Influence of the heating conditions on the thermal and chemical behaviour of solid particles undergoing a fast endothermic decomposition

This paper deals with models describing the thermal and chemical behaviour of solid particles undergoing fast endothermic reactions under the influence of an external heat flux. The heat source temperature is supposed to be constant, to increase with time, or to deliver a simple thermal flash. It is shown that the pyrolysis conditions (reaction temperature, conversion, etc.) depend on the chemical characteristics of the reaction and also to a large extent on the external heating conditions. Relationships are proposed to take into account these parameters. The results are applied to the thermal decomposition of NaHCO₃. The pyrolysis of cellulose is finally chosen in order to show how these operating parameters can also affect the selectivity of a more complex reaction.     

IDENTIFICATION OF LANOSTANES AND THEIR POSSIBLY GEOCHEMICAL SIGNIFICANCE IN BIYANG DEPRESSION

In the study, a series of C_(30)-C_(32) lanostane homologs have been identified from Eogene source rocks and crude oils of Biyang depression in Henan Province, China. Based upon the geochemical investigations and simulating experiments, the idea that the generation of lanostane may mainly be related to the specific original organic inputs and low maturity has been proposed.     

热导式热量计特征热谱方程的建立

Based on the interfacial model of a conduction calorimeter, a characteristic thermogram equation is suggested in this paper. Measurements of only two quantities such as the maximum peak height △m and its time tm, enables us to calculate the peak height at any interval by using this model. Thermograms of alkaline hydrolysis of ethyl propionate and ethyl acetate have been measured at 25℃, respectively. The themographic data calculated by using the characteristic thermogram equation are in reasonable agreement with those read from the thermograms.     

过渡金属对分子筛担载Pd催化剂上CO氧化性能影响

分别采用共浸和连续浸渍法制备了一系列添加过渡金属的Pd-M-Ox-NaZSM-5(M=Cr，Mn，Fe，Co，Ni，Cu，Zn，Mo，Zr等)负载型催化剂．以CO氧化为探针反应，考察了不同制备方法对CO氧化性能影响，结果表明共浸法制备的各催化剂其活性明显优于连续浸渍法．详细考察了反应温度、Fe含量、氢气预还原、空速以及水蒸气等对共浸Pd-Fe-Ox-NaZSM-5催化剂上CO氧化行为影响，并应用XRD和XPS等手段对催化剂体相结构和表面状态进行了表征．结果表明：加入Fe2O3可明显提高Pd/NaZSM-5催化剂活性，且催化CO氧化的转化率随反应温度及Fe含量增加而增加；空速增加以及H2预还原作用导致Pd-Fe-Ox-NaZSM-5活性有所降低；催化剂对水蒸气较为敏感．XRD测试结果表明催化剂中Pd组分处于较高分散状态，以红铁矿形式存在的Fe2O3的引入，促进了Pd物种在NaZSM-5载体上的分散．表面XPS分析证实Fe2O3与Pd物种间存在较强的相互协同作用，且催化剂表面Pd物种处于较高氧化状态．Pd的高分散及其与Fe2O3的相互协同作用是共浸催化剂具有高活性的关键因素．     

Chemical equilibrium model for the thermodynamic properties of mixed aqueous micellar systems: Application to thermodynamic functions of transfer

Mixed micelles can be formed in water between various pairs of hydrophobic solutes such as surfactants, alcohols and hydrocarbons. These systems can often be studied through the thermodynamic functions of transfer of one of the solutes, usually kept near infinite dilution, from water to an aqueous solution of the other solute. When mixed micelles are formed, these functions change significantly, and often go through extrema, in the region where the binary system micellizes or undergoes some microphase transition.Three main effects are responsible for the observed trends: pair-wise interactions between both solutes in the monomeric form, a distribution of the reference solute between the aqueous and micellar phases and a shift in the monomer-micelle equilibrium in the vicinity of the reference solute. Simple equations can be derived for these three effects which can account for the sign and magnitude of the observed trends using parameters which are derived for the most part from the two binary systems.     

