用能量法求多自由度振动系统的角频率

利用简谐振动能量方程，通过分析振幅矢量的关系，用能量法求多自由度振动系统的角频率或简正振动频率。     

Modification of the surface state of rough substrates by two different varnishes and influence on the reflected light

Modification of the visual appearance when a rough surface is covered by a varnish is mostly attributed to the levelling of the substrate surface, which depends on the molecular weight of the varnish. The topography of varnished surfaces, however, has never been measured directly. Surfaces of varnishes applied over glass substrates of varying roughness were studied, therefore, using mechanical profilometry. Two different varnishes made with a low and a high molecular weight resin were studied. Both varnishes lower the r.m.s. roughness of the substrates and filter the high spatial frequencies. These results are amplified for the varnish containing the low molecular weight resin. The light reflected by the varnished samples is modelled from these topographical data. Its angular distribution, calculated from the probability density of slopes is presented, taking into account separately the air/varnish and the varnish/substrate interfaces. These analyses are presented in a back-scattering configuration. They show that varnishing significantly reduces the angular width of the reflected light and that this effect is magnified for the low molecular weight resin. Modelling furthermore shows that the influence of the roughness of the varnish/substrate interface is negligible in the total reflected light.     

All-optical frequency multiplication/recovery based on a semiconductor optical amplifier ring cavity

A novel scheme for all-optical frequency multiplication/recovery based on a semiconductor optical amplifier ring cavity is proposed and investigated numerically. The results show, for a 2.5 GHz driving pulse train, it can be generated 5-25 GHz repetition rate pulse trains with low clock amplitude jitter, polarization independence and high peak power. Furthermore, the extraction of the clock signal from a pseudorandom bit sequence signal can be realized based on the proposed scheme.     

Case-study evaluations of the acoustical designs of renovated university classrooms

The acoustical characteristics of 14 university classrooms at the University of British Columbia were measured before and after renovation—seven of these are discussed in detail here. From these measurements, and theoretical considerations, values of quantities used to assess each classroom configuration were predicted, and used to evaluate renovation quality. Information on each renovation was determined with the help of the university campus-planning office and/or the project acoustical consultant. These were related to the evaluation results in order to determine the relationship between design and acoustical quality. The criteria focused on the quality of verbal communication in the classrooms. Room-average Speech Intelligibility (SI) and its physical correlate, Speech Transmission Index (STI), were used to quantify verbal-communication quality. A simplified STI-calculation procedure was applied. The results indicate that some renovations were beneficial, others were not. Verbal-communication quality varied from ‘poor’ to ‘good’. The effect of a renovation depends on a complex interplay between changes in the reverberation and changes in the signal-to-noise level difference, as affected by sound absorption and the source outputs. Renovations which reduce noise are beneficial unless signal-to-noise level differences remain optimal. Renovations often put too much emphasis on adding sound absorption to control reverberation, at the expense of lower speech levels, particularly at the backs of classrooms. The absorption and noise contributed by room occupants has apparently often been neglected.     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

Estimation of integrated volatility in stochastic volatility models

In the framework of stochastic volatility models we examine estimators for the integrated volatility based on the pth power variation (i.e. the sum of pth absolute powers of the log‐returns). We derive consistency and distributional results for the estimators given high‐frequency data, especially taking into account what kind of process we may add to our model without affecting the estimate of the integrated volatility. This may on the one hand be interpreted as a possible flexibility in modelling, for example adding jumps or even leaving the framework of semimartingales by adding a fractional Brownian motion, or on the other hand as robustness against model misspecification. We will discuss possible choices of p under different model assumptions and irregularly spaced data. Copyright © 2005 John Wiley & Sons, Ltd.     

高频聚焦换能器声场的激光测量法

本文描述了一种使用激光测振技术测量高频聚焦换能器声场布的方法，并给出了使用该方法对一种高频聚换能器进行测量的结果，通过理论计算对结果的正确性进行了验证。     

数字全息图变频采样研究

根据Whittaker-Shannon抽样定理,对菲涅耳全息图进行变频率采样,保证整个全息图各部分采样频率为该处相应空间频率的两倍,从而完全消除数字全息图由于采样冗余而带来全息图的信息冗余.并且,对变频采样后的全息图进行线性插值恢复即可获得良好的再现像质.实验和理论均证明了该方法的有效性和可行性,为全息图的信息存贮与传输提出一条新的思路.     

风力发电机组变速恒频控制系统研究

全面介绍了一种最新应用于风力发电中的新型电机—无刷双馈电机，并分析了这种新型电机作变速恒频运行的原理并对这种电机进行了动态特性仿真研究，给出了形式简洁的控制方程和易于实现的控制方案。     

BEPCII直线加速器相控系统设计研究

为了补偿由于各种因素引起的微波相位漂移,BEPCII直线加速器需要建立微波相位反馈控制系统.能量最大法将用来确定每台功率源的最佳相位.沿直线加速器速调管长廊铺设相位稳定同轴线提供相位参考.现在已经完成了关键部件,如PAD单元、IfA 单元的开发.搭建了相控最小系统对系统进行了验证.