,15m in后的降解率达到了78%(P25,58%)。考察了尿素添加量以及焙烧温度对TiO2催化性能的影响,当尿素与钛酸丁酯物质的量之比为3∶1,300℃下焙烧2 h为较适宜的催化剂制备条件。初步探讨了尿素作为添加剂在低温制备高活性TiO2过程中的作用。     

Alkaline Stable Anion Exchange Membranes Based on Cross-Linked Poly(arylene ether sulfone) Bearing Dual Quaternary Piperidines for Enhanced Anion Conductivity at Low Water Uptake

Alkaline stable anion exchange membranes based on the cross-linked poly(arylene ether sulfone) grafted with dual quaternary piperidine (XPAES-DP) units were synthesized. The chemical structure of the synthesized PAES-DP was validated using ¹H-NMR and FT-IR spectroscopy. The physicochemical, thermal, and mechanical properties of XPAES-DP membranes were compared with those of two linear PAES based membranes grafted with single piperidine (PAES-P) unit and conventional trimethyl amine (PAES-TM). XPAES-DP membrane showed the ionic conductivity of 0.021 S cm⁻¹ at 40 °C which was much higher than that of PAES-P and PAES-TM because of the possession of more quaternary ammonium groups in the cross-linked structure. This cross-linked structure of the XPAES-DP membrane resulted in a higher tensile strength of 18.11 MPa than that of PAES-P, 17.09 MPa. In addition, as the XPAES-DP membrane shows consistency in the ionic conductivity even after 96 h in 3 M KOH solution with a minor change, its chemical stability was assured for the application of anion exchange membrane fuel cell. The single-cell assembled with XPAES-DP membrane displayed a power density of 109 mWcm⁻² at 80 °C under 100% relative humidity.     

Unusual Surface Latent Heat Flux Variations and Their Critical Dynamics Revealed before Strong Earthquakes

We focus on the possible thermal channel of the well-known Lithosphere–Atmosphere–Ionosphere Coupling (LAIC) mechanism to identify the behavior of thermal anomalies during and prior to strong seismic events. For this, we investigate the variation of Surface Latent Heat Flux (SLHF) as resulting from satellite observables. We demonstrate a spatio-temporal variation in the SLHF before and after a set of strong seismic events occurred in Kathmandu, Nepal, and Kumamoto, Japan, having magnitudes of 7.8, 7.3, and 7.0, respectively. Before the studied earthquake cases, significant enhancements in the SLHF were identified near the epicenters. Additionally, in order to check whether critical dynamics, as the signature of a complex phenomenon such as earthquake preparation, are reflected in the SLHF data, we performed a criticality analysis using the natural time analysis method. The approach to criticality was detected within one week before each mainshock.     

Synthesis, Crystal Structure and Thermoanalysis of Complex of Zn(Ⅱ) with Aminomethanesulfonic Acid-5-bromosalicylaldelyde Schiff Base

The title complex [Zn(L)(phen)(CH3OH)] (L= C8H6BrO4NS, aminomethanesulfonic acid 5-bromo-salicylaldelyde schiff base; phen = 1,10-phenanthroline) has been synthesized and characterized by X-ray diffraction method. The crystal belongs to monoclinic, space group P21/c with a = 1.8712(3), b = 1.38008(19), c = 0.83685(12) nm, β = 97.791 (2)°, Mr = 569.72, V = 2.1411(5)nm3,Z= 4, Dc = 1.767 g/cm3, μ = 3.151 mm-1, F(000) = 1144, the final R = 0.0402 and wR = 0.0885. The central Zn(Ⅱ) is six-coordinated by one nitrogen and two oxygen atoms from the Schiff base, two nitrogen atoms from 1,10-phenanthroline and one oxygen from methanol to form a distorted octahedral coordination geometry.     

Isobaric thermal expansivities of polyethylenes with various crystallinities over the pressure range from 0.1 to 300 MPa and over the temperature range from 303 to 393 K

A pressure-controlled scanning calorimeter (PCSC) has been applied for measuring the isobaric volume thermal expansivities (α_p) of crystalline polymers as a function of pressure up to 300 MPa at various temperatures. The measurements have been performed for several well-defined polyethylenes with various degrees of crystallinity at 302.6, 333.0, 362.6, and 393.0 K. The results are reported as values of coefficients in a correlation equation, which facilitates the use of reported data over large ranges of temperature and pressure. The general pressure-temperature behavior of α_p for all polyethylenes under study is such that α_p increases with temperature and decreases with pressure. The increase with temperature is smaller at high pressures and the isotherms of α_p have a tendency to converge at high pressures; α_p decreases linearly with the crystallinity of the polyethylene over the whole range of pressure and temperature under investigation. From the linear approximation of experimental data for polyethylenes with various crystallinities the estimated α_p for both crystal and amorphous phases of polyethylenes have been determined as a function of pressure up to 300 MPa at 302.6, 333.0, and 362.5 K. The obtained results have been compared with available literature crystallographic data and with the values derived from the Pastine theoretical equation of state for both crystalline and amorphous phases. © 1996 John Wiley & Sons, Inc.     

Radical copolymerization of N-alkylmaleimides with isobutene and the properties of the resulting alternating copolymers

Radical copolymerization of N-methylmaleimide (MeMI) as well as other N-alkylmaleimides (RMI) and isobutene (IB) was carried out with 2,2′-azobis(isobutyronitrile) as an initiator at 60°C. The initial rate of the copolymerization (R_p) was dependent on the monomer composition and was maximum at the 40 mol % of MeMI in the feed. A solvent effect on the R_p and the monomer reactivity ratio was observed in this copolymerization system, i.e., copolymerization in chloroform produced a higher R_p and an alternating tendency compared with those in dioxane (r_MeMI = 0.14, r_1B = 0 in chloroform and r_MeMI = 0.47, r_1B = 0 in dioxane). The alternating copolymer of RMI and IB shows a high glass transition temperature (T_g) and excellent thermal stability, e.g., the T_g and the thermal decomposition temperature (T_d) were 152 and 363°C, respectively, for the alternating copolymer of MeMI and IB. Both the T_g and T_d increased as the concentration of the MeMI unit in the copolymers increased. Colorless transparent sheets were obtained from press molding the alternating copolymers. They showed excellent mechanical and optical properties. © 1996 John Wiley & Sons, Inc.