SHAPE MEMORY EFFECT OF PU IONOMERS WITH IONIC GROUPS ON HARD-SEGMENTS

SMPU （shape memory polyurethane） non-ionomers and ionomers, synthesized with poly（c-caprolactone） （PCL）, 4, 4＇-diphenylmethane diisocyanate （MDI）, 1,4-butanediol （BDO）, dimethylolpropionic acid （DMPA） were measured with cyclic tensile test and strain recovery test. The relations between the structure and shape memory effect of these two series were studied with respect to the ionic group content and the effect of neutralization. The resulting data indicate that, with the introduction of asymmetrical extender, the stress at 100% elongation is decreased for PU non-ionomer and ionomer series, especially lowered sharply for non-ionomer series; the fixation ratio of ionomer series is not affected obviously by the ionic group content; the total recovery ratio of ionomer series is decreased greatly. After sufficient relaxation time for samples stretched beforehand, the switching temperature is raised slightly, whereas the recovery ratio measured with strain recovery test method is lowered with increased DMPA content. The characterization with FT-IR, DSC, DMA elucidated that, the ordered hard domain of the two series is disrupted with the introduction of DMPA which causes more hard segments to dissolve in soft phase; ionic groups on hard segment enhance the cohesion between hard segments especially at high ionic group content and significantly facilitate the phase separation compared with the corresponding non-ionomer at moderate ionic group content.     

Molar excess heat capacities and volumes for mixtures of alkanoates with cyclohexane at 25°C

Molar excess volumes V ^E at 25°C have been determined by vibrating-tube densimetry, as a function of mole fraction x for different series of an alkanoate (H _2m+1 C _m COOC _n H _2n+1 )+cyclohexane. Three types of alkanoates were investigated, i.e., methanoates (m=0, with n=3 and 4), ethanoates (m=1, with n=2, 3, and 4) and propanoates (m=2, with n=1, 2, and 3). In addition, a Picker flow calorimeter was used to obtain molar excess heat capacities C _p ^E at constant pressure at the same temperature. V ^E is positive for all systems and rather symmetric, with V ^E (x=0.5) amounting to almost identical values in a series of mixtures containing an alkanoate isomer of same formula (say C₄H₈O₂, C₅H₁₀O₂, or C₆H₁₂O₂). The composition dependence of C _p ^E is rather unusual in that two more or less marked minima are observed for most of the mixtures, especially when the alkanoate is a methanoate or an ethanoate. These results are discussed in terms of possible changes in conformation of both the ester and cyclohexane.     

低钴AB5型稀土系贮氢电极合金的研究

为了进一步降低AB5型混合稀土系贮氢合金的成本,采用Cr,Si,Cu替代Co和调节化学计量比的方法制备低钴AB5型贮氢合金。结果表明:3种取代元素在寿命方面的效果依次为Si>Cr>Cu,在放电容量和活化性能方面依次是Cu>Cr>Si。Cr,Cu,Si只有少量的替代才可能发挥其有利影响;通过非化学计量比的调节,低钴混合稀土系贮氢电极合金的放电容量、活化性能及倍率放电能力都能较好地达到实用要求,但是循环寿命有待提高。     

低温燐光的研究及应用

本文综述了44篇文献,介绍低温燐光的发展概况及其应用。     

Characterization of the Converging Jet Region in a Triple Torch Plasma Reactor

Enthalpy probe measurements were taken of the converging plasma plume in a triple torch plasma reactor and related to substrate heat flux measurements. Results show excellent entrainment of process gases injected into the converging plasma plume by way of the central injection probe. At lower pressures (40 kPa), the plasma volume is equivalent to at least a 3 cm diameter, 4 cm long cylinder, with relatively uniform temperature, velocity, and substrate heat flux profiles when compared to a typical dc arc jet. Converging plasma plume size, substrate heat flux, and enthalpy profiles are also shown to be a strong function of applied system power. Substrate heat flux measurements show smaller radial gradients than enthalpy probe measurements, because of the high radial velocity component of gases above the substrate boundary layer. Enthalpy probe measurements were also conducted for diamond deposition conditions and approximate temperature and velocity profiles obtained. Problems with the uniform gas mixture assumption prohibited more accurate measurements. Reproducibility of enthalpy measurement results was shown with an average standard deviation of 11.8% for the velocity and 7.6% for the temperature measurements